2013 Chrysler 200 Touring Sedan 4-door 2.4l on 2040-cars

Auto blog

NHTSA closes investigation on 4.7M FCA power modules, no recall

FCA US hasn't had the best time with recalls as of late. Not only did the company recently agree to greater safety oversight and paid $105 million to the government, that came just days after hacking fears prompted a 1.4-million model recall campaign. However, a recent decision to close an investigation by the National Highway Traffic Safety Administration means that the automaker doesn't have to worry about another major recall possibly affecting 4.7 million vehicles, according to the agency's report (as a PDF). Last September, the Center for Auto Safety petitioned NHTSA to investigate an alleged problem with the totally integrated power module (TIPM) on these FCA US models. The group claimed that a fault with the component could cause a variety of maladies, including stalls, not starting, catching fire, unintended acceleration, and airbag non-deployment. At the time, it also submitted 70 cases where this had reportedly happened. According to NHTSA, "no valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration, or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components." The agency did find signs of an issue with the fuel pump relay in some Jeep Grand Cherokees and Dodge Durangos, but FCA US issued recalls for the problem in September 2014 and February 2015. Without anything else to go on, the Feds don't think it's worth investigating this topic any more.

Jeep still working to improve Cherokee's 9-speed auto

Fiat Chrysler is hoping an upcoming software update will stem the tide of consumer complaints surrounding its nine-speed automatic transmission. Owners of the 2014 Jeep Cherokee have reported a number of problems on the National Highway Traffic Safety Administration's SaferCar.gov website, since the new model and its troubled gearbox arrived way back in October 2013. The software update is "intended to keep the vehicle performing as intended, and to prevent durability issues from occurring in the future," an FCA spokesperson told Automotive News, and will be available to owners of both the 2014 to 2015 Jeep Cherokee and the 2015 Chrysler 200, which also uses the 9AT. While FCA will be notifying consumers of the update, owners can also request the software reflash if they happen into their dealer before then. Despite the widely documented problems with the transmission, the only complaints on NHTSA's website relate to the 2014 Cherokee – neither the 2015 Jeep nor the 200 have received any complaints. That bodes well as FCA prepares to begin deliveries of the 2015 Jeep Renegade and launch the Fiat 500X, both of which pair the 9AT with the 2.4-liter Tigershark four-cylinder. "We have had to do an inordinate amount of intervention on that transmission, surely beyond what any of us had forecast," FCA CEO Sergio Marchionne told Automotive News. "There are things that we have done – that we continue to do. Our proactive customer care intervention has actually increased in intensity on these vehicles in 2014, especially in the second half." What's fascinating about the 9AT's problems are that they haven't been the fault of manufacturer ZF, but have related to software that wasn't "mature" and had "teething problems," Marchionne has said previously, AN reports. With the lack of criticism for the 9AT in 2015 models and this pending software update, though, here's hoping that FCA has finally figured out its fuel-sipping gearbox. Related Video:

Detroit 3 and UAW set for showdown over tiered wages

This week, thousands of United Auto Workers will converge on Cobo Center in Detroit for the Special Convention on Collective Bargaining, an every-four-year event that lets members tell UAW leaders what the negotiating priorities should be during contract negotiations. This is where a lot of sand and a lot of lines start coming together in preparation for contract negotiations between the UAW and the Detroit 3 automakers, which will happen later this year. Number one on the UAW agenda is the end of the two-tier wage system created in 2007 to help the automakers get through bankruptcy; veteran workers are paid the Tier 1 rate of around $29.00 per hour, new hires are paid the Tier 2 rate of between $15 and $20 and get about half the benefits of Tier 1. Tier 2 hiring has been an undoubted success for the automakers, allowing them to keep factories in the US and hire more workers. By agreement, it is capped at a certain percentage of each automaker's workforce, and while the union's ultimate position is to get rid of the dual-scale system entirely; one leader said Ford could easily afford the $335 million it would take to convert all its workers to Tier 1 out of its $6.9 billion in 2014 North American profit, and General Motors could do the same out of the $5 billion it is handing to investors through the (admittedly forced) share buyback. Other delegates say that at the very least they'd be happy with enforcement of the current caps in the new contract. The automakers, conversely, would welcome expansion of the Tier 2 ranks. Including benefits, import automakers pay workers "in the high $40 range" per hour, according to an analyst, while Ford and GM pay about $59 in wages and benefits per hour. More Tier 2 workers on the rolls would let those two companies get labor cost parity with the competition. Fiat-Chrysler pays wages closer to the imports because of special exceptions in its UAW contract that allow unlimited Tier 2 hiring; those exceptions will end on September 14 and bring FCA into line with the other domestics, unless the new contract maintains them. FCA CEO Sergio Marchionne is opposed to the two-tier system, having called it "almost offensive." One analyst says the UAW might win a sizable pay raise for Tier 2 and a small increase for Tier 1, but the keystone issue will be how the hiring matrix can help the automakers keep overall wages in line with the imports.