Find or Sell Used Cars, Trucks, and SUVs in USA

2003 Chevy Tracker 4x4 Power Locks/windows Gas Saver! Great In Snow! on 2040-cars

Year:2003 Mileage:69205
Location:

Waterbury, Connecticut, United States

Waterbury, Connecticut, United States
Advertising:

Auto Services in Connecticut

Warburtons Automobile Repair ★★★★★

Auto Repair & Service
Address: 913 Main St, Oneco
Phone: (401) 828-6574

Vail Buick GMC ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 606 Bedford Rd, Ridgefield
Phone: (914) 666-7537

Saf-T Auto Ctr ★★★★★

Auto Repair & Service, Brake Repair, Gas Stations
Address: 986 S Main St, Cheshire
Phone: (203) 271-0899

Ren Sales & Svc ★★★★★

Auto Repair & Service
Address: 98 Linwood Ave, North-Grosvenordale
Phone: (508) 234-9651

Pop`s Exhaust ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Mufflers & Exhaust Systems
Address: 53 Slater St, Coventry
Phone: (860) 645-6095

Paul`s Automotive ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Parts & Supplies
Address: 804 Stanley St, New-Britain
Phone: (860) 223-3324

Auto blog

2017 Honda Ridgeline enters the landscape block war

Sun, Jun 12 2016

In the test of pickup truck beds, if steel is apples and aluminum is oranges, Honda wants you to know that composites are pineapples. Chevy recently performed a test in which its own Silverado was pitted against its most obvious competitor, the Ford F-150. A loader dropped over 800 pounds of landscaping blocks into the two truck beds, and Ford's aluminum bed ended up with more damage than Chevy's steel bed. Check that test out right here. Honda apparently wasn't content to let Chevy throw stones alone. In a new test, the Japanese automaker replicated the block-drop test using its brand-new Ridgeline truck, which features a composite bed. As you'll see in the video above, there was very little damage to the high-strength plastic bed of the Ridgeline after a similar load of landscaping blocks were dropped from a loader. Without being on hand at any of these tests, we can't say with any degree of certainty that they match up in severity. But they all look pretty similar, and this is actually a test that Honda performed in front of journalists ( ourselves included) earlier this year. We visually inspected the composite bed of a Ridgeline after a demonstration just like the one on video above, and can confirm that there was basically no damage to Honda's truck. Chevy went an extra step by flinging a heavy toolbox into the Silverado and F-150; Honda didn't match that particular test. Does any of this matter? That's up to truck buyers and owners to decide, naturally, but we doubt anyone would actually dump a load like this into their own truck. And it's also worth noting that a heavy-duty spray-on bedliner would probably minimize damage to the metal surface below, whether steel or aluminum. If nothing else, it's memorable marketing. Related Video:

GM recalls 668,000 SUVs due to faulty anchor bars for child seats

Fri, May 19 2023

DETROIT — General Motors is recalling more than 668,000 small SUVs in the U.S. because owners may not be able to hook child seats to the anchors. The recall covers certain 2020 to 2023 Chevrolet Equinox and GMC Terrain SUVs. The National Highway Traffic Safety Administration says in documents posted on its website Thursday that the rear-seat lower anchor bars may have had too much powder coating. That could make them too thick and prevent a child seat from being installed. GM says no crashes or injuries have been reported. The automaker is asking owners to install child seats using the seatbelts until the latches are repaired. Dealers will inspect the anchors and replace the finish if necessary. Owners will be notified by letter starting June 26.   Recalls Chevrolet GM GMC SUV child safety car seat

Final C6 Corvette built in Bowling Green

Fri, 01 Mar 2013

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.