2010 Red Srt8! on 2040-cars

Auto blog

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

A look at the Dodge Demon's drag settings, modes, and go-fast tech

In the same video that gave us a peek at the 2018 Dodge Challenger SRT Demon's performance stats, there's a serious dump of info on the tech and tools that will likely help this muscle coupe slaughter drag strips. Dodge has outlined a few of them for us and we're using the power of inference to figure out the rest. Here's what we've gathered. A lot of these hints come from the Demon's version of Performance Pages, the infotainment screens that show what SRT models are doing and let the driver change the powertrain and chassis setup. There are a lot of Demon-only features, including line lock, a quick cooldown mode for the supercharged engine, and data recording. And of course there are pages to show a digital time slip with acceleration and braking figures, a g-load plot, and lots of gauges to track temps and levels. The engine output is shown in the video on a special Dyno page. It tracks horsepower and torque over time on the upper graph, and engine rpm and shift points on the lower graph. And we think it's still hiding something. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Any good drag car has a line lock, allowing the driver to lock the front brakes and leave the rears free to do a nice tire-warming (or tire-shredding, depending on length) burnout. Ford has it on the Mustang, Chevy puts it on the ZL1, and now Dodge is adding it to the Demon. It should help get the giant Nitto tires up to temp for a drag run. And once the tires are warm, there's launch control, just like on the SRT Hellcat, with selectable rpm to dial things in for the conditions. The Demon also has a shift light in the cluster, and the driver can set a shift point individually for each gear. After each drag run, you can activate Quick Cooldown, which Dodge says uses the first production application of After-Run Chiller – it runs the cooling fan and intercooler coolant pump with the engine off until the coolant reaches its target temp. It's shown in one of the slides above. The checklist on the left side of that page suggests it requires a set of conditions be met to work: engine off, hood open, and sufficient battery level. This further reinforces our theory that the supercharger is going to make big boost, beyond the Hellcat's 11.6 psi. And while you're waiting for the supercharger to cool off for another run, you can review the performance data the car records.

The Dodge Demon was developed under a cloud of smoke

The Dodge Demon needs no introduction. The car is so full of superlatives that most of it sounds unbelievable until you see and hear it in action. The car was revealed after months of teasers and cryptic messages, but the public weren't the only ones in the dark. From the start, the Demon's development was a closely guarded secret. There were even some within SRT that didn't know about the project. The people behind the car went through a lot of effort to keep it that way. At an event covering the finer details of the Demon's supercharged 6.2-liter V8, Dodge CEO Tim Kuniskis and SRT Powertrain Director Chris Cowland spoke about the smoke and mirrors used to hide the Demon's development. Work on the car progressed for nearly two years before it was made public, with just a small team having full access to the project. Numbers were altered. Secret meetings were held. SRT engineers worked nights and weekends while parts suppliers were given as little information as possible to move progress forward. Preliminary work on the Demon began in April of 2015, not long after the standard Hellcat hit the streets. The goal wasn't to create a faster Hellcat. Kuniskis said that would have been easy. They wanted a single-minded vehicle that could also be driven on the road. It's the same mindset that brought about the Dodge Viper ACR. Dodge wanted a car that could sell the brand to both enthusiasts and non-enthusiasts alike. 840 horsepower is going to raise anyone's eyebrows, including the Camry owner parked down the street. While preliminary work started in April, the final greenlight wasn't given until September. The project was originally going to revive the American Drag Racer, or ADR, name. When we saw the first hints of the Demon last fall, we labeled the spy photo above the Dodge Challenger ADR. It was set to have 10-percent more power and 20-percent more launch force than the already gut-punching Hellcat. It was also only going to have a quarter-mile time in the 10s, just slightly quicker than the Hellcat. Somewhere along the line, the team realized that the ADR wasn't enough. It was just going to be a Hellcat plus, and that wasn't exciting. The main goal was changed: 9s with light. Translated, that means a 9-second quarter mile with light under the tires (read: a wheelie). From that point forward, everything about the Demon's development, from power to suspension to weight, would be done in pursuit of that goal.