2006 Dodge Charger Base Sedan 4-door 2.7l on 2040-cars
Amite, Louisiana, United States
Body Type:Sedan
Vehicle Title:Clear
Engine:2.7L 2700CC 167Cu. In. V6 GAS DOHC Naturally Aspirated
Fuel Type:GAS
For Sale By:Private Seller
Make: Dodge
Model: Charger
Trim: Base Sedan 4-Door
Options: CD Player
Safety Features: Anti-Lock Brakes, Driver Airbag, Passenger Airbag
Drive Type: RWD
Power Options: Air Conditioning, Cruise Control, Power Locks, Power Windows, Power Seats
Mileage: 103,896
Exterior Color: Silver
Interior Color: Gray
Number of Doors: 4
Number of Cylinders: 6
2006 Dodge Charger 2.7
Dodge Charger for Sale
2007 dodge charger r/t awd 5.7l hemi-leather-sunroof-nav-white-upgrades!!!(US $14,500.00)
Daytona orange on black. hemi 5.7l. sunroof. heated seats. carfax certified.(US $19,000.00)
Charger, cheap, sedan, police,(US $2,000.00)
2013 dodge charger se one owner clean carfax no accidents
2013 dodge charger se sedan 4-door 3.6l white low mileage smoke free(US $21,490.00)
2008 dodge charger srt8 sedan 4-door 6.1l (super bee)(US $26,000.00)
Auto Services in Louisiana
Wrens Auto Service ★★★★★
Transmission Depot Inc ★★★★★
Total Package Auto Detailing, LLC ★★★★★
The Radiator Shop ★★★★★
Team Automotive ★★★★★
Stafford`s Auto Repair ★★★★★
Auto blog
Dodge Challenger spied exercising supercharged Hellcat Hemi V8
Wed, 23 Oct 2013One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.
Watch these Dodge Demons explode on a Texas drag strip
Thu, Feb 14 2019The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.
How to update and secure a vulnerable Chrysler Uconnect system
Sat, Jul 25 2015If you own one of the 1.4 million vehicles affected by the recent Chrysler software recall, you may want to watch this video. In it, we explain how to get the latest infotainment software loaded onto the 8.4-inch Uconnect system. The recall was a response to the findings of researchers who were able to hack into and remotely control a 2014 Jeep Cherokee through its cellular connection. Although Fiat Chrysler has worked with Sprint to plug most of the holes on the carrier side, there are still some vulnerabilities that only this latest software version can patch. Owners have three options to get the update: download it now, wait for a USB stick in the mail, or take the vehicle to an FCA dealer. Chrysler will be sending USB sticks loaded with the software update to customers. Anyone with an internet connection and a USB stick of their own with at least 4 GB capacity can speed things up by downloading the patch from the Uconnect website. We cover that process from start to finish in the video, with the final portion still applicable to those using the FCA-supplied USB stick. If after watching this you still don't want to tackle the patch yourself, you can take your vehicle to the dealer to have it done. Also note that this process is the same for all Uconnect updates, not just the one patching the exploits. Our demonstrator vehicle is a 2015 Ram 1500 pickup. The procedure should be very similar on other products with the 8.4-inch Uconnect system, with only the location of the USB port varying. Once you have the USB stick with the software on it – either after having downloaded it yourself or receiving it in the mail from Chrysler – the installation process is relatively simple. It takes about 15 minutes to perform the update; we edited out the wait in the video. To check whether or not your car's 8.4-inch Uconnect system is running the latest software, go to System Information on the touch screen's Settings page and look at Software Version. The update related to the recall is version 15.17.5. Related Video: Recalls Chrysler Dodge Jeep RAM Safety Technology Infotainment Videos Original Video hacking










