2022 Chrysler 300 Series Touring on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

EU starts legal action against Italy over Fiat Chrysler emissions

BRUSSELS/ROME - The European Commission launched legal action against Italy on Wednesday for failing to respond to allegations of emission-test cheating by Fiat Chrysler, in a procedure that could lead to the country being taken to court. The Commission said Italy had failed to convince it that devices used to modulate emissions on Fiat Chrysler vehicles outside of narrow testing conditions were justified. "The Commission is now formally asking Italy to respond to its concerns that the manufacturer has not sufficiently justified the technical necessity – and thus the legality – of the defeat device used," the Commission said in a statement. Italy has two months to respond to the Commission's request and may be eventually taken to the European Court of Justice if the answer is found to be unconvincing. Italy had asked the European Union to postpone its plan to launch legal action against Rome over emissions at Fiat Chrysler, Transport Minister Graziano Delrio said. "Considering that after the end of the mediation process, we did not receive any request for further information ... we ask that you delay starting the infringement procedure while we await a letter asking for clarification on issues raised by your relevant offices," Delrio told EU Industry Commissioner Elzbieta Bienkowska, according to the ministry's statement. The European Commission has been mediating a dispute between Rome and Berlin after Germany accused Fiat Chrysler of using an illegal device in its Fiat 500X, Fiat Doblo and Jeep Renegade models. That mediation ended without fanfare in March. EU officials have become increasingly frustrated with what they see as governments colluding with the powerful car industry and the legal move is the biggest stick the European Commission has available to force nations to clamp down on diesel cars that spew out polluting nitrogen oxide (NOx). Delrio, however, said the material Italy had sent to the Commission during the mediation process showed that the vehicles' approval process was correctly performed. Under the current system, which the Commission is trying to overhaul, national regulators approve new cars and alone have the power to police manufacturers. But once a vehicle is approved in one country, it can be sold throughout the bloc. Last December, the Commission launched cases against five nations, including Germany, Britain and Spain, for failing to police the car industry adequately.

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.