2007 Lt Crew 4x4 Satellite Trailer Hitch Lifetime Warranty We Finance 93k Miles on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM's Ultium EV platform finally shows up in Q3 sales numbers

General Motors has heralded its Ultium battery-electric platform as the future of its passenger car and truck lineup, but for the first two years of its existence, its impact on the marketplace has been virtually nonexistent. Well, that finally changed in the third quarter of 2023, and while the cars based on this architecture don't represent anywhere near the volume of GM's broader combustion portfolio, we're reaching a point where Ultium products are finally in view (and in the hands) of real-world shoppers. At this point, five U.S.-market Ultium models are in production: the GMC Hummer EV, Cadillac Lyriq, Chevrolet Blazer & Silverado EV, and BrightDrop Zevo 600. If you're not familiar with that last one, that's OK; it's a commercial product that you likely won't see on the road for some time. Together, these four combined for 4,257 sales in the third quarter alone — up from 2,663 for the entire first half of the year. While that may not seem like a significant uptick when viewed from altitude, the quarter-to-quarter numbers paint a clearer picture.  Let's toss out the stragglers first. The Chevy Blazer EV, and Silverado EV for example, are barely in production. GM delivered 19 Blazers and 18 Silverados in the third quarter and that's the entirety of their production runs so far. Likewise, GM's BrightDrop Zevo 600 delivery van effectively exists apart from the consumer marketplace, so its contribution of just 35 units can be set aside too. That leaves us the two you've heard of: the GMC Hummer EV and Cadillac Lyriq — models with high sticker prices and long reservation queues.  Through the second quarter (remember, we're talking six months here), GMC sold 49 Hummer EVs. No typo. In the three months that made up the third quarter, GM moved 1,167 of them. Not only is that a dramatic improvement over the first half, but it's more Hummers than GMC sold in the entirety of 2022 (854). Lyriq's improvement was less eye-popping on paper, but after moving just 122 total units in 2022 and 2,013 of them in the first half of 2023, Cadillac managed to up that figure to 3,018 units in the third quarter alone.  GM is betting its short-term EV future on the Ultium platform, so these trends need to continue if that's going to be a profitable wager.

"Turbo" Chevrolet Camaro is a 700-HP fantasy car come to life [w/video]

For a concept car built to promote an animated movie about a snail that wants to go racing, this thing ain't half bad. The outsized monster you see before you started life as a Chevrolet Camaro ZL1, and then went through a big-time Hollywood makeover before being positioned on the Chevrolet stand here in Chicago.
This 2013 "Turbo" Camaro Coupe is getting the promotion machine ratcheted up for a new DreamWorks tale by the name of, you guessed it, Turbo. Coming this summer, the movie will follow one snail's quest to become a race driver worthy of making the cut at the Indy 500. Like many DreamWorks vehicles before it, we're guessing that the petrolhead snail will star in a movie that adults (especially racing fans) with have no trouble watching with their kids. Check out the trailer below to see if you agree.
As for the car, we're told that it is "instrumental" in transforming Turbo from snail into racer. Helping the beastly pony car in this mighty task, is an ankle-cracking front splitter matched by a ungodly huge rear wing out back, a COPO hood and a supercharged (yes, supercharged) V8 engine making more than 700 horsepower. 24-inch wheels all the way around - 10-inches wide in front and 15-inches wide in back - should allow the "Turbo" Camaro to hook up with ease, as well.