2009 Chrysler Town And Country One Owner Low Miles No Reserve!!! on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

Chrysler may be testing a Hellcat 300

Another day goes by, and another mysterious, undisguised SRT prototype comes out of FCA. This time we have a Chrysler 300 SRT that looks nearly stock except for its footwear. Our spy photographer got up close and personal with this machine, and found that it has the same wheels with 315-mm tires that were on the early Dodge Demon prototypes. The only difference is the wheels on this 300 have Chrysler-branded center caps. All that extra width means these wheels stick pretty far out from the wheel wells, which would suggest that any production car running this setup would have flares to cover the wheels. Behind those wheels are four-piston Brembo calipers and slotted discs that looks similar to those on the current 300 SRT. We doubt that Chrysler is building a Demonized version of the 300, but the tires do suggest that this is a much more potent 300 than the current SRT, which was discontinued in the US in 2015 but is still sold in the Middle East and Australia. That's not all we have to go on, though, since our spy photographer says it sounded like it had Hellcat power under the hood. Equipping a 300 with a Hellcat engine would be a breeze, too, since the engine is already in the Charger, which is virtually identical mechanically. What you may be wondering is why Chrysler is adding a Hellcat version of the 300 SRT when that model hasn't been available in the US since 2015. One possible reason is that this would finally allow Aussies access to the 707-horsepower machine. Dodge is not a brand offered Down Under, so it doesn't get the Charger Hellcat, leaving the 300 as the only V8, rear-drive Mopar available. And for the Middle East, if the normal 300 SRT was selling well, it would only make sense to offer another variant. It shouldn't cost Chrysler too much to develop this model either, since the 300, mechanically, is virtually identical to the Charger. Related Video: Featured Gallery Chrysler 300 SRT Hellcat Widebody Spy Photos View 16 Photos Image Credit: Brian Williams Spy Photos Chrysler Performance Sedan chrysler 300 srt8

FCA recalls 1.25M trucks for software error in fatal crash

WASHINGTON - Fiat Chrysler Automobiles said Friday it would recall more than 1.25 million pickup trucks worldwide to address a software error linked to reports of one crash death and two injuries. The error code could temporarily disable the side air bag and seat belt pretensioner deployment during a vehicle rollover spurred by a significant underbody impact, such as striking onroad debris or driving off-road, the Italian-American automaker said. The company will reprogram computer modules in the affected vehicles to address this error. The recall covers 1.02 million 2013-16 Ram 1500 and 2500 pickups, and 2014-2016 Ram 3500 pickups in the United States, 216,007 vehicles in Canada; 21,668 in Mexico; and 21,530 outside North America, the automaker said. Fiat Chrysler said the recall would begin in late June. In the event of the software error code, the problem could temporarily be addressed by turning the vehicle off and then on, the company said. The automaker told the U.S. National Highway Traffic Safety Administration it began investigating the issue in December after it received notice of a suit involving a 2014 Ram 1500 in which the airbag failed to deploy in a rollover crash.Reporting by David ShepardsonRelated Video: Recalls Chrysler Fiat Truck FCA airbag fiat chrysler automobiles