2020 Chrysler Pacifica Touring L Plus on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

GM seeks appeals court ruling to continue legal fight with Fiat Chrysler

DETROIT — General Motors on Friday asked a U.S. appeals court to allow it to continue pursuing its civil racketeering suit against rival Fiat Chrysler Automobiles, rejecting a lower court judge's belittling of the complaint. The automaker's filing with the Sixth Circuit Court of Appeals comes less than a week after U.S. District Court Judge Paul Borman called GM's suit against Fiat Chrysler a "waste of time and resources" at a time when both automakers should be focused on surviving the coronavirus pandemic. Borman ordered GM Chief Executive Mary Barra and Fiat Chrysler CEO Mike Manley to meet by July 1 to negotiate a resolution. "As we have said from the date this lawsuit was filed, it is meritless," FCA said on Friday. "FCA will continue to defend itself vigorously and pursue all available remedies in response to GM's groundless lawsuit. We stand ready to comply with Judge Borman's order," it added. In its motion, GM asked the appeals court to throw out Borman's order and reassign the case to a different district court judge. It called Borman's order "unprecedented" and "a profound abuse" of judicial power. GM sued Fiat Chrysler last year, accusing the Italian-American company's executives of bribing United Auto Workers union officials to secure labor agreements that put GM at a disadvantage. Fiat Chrysler is under investigation by the U.S. Justice Department as part of a wide-ranging probe of UAW corruption. GM's accusations came as Fiat Chrysler and French automaker Peugeot were in the early stages of preparing for a merger. Fiat Chrysler has said the suit was aimed at disrupting that deal. GM has said the suit has nothing to do with the merger. In a statement, GM rejected Borman's characterization of the suit as a "distraction" and defended its decision to press the case. "We filed a lawsuit against FCA for the same reason the U.S. Department of Justice continues to investigate the company: former FCA executives admitted they conspired to use bribes to gain labor benefits, concessions and advantages. Based on the direct harm to GM these actions caused, we believe FCA must be held accountable." Related Video: Government/Legal UAW/Unions Chrysler Fiat GM

Stellantis axed the SRT engineer team, but performance isn't going away

Stellantis has broken up the Street & Racing Technology (SRT) engineering team that created over a dozen high-performance vehicles, including the Dodge Charger Hellcat, but the situation isn't as dire as it sounds. The newly-formed company assigned SRT's former engineers to different positions, where they'll continue to make hot rods. "All of the core elements of the SRT performance engineering team have been integrated into our company's global engineering organization," a spokeswoman told enthusiast website Mopar Insiders. She added that integrating SRT's personnel into other brands in the Stellantis portfolio will ensure that the lessons learned from decades of peddling speed will permeate other products. Previously, SRT operated with a high degree of independence. Don't get too excited. Her statement does not necessarily mean that Citroen will begin building cars powered by the Hellcat engine, though a C3 Chat D'enfer sounds absolutely epic. Technology transfer will likely be limited to fields like aerodynamics and thermal management, and the design department might learn a couple of neat new tricks. Dodge will still move forward with the development of its next SRT-branded cars; the decision to dissolve the SRT team will not affect future models, according to the spokeswoman. Whether they'll be powered by a V8 is up in the air, because company boss Tim Kuniskis warned that regulations are killing the eight-cylinder engine. Similarly, Jeep will continue designing high-performance models, like the Grand Cherokee Trackhawk. What changes is that the model will be developed and designed by a group of engineers and designers from Jeep, not from SRT. SRT is dead, but performance isn't going away. SRT's demise nonetheless marks the end of an era for Chrysler. The division traces its roots to 1989, when some of the company's brightest minds were brought together to develop the first-generation Dodge Viper. It merged with Team Prowler to form the Specialty Vehicle Engineering (SVE) group, which was renamed Performance Vehicle Operations (PVO) in 2002 and finally dubbed SRT in 2004. SRT has operated as the carmaker's in-house tuner since, its resume includes a diverse selection of cars ranging from the Neon SRT-4 to the 1500 TRX, and it was promoted to a standalone brand led by designer Ralph Gilles in 2011. Fiat-Chrysler Automobiles (FCA) axed the SRT brand in 2014 but kept the name and the development team. Related video: