2007 Dodge Caliber Fwd Clean Carfax on 2040-cars

Auto blog

Texas cops pull armed suspect from burning car

A high-speed chase through Fort Worth, Texas ended in dramatic fashion earlier this month when FWPD pulled armed burglary suspects from the burning wreckage of their escape vehicle. According to NBC DFW, Fort Worth police were dispatched to Avington Way on the evening of July 16 to investigate reports of a burglary. The burglary victim told police he had arrived home to find three individuals hauling his property out of his house. When he approached them, one of the suspects pointed a handgun at him and told him to stay back. Then all three suspects climbed into a silver Dodge Avenger and sped away. FWPD officers spotted the Avenger a short time later on Sycamore School Road and, after the car refused to pull over, the chase was on. Police chased the burglary suspects through the city at speeds approaching 100 mph until the Avenger blew a red light and was t-boned by an oncoming pickup at the intersection of California Parkway and James Avenue. As the pursuing officers closed in on the disabled car, it suddenly caught fire. One suspect bailed out and ran for it, but the remaining two were trapped inside with the flames quickly mounting. Despite the spreading fire and the threat of armed suspects in the vehicle, police officers rushed to pull the men from the wreck. The driver was removed easily, but the passenger was unconscious and trapped behind a crushed passenger door. The scene was caught on the officers' body cameras as they pried the door open with their bare hands. Eventually the officers got the semi-conscious man out of the passenger seat just as the car was completely engulfed in flames. "It was pretty dramatic. We recruit people that can think on the fly, think quickly, and perform under pressure," FWPD Sergeant Marc Povero told WFAA. All three suspects are facing charges for burglary, and the driver was charged with evading arrest. News Source: WFAA, NBC DFW Auto News Chevrolet Dodge Driving Safety Truck Police/Emergency Sedan fire car fire burglary

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

The Dodge Demon sheds some weight in pursuit of speed

The Dodge Demon teaser train isn't stopping until it hits New York City. In case you need a reminder, the upcoming Demon is the more pedestrian Hellcat's stripped-down and hopped-up sibling that promises to be built for the sole purpose of traveling a quarter-mile mile quicker than any of its rivals. The weekly video rollout on www.ifyouknowyouknow.com continues with the latest sneak peak, "Reduction." While there were early rumors that the Demon may pack an all-wheel-drive system and in turn gain enough grip to rotate the Earth underneath it, Dodge and SRT look to be going down a simpler route. The press release reveals the Demon is 200 pounds lighter than the standard Hellcat. It's unclear where all that weight is coming from, but at nearly 4,500 pounds, the Challenger Hellcat could stand to go on a bit of a diet. The video hints at adjustments to the wheels, steering, suspension, and brakes, as well as some modifications to the car's interior. Don't be surprised if the Demon is a bare bones stripper model with no back seat, no A/C, and no radio. Who needs music when you have 2.4-liter supercharger and a 6.2-liter Hemi V8 making sweet love under the hood? Related Video: Image Credit: FCA Design/Style Marketing/Advertising New York Auto Show Dodge Coupe Future Vehicles Special and Limited Editions Performance dodge demon dodge hellcat