Find or Sell Used Cars, Trucks, and SUVs in USA

1971 Dodge Challenger Two For One Mopars on 2040-cars

Year:1971 Mileage:0
Location:

Eugene, Oregon, United States

Eugene, Oregon, United States
Advertising:
Vehicle Title:Clear
Fuel Type:Gasoline
Engine:none
For Sale By:Private Seller
VIN: JH23G1225912 Year: 1971
Drive Type: 2 whell
Make: Dodge
Mileage: 0
Model: Challenger
Trim: base
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"1971 Dodge Challenger bead blasted and epoxy primed rolling chassie. Plus Bonus 1966 Dodge Dart GT. Both have Clear titles make payments, gold & silver."

Auto Services in Oregon

Zeigler`s Trans & Auto Repair ★★★★★

Automobile Parts & Supplies, Auto Body Parts
Address: 1911 SW Court Ave, Pilot-Rock
Phone: (541) 276-8024

Washington Glass Of Goldendale ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Automobile Accessories
Address: 740 E Broadway St, Rufus
Phone: (509) 773-5500

Tualatin Transmission Center ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Clutches
Address: Zigzag
Phone: (503) 691-1555

Tualatin Tire Factory ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Brake Repair
Address: 8750 SW Old Tualatin-Sherwood Rd, Beavercreek
Phone: (503) 692-9333

Trinity Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Home Repair & Maintenance
Address: Idanha
Phone: (503) 267-9596

Tom Dwyer Automotive Svc ★★★★★

Auto Repair & Service, Brake Repair, Auto Transmission
Address: 530 SE Tenino St, Boring
Phone: (503) 230-2300

Auto blog

Dodge Challenger ACR rumored finally on its way using Viper ACR as benchmark

Mon, Jun 1 2020

In 1995, Dodge released the ACR Neon, an unlikely combination of cheap, compact American sedan and high-performance parts and engineering marked by initials standing for American Club Racer. Dodge sold a heap of them, so the automaker flexed the ACR brand's potential with the first ACR Viper in 1999. The racy coupes made huge noise for Dodge and the Viper. After the fourth-gen Viper ended production in 2010, Dodge took a Challenger ACR concept to SEMA in 2011. But instead of carrying the coupe to production, Dodge resurrected the Viper for 2013 and got one more Viper ACR model out during the last Viper's final years. With the Viper gone again, it appears Dodge is sorting out that Challenger ACR concept for real. Last October, Mopar Insiders reported the automaker was trying to get a Challenger ACR prepared for the model's 50th anniversary this year. The timing looks highly unlikely, but an Allpar source says the track-happy coupe is still coming, and with bonkers expectations and gear. We're talking about a big-boi widebody Challenger tuned to do hard laps, fast, around twisty circuits, all day long. An Allpar insider known as "Muther," a code name to tug at John le Carre's heart, said Dodge is considering two engines. Because the point of the car is to be raced and some series don't accept forced induction, one trim would fit the naturally aspirated 392 Hemi from the R/T Scat Pack. There's no telling if that motor would get a power bump, but the Challenger ACR concept upped its output slightly with measures like a cat-back exhaust. The other trim, naturally, would fit the 6.2-liter Hellcat Redeye V8.     Muther told Allpar that if engineers can get the car under 4,000 pounds, the math points to being within two seconds of the time set by the Viper ACR-E at Road America. That "E" represents the Extreme Aero Package, with addenda like a deeper front splitter, dive planes, and an adjustable, dual-element rear wing that helped the Viper ring up 14 lap records on U.S. tracks. The fastest time we know of for a Viper at Road America is from 2011, factory race driver Kuno Wittmer doing 2:20 even in a Gen IV Viper ACR. Wittmer's ride weighed 3,408-pounds. Dodge boffins want to get the Challenger ACR under 4,000 pounds. Achieving the weight goal would mean cutting at least 387 pounds from a standard R/T Scat Pack Widebody, and 512 pounds from the Hellcat Redeye Widebody if that trim has the same target.

The Dodge Demon isn't the only way to a 10-second quarter mile

Tue, Jul 25 2017

The Demon's rear tires smoke, the front tires lift – and in under ten seconds (after having spent $85,000) you've covered a quarter mile. In short, we fully get the attention shown Dodge's SRT Demonstrator. With disruption the operative word of the times, it's good to see a representative of the movement coming from Detroit. The SRT Demon delivers disruption in spades. There is, however, a viable alternative – and it doesn't require getting on the list at your Dodge dealer. If you want to do 0-60 in under three seconds or the quarter mile in around 10, the folks at Honda, Kawasaki, Suzuki and Yamaha – with any of their one-liter superbikes – have you covered. The gestation of what we now know as the superbike came roughly a decade after the debut of the muscle car. It was in the early '70s, as emission and safety regulations – along with rising insurance premiums – decimated the ranks of Detroit's fastest that motorcycle makers found their magical, almost mystical momentum. Honda's CB750 four was arguably the first, followed soon by Kawasaki's Mach III and Z-1. After that, it was Katie-bar-the-door, with more horsepower offered by Japanese OEMs until, invariably, insurance premiums went higher and, during the last recession, 20-somethings couldn't get affordable loans or insurance. Today, Japan's Big Four are once again engaged in a horsepower war, fueled by the rising interest in MotoGP, along with the rising profits available when selling a $20,000 motorcycle. And if that $20,000 - $10K per wheel – seems high, simple math tells you it's less than half of what you'll spend per corner if buying Dodge's Demon. The specs tell the tale. The Demon, fattened by both its flared fenders and a platform dating from the George Bush administration, supports its 4,200+ pounds on a wheelbase of 116 inches. That's in contrast to Suzuki's GSX-R1000 – redesigned for 2017 – which puts its 443 pounds atop a wheelbase of just 56 inches. To maximize its Hemi-supplied 800+ horsepower, Dodge diverts the air conditioning from the Demon's interior to the engine, which makes racing on a summer evening (you guessed it) devilishly hot. On Suzuki's GSX-R1000 – or similarly-equipped superbikes – almost all of the air at 100+ miles per hour is directed at you. To further underscore the differences, know that the GSX-R1000 and its like-minded competition can turn a quick corner, while the Demon is hard-pressed to execute a U-turn at the end of a quarter-mile straightaway.

2 men die in Dodge Challenger Hellcat crash at Colorado airport

Tue, Sep 12 2017

Two friends died in the crash of a Dodge Challenger Hellcat over the weekend after they shot off the end of an airport runway, authorities said. That someone died in a 707-horsepower Hellcat is, sadly, not unexpected. But two aspects of the story are remarkable. First, the men's ages: The Denver Post reports the crash victims were Lynd Fitzgerald, 71, of Colorado Springs, and his passenger, Roger Lichtenberger, 76, of San Marcos, Calif. Second, their speed: The car was likely moving at over 100 miles per hour, authorities said. The men had permission to use the 8,300-foot runway at Central Colorado Regional Airport in Buena Vista. That's more than a mile and a half long. But when the car left the runway, it went 300 feet before flying over a ravine, hitting the ground, becoming airborne again, flipping end over end across a second ravine, and ultimately landing on its wheels 650 feet past the end of the pavement. Responding police officers tried to provide first aid, but the men were declared dead at the scene. "They were just test-driving this car. They went a little too fast. I don't want to surmise. ... They probably got to the end of the runway and, at that speed, didn't realize they were there so fast. And they lost control. It was just too high a speed and they got to the end of the runway," said Chaffee County Sheriff John Spezze. There were skid marks near the end of the runway, but the sheriff didn't know the length. "I've never seen anything like it," Spezze told the newspaper. "They had permission to be there. There were no laws broken." Related Video: