2003 Chrysler Town & Country Limited All Wheel Drive Gold Leather Loaded on 2040-cars

Auto blog

Fiat and UAW back at negotiating table over Chrysler stake

We knew there'd be no Chrysler IPO before the end of this year, but Fiat is determined to get the best run going into 2014 and is back at the poker table with the UAW. The delay was said to be Chrysler's desire to clean up a tax issue with the IRS; turns out that also bought the carmaker time to try and close a deal for the UAW's 48.5-percent stake in the company before the IPO happens.
Whereas the price Chrysler was willing to pay was once more than $1 billion under the UAW's asking price, the gap has closed to just $800 million of late. A recent valuation of the company at $10 billion - a valuation the UAW has disputed - means Fiat would be looking to pay about $4.2 billion instead of the $5 billion that the UAW seeks. But the UAW needs to hold out for the highest amount it can get because its pension obligations through the Voluntary Employee Benefit Association (VEBA) are $3.1 billion greater than the VEBA's assets, which include the Chrysler stake.
There's a clause in the agreement that Fiat can buy the VEBA shares for $6 billion, but Fiat CEO Sergio Marchionne has said that the UAW "should buy a ticket for the lottery" if they even want $5 billion. The UAW, though, has more time to wait; it's Fiat that wants access to Chrysler's $11.9-billion war chest and that would like to avoid the risk of paying the full $6 billion for the UAW share if the float really takes off. With other valuations of Chrysler as high as $19 billion, a hot IPO could make that $6 billion look like a bargain.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Mopar opening Custom Shop at Cobo

While other automakers have been streamlining their brand portfolio, the Chrysler Group has shown no such signs. It's got the Dodge, Chrysler and Jeep brands, plus Fiat, and it recently broke out its SRT and Ram nameplates into their own brands. And you can bet each will have its own presence at the Detroit Auto Show this year. But don't forget Mopar. The company's performance parts division is getting its own display at Cobo this year, and it'll be the largest in the brand's history.
The Mopar Custom Shop is poised to take up 5,500 square-feet of Cobo floor space, further expanding on last year's Mopar Garage. If the image above offers any indication, the show stand will include a Dodge Challenger, SRT Viper, Fiat 500L, Jeep Wrangler, Jeep Cherokee, Ram 3500 and what looks like (but isn't identified in the press release below as) a Chrysler 200 (which may be replaced by a 2014 model), all augmented with Mopar parts and accessories.
Visitors will also be able to use pre-programmed iPads to configure Chrysler Group vehicles with a wide range of accessories - a portfolio that grows by 1,500 new parts every year and tops over 100 add-ons for every new vehicle Chrysler launches.