We Finance!!! 2011 Chevrolet Silverado 2500hd Ls 4x4 Duramax Diesel Texas Auto! on 2040-cars
Webster, Texas, United States
Vehicle Title:Clear
Fuel Type:Diesel
Engine:8
For Sale By:Dealer
Transmission:Automatic
Make: Chevrolet
Model: Silverado 2500
Mileage: 57,013
Disability Equipped: No
Sub Model: 2500 4WD
Doors: 4
Exterior Color: White
Cab Type: Crew Cab
Interior Color: Black
Drivetrain: Four Wheel Drive
Chevrolet Silverado 2500 for Sale
4x4 diesel extended cab short bed topper xnice truck fl(US $15,995.00)
2005 chevy 2500 6.6 duramax diesel allison auto 4x4(US $18,950.00)
2009 chevy k2500hd 6.0l vortec v8 4x4 reg cab pw pl clean(US $13,950.00)
$8000 off msrp!! 2500hd crew cab*4x4*snow plow prep pkg*6.0 v8(US $31,313.00)
Crew cab short bed ( regency ) lifted! rare...(US $29,900.00)
1993 chevy silverado, no reserve
Auto Services in Texas
Youniversal Auto Care & Tire Center ★★★★★
Xtreme Window Tinting & Alarms ★★★★★
Vision Auto`s ★★★★★
Velocity Auto Care LLC ★★★★★
US Auto House ★★★★★
Unique Creations Paint & Body Shop Clinic ★★★★★
Auto blog
Weekly Recap: Autonomous driving goes commercial in Nevada
Sat, May 9 2015Nevada granted Daimler Trucks North America the first license to run an autonomous commercial vehicle on public roads in the United States Tuesday, marking another milestone in the technology's rapid advancement. Gov. Brian Sandoval and Daimler truck chief Wolfgang Bernhard promptly used the license to lap Highway 15 near Las Vegas in a newly revealed Freightliner Inspiration Truck. It was a clear signal that autonomous driving is big-rig reality, though it's still a long way from widespread use. Nevada certified two of Daimler's Freightliner Inspiration Trucks, which use the company's Highway Pilot system with a stereo camera, radar, and lane-keeping collision-prevention features to regulate the brakes and steering. The radar component has a long-range sensor that can cover 820 feet at an 18-degree angle and a shorter-range unit that stretches 230 feet at a 130-degree angle. The Inspiration trucks are based on the existing Freightliner Cascadia Evolution model used on US roads. In addition to the autonomous technologies, it also has futuristic design cues, including blue lighting in the front and a new hood and grille. While there are only two Freightliner Inspiration trucks in existence, Daimler expects to bring the Highway Pilot system into mass-produced big rigs by 2025, in time to capitalize on the market's predicted growth. The German truckmaker predicts the global hauling market will triple by 2050, and the United States will be a key part of that growth. Trucks carry 69.1 percent the nation's domestic freight tonnage and hauled 9.7 billion tons of freight in 2013, according to the American Trucking Association. Daimler expects autonomous driving to augment this growth, and perhaps evolve the role of the truck driver. Still, the company points out autonomous tech is not meant to replace drivers, but to assist them and relieve fatigue and monotony on long hauls. The driver has to stay in control for passing, in city traffic, and when hooking up the trailer. The company said autonomous driving also offers the potential for improved fuel economy – tests showed a five-percent gain – and lower maintenance costs. Daimler also said the technology could reduce congestion on the road. Much of this is attributable to the constant flow of traffic, which is aided by autonomous driving. While the benefits are becoming increasingly apparent, autonomous technology is still met with skepticism.
Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]
Thu, Jan 8 2015With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.
Weekly Recap: Lamborghini to build SUV
Sat, May 30 2015Finally, Lamborghini will build a sport utility vehicle. The Italian supercar maker confirmed this week that it will launch a luxury SUV in 2018. It will be built at Lamborghini's soon-to-expand factory in Sant'Agata Bolognese in Italy, and will double the company's current sales volume. Lamborghini did not announce a name for the vehicle or other details, but noted a concept version, the Urus, was displayed at the Beijing motor show in 2012. It will be sold around the world, but it's expected to be a critical offering in the United States, China, and the Middle East. The automaker projects the SUV will sell about 3,000 units per year, and it will be the third product in Lamborghini's portfolio. It currently sells the Huracan and Aventador supercars. "The introduction of a third model line endorses the stable and sustainable growth of the company and signifies for us the beginning of a new era," Lamborghini chief executive Stephan Winkelmann said in a statement. The project is also a boon for Italy, which will get 500 new jobs in the Emilia Romagna region as Lamborghini's factory will nearly double in size. Ian Fletcher, principal analyst for IHS Automotive, said the SUV will position Lamborghini for future growth. "It could well also bring new customers to the brand [who] may find the dramatic styling of Lamborghini products appealing, but find its typical sports cars restrictive," he said. "If it is a success, the SUV could be a catalyst to Lamborghini broadening its portfolio further." OTHER NEWS & NOTES GM invests in Chevy Camaro factory General Motors is investing $175 million to upgrade its factory in Lansing, MI, to build the 2016 Chevy Camaro. The investment will pay for new tooling and equipment. The improvements include three new paint systems and two new robotic framers. GM will add a second shift at the factory to build the Camaro, resulting in 500 jobs. The automaker had dropped the plant to one shift last year amid slow sales for its products, the Cadillac ATS and CTS. GM is spending $5.4 billion over the next three years to upgrade its US facilities. Last week, GM announced plans to spend $439 million to build a new paint shop for the Chevy Corvette. While the Camaro and Corvette plant improvements are intriguing to enthusiasts, GM also confirmed this week that it is investing $1.2 billion in its Fort Wayne (IN) factory that builds trucks.