2005 - Chrysler Town And Country Handicapped Van on 2040-cars

Auto blog

Maserati Levante will borrow Chrysler Pacifica Hybrid's PHEV powertrain

The plug-in hybrid tech from the 2017 Chrysler Pacifica Hybrid minivan will move seriously upmarket into a future version of the Maserati Levante crossover. The PHEV model should arrive around early 2018 or possibly the end of 2017, division boss Harald Wester told Motor Trend. Wester was blunt about the reason for using the minivan's powertrain. "A standalone program would be suicidal so we have to look at FCA," he said to Motor Trend. However, he expects the PHEV to comprise a tiny portion of the luxury CUV's sales volume – possibly as low as six percent. The Pacifica Hybrid will be the first PHEV minivan in the US when it arrives in the second half of 2016. The powertrain combines a 3.6-liter V6 that runs on the more efficient Atkinson cycle, and two electric motors, which are in the gearbox. A 16-kWh lithium-ion battery under the floor stores the energy for the system. Chrysler estimates the setup can carry the minivan 30 miles purely on electric power and achieve 80 MPGe. The first examples of the Levante should arrive in the US in August, according to Motor Trend. Maserati plans initially to offer its luxury crossover here with two twin-turbocharged 3.0-liter V6s. Base models use a version with 350 horsepower and 368 pound-feet of torque. The S trim gets some extra grunt thanks to a tune that makes 430 hp and 427 lb-ft. Both models come with an eight-speed automatic transmission, all-wheel drive, and a limited-slip differential. The Maserati will have a fleet of posh, European crossovers to fight against, and the PHEV will possibly offer an edge to entice a few green-minded, wealthy customers. Related Video:

Marchionne blames design 'dummies' for poor Chrysler 200 reception

I like the new Chrysler 200. In fact, we have one in the office this week, and every time I see it outside, I think to myself, "That's a really good looking car." But truly good automotive design allows form to perfectly blend with function, and that's where the 200 falls short – so short, in fact, that Chrysler's midsize sedan has yet to earn a full recommendation from the folks at Consumer Reports. The problem? That slick roof design. During an interview at the Detroit Auto Show this month, Fiat-Chrysler CEO Sergio Marchionne said the 200's rear roofline compromised ingress and egress from the rear seats, and that's why CR can't fully recommend it. "The 200 failed because somebody thought that the rear-seat entry point inside the 200 – which is our fault, by the way – is not up to snuff," Marchionne said to Automotive News. Marchionne went on to say that FCA's designers copied the roofline of the Hyundai Sonata, which "has the same problem." He continued, "We didn't copy the car, we copied the entry point to the rear seat. Dummies. I acknowledge it." Harsh words, but Marchionne isn't alone in his sentiments. FCA design boss Ralph Gilles tweeted today, "He is right, we might have gone too aggressively after aero. Which we achieved as it is best in class. No free lunch." So yes, the 200 looks good. But following this incident, perhaps a redesign will ditch that sloping roof for something that's a bit more functional. Related Video:

NHTSA looking into non-Takata airbag shrapnel case

The global airbag inflator recall from Takata has been one of the biggest topics in auto safety for months. Now, the National Highway Traffic Safety Administration is opening a preliminary evaluation into the components from Arc Automotive to investigate whether two reported ruptures and two injuries signal a wider problem. So far, only the 2002 Chrysler Town & Country and 2004 Kia Optima are believed to be affected. If a safety campaign is deemed necessary, it could cover an estimated 420,000 of the minivans and 70,000 of the Korean sedans. NHTSA first noticed these ruptures in December 2014. The agency received a complaint of a 2009 case in Ohio about the bursting of the driver's side inflator in a 2002 Town & Country. According to the report, the incident broke the woman's jaw and sent shrapnel into her chest. The government investigated the case, and this was found to be the only known occurrence in these vehicles. The analysis indicated the part's gases were possibly blocked somehow and caused the component to explode. FCA US spokesperson Eric Mayne told Autoblog that the company is "cooperating fully" with NHTSA. "Also, we no longer use that inflator," he said. A second incident came to NHTSA's attention in June 2015 with the driver's side rupture in a 2004 Optima in New Mexico. The agency lists fewer details about the case, and a root cause isn't known. This is also the only currently known example in a Kia vehicle. According to a statement from Kia to Autoblog, "We are taking this matter very seriously and support NHTSA's action and will continue working cooperatively with the agency and suppliers throughout the process." Arc's components are sealed within a steel housing that's meant to protect them from "external atmospheric conditions," according to NHTSA. Multiple suppliers also use them. In the Chrysler, the airbag module came from Key Safety Systems and from Delphi in the Kia. In a statement to Autoblog the company said, "We have received NHTSA's notification and are cooperating fully with its Preliminary Evaluation." At this time, NHTSA admits that it doesn't know for certain whether these two cases are linked. The agency is conducting this preliminary evaluation to learn more.