2003 Chevrolet 3500 Lt 6.6l Duramax Diesel Leather Dually Drw Low Reserve No on 2040-cars

Auto blog

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

GM’s move to Woodward is the right one — for the company and for Detroit

Back in 2018, Chevy invited me to attend the Detroit Auto Show on the company dime to get an early preview of the then-newly redesigned Silverado. The trip involved a stay at the Renaissance Center — just a quick People Mover ride from the show. IÂ’d been visiting Detroit in January for nearly a decade, and not once had I set foot inside General MotorsÂ’ glass-sided headquarters. I was intrigued, to say the least. Thinking back on my time in the buildings that GM will leave behind when it departs for the new Hudson's site on Woodward Avenue, two things struck me. For one, its hotel rooms are cold in January. Sure, itÂ’s glass towers designed in the 1960s and '70s; I calibrated my expectations accordingly. But when I could only barely see out of the place for all the ice forming on the inside of the glass, it drove home just how flawed this iconic structure is.  My second and more pertinent observation was that the RenCen doesnÂ’t really feel like itÂ’s in a city at all, much less one as populous as Detroit. The complex is effectively severed from its surroundings by swirling ribbons of both river and asphalt. To the west sits the Windsor tunnel entrance; to the east, parking lots for nearly as far as the eye can see. To its north is the massive Jefferson Avenue and to its south, the Detroit River. You get the sense that if Henry Ford II and his team of investors had gotten their way, the whole thing would have been built offshore with the swirling channel doubling as a moat. This isnÂ’t a building the draws the city in; itÂ’s one designed to keep it out. Frost on the inside of the RenCen hotel glass. Contrasted with the new Hudson's project GM intends to move into, a mixed-use anchor with residential, office, retail and entertainment offerings smack-dab in Detroit's most vibrant district, the RenCen is a symbol of an era when each office in DetroitÂ’s downtown was an island in a rising sea of dilapidation. Back then, those who fortified against the rapid erosion of DetroitÂ’s urban bedrock stood the best chance of surviving. This was the era that brought us ugly skyways and eventually the People Mover — anything to help suburban commuters keep their metaphorical feet dry. The RenCen offered — and still offers — virtually any necessity and plenty of nice-to-haves, all accessible without ever venturing outside, especially in the winter, but those enticements are geared to those who trek in from suburbia to toil in its hallways.

A Chevy Camaro hybrid? That's what EcoCAR3 could bring

Figuring out a way for a hybrid powertrain to co-exist with the performance expectations of a classic American muscle car is a challenge that could vex that most experienced of automotive engineers. It's a challenge, in fact, being handed to a bunch of college students. Over the next four years, students from 16 North American colleges and universities will attempt to wring fuel efficiency from a 2016 Chevy Camaro as part of EcoCAR3, an advanced-vehicle technology competition sponsored by the Department of Energy, General Motors and others. They'll be attempting to use hybrid or plug-in hybrid technology while not sacrificing the performance of the Camaro, which was selected in part because the current model achieves just 17 miles per gallon in city driving and 28 MPGs on the highway, per EPA numbers. Students will get the latest version of the vehicle to work on, one that is expected to be unveiled next month on Belle Isle in Detroit. "If we still want to produce V8 Camaros, we're going to have to look at alternative methods of propulsion," said Al Oppenheiser, the chief engineer on the Camaro. "So the ideas that these college teams come up with could very easily be adapted to a car like the Camaro." Unlike similar competitions that reward fuel efficiency in vehicles, EcoCAR seeks those gains while emphasizing cost and consumer acceptance of these vehicles. The cars shouldn't look like experiments; they should look like everyday vehicles on the road. Previous competitions have allowed the teams to use whatever powertrain they desired. This time, EcoCAR officials designed the competition to concentrate on hybrid, hybrid-electric and diesel options. Competitors won't have the option of using hydrogen fuel cells as they have in the past. Last year, a team from Colorado State built a vehicle that contained both hydrogen and electric power sources. This year's limit is a curious choice, as some automakers such as Toyota have placed heavy bets on fuel cells in recent years. General Motors also runs a fuel-cell program. With the focus on cost and practicality, however, the program officials wanted to narrow the framework of the contest. "We always have some good decisions on what to make within the scope or out of scope," said Jim Kolhoff, global director of software engineering for General Motors.