Navigation Hemi V8 Leather Heated Seats Sunroof Warranty Ipod Mp3 ( Hc1177p ) on 2040-cars

Auto blog

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

2015 Dodge Challenger SRT Hellcat [w/videos]

Darrell Waltrip once said, "If the lion didn't bite the tamer every once in a while, it wouldn't be exciting." The sentiment behind that aphorism is causing my adrenal gland to wake up as Dodge and SRT drivers and engineers - somber-faced to a man - give me the track talk that will precede my driving the 2015 Dodge Challenger SRT on the circuit at Portland International Raceway. PIR might not be Daytona, and the 707-horsepower Challenger Hellcat might seem tame to a legend like ol' Jaws, but there's a not-small part of me that's thinking about how hard Dodge's fire-breathing kitty might bite.
Just a few hours previous, I'd gotten behind the wheel of the Hellcat for the first time, letting its hyperbole-spitting, supercharged V8 Hemi pull me yieldingly through Portland's morning commuter traffic. Lulled into a cocky certainty by the Challenger's good manners at low speed, I drove the throttle just a hair too deep, too fast when I ran on to the highway ramp. For just an instant the rear tires were utterly drenched in torque, and the back end of the big Dodge loosened up like a drift car on a wet track. Throttle steer lives at the fleeting whim of your right foot in this car.
It was no big thing to lay off the gas and pull the Hellcat back in line as I entered the highway, but the incident did get me to thinking: What will this car do to me on a road course?

2019 Dodge Durango raids the SRT parts bin for updates

Fiat Chrysler will squeeze some extra excitement from the upcoming 2019 Dodge Durango, by providing some modest updates. They include giving the three-row SUV new colors and broadening the use of elements of the Durango R/T and SRT performance models, among other upgrades when it goes on sale in the fall. It'll still be offered in five models — SXT, GT, Citadel, R/T and the SRT — with the same 295-horsepower 3.6-liter V6 as the standard engine. For 2019, the GT model will get the SRT and R/T's performance front fascia and LED fog lamps. It also has the option of an SRT-inspired hood with center air inlet duct and two heat extractors. On the Citadel models, second-row captain's chairs will be standard. There's also a new integrated trailer brake on models equipped with the Trailer Tow Package. New 20-inch wheel designs are available on various trims, and an available 825-watt, 19-speaker Harman Kardon sound system for the Citadel, R/T and SRT. Three new exterior color options appear, too: F8 Green, Destroyer Gray and Reactor Blue. SRT buyers can now opt for red seat belts and lightweight Brembo brakes with two-piece rotors. Its Hemi V8 still makes 475 horsepower as it did last year. The R/T model, meanwhile, continues with the 5.7-liter Hemi V8, also available on the Citadel, making 360 horsepower and 390 pound-feet of torque. Sepia leather seats are a new option. Order books are now open, but there's no word yet on price. Related Video: