1950 Chevy Truck on 2040-cars

Auto blog

Drivers buy new $300K McLaren 720S, 2019 Chevy Corvette, and wreck 'em

Two high-powered, high-priced sports cars, wrecked in their infancies. No doubt they were fun while they lasted. In Great Falls, Va., a tony suburb of Washington, D.C., that hugs the Potomac River, someone was out enjoying driving the McLaren 720S they had purchased only the day before on a leafy, two-lane road. Then, horror: In an instant, the car hit a tree, mangled and destroyed "because of speed," according to the Fairfax County Police Department. Purchased Friday. Totaled Saturday. This McLaren 720S, costing around $300,000, was destroyed today in Great Falls because of speed. The driver was taken to the hospital with thankfully only non-life threatening injuries. A reminder to slow down, or it could cost you. pic.twitter.com/XhC3LKRY1t — Fairfax County Police (@FairfaxCountyPD) July 14, 2018 Then on salvage auction site Copart, a brand-new orange 2019 Chevrolet Corvette Grand Sport lies in a warehouse in Lincoln, Neb., its front left corner crushed, wheel askew. It had just 15 miles on the odometer. We know nothing of the backstory, except for the obvious front-end damage and secondary damage to the undercarriage. The rear end and 6.2-liter V8 engine, which makes 460 horsepower and 465 pound-feet of torque, look OK. The most current bid as this was published was just north of $9,000. It's tempting in both cases to assign the blame to over-eager drivers who weren't quite yet able to corral all that power. In the case of the McLaren, the supercar makes 710 horsepower and 568 pound-feet of torque from its quad-cam, twin-turbo 4.0-liter V8. It goes from 0-62 miles per hour in 2.9 seconds and boasts a top speed of 212 mph. We're not saying the unidentified driver was a newbie, but this car is definitely not for newbies. Police write that the incident is "A reminder to slow down, or it could cost you." As in, $300,000. Or at least the depreciation for driving it off the lot. Related Video:

GM exploring ways to raise half-ton Duramax diesel tow rating

Lots of truck owners cheered when GM announced fuel economy numbers for the 2020 Chevrolet Silverado with the 3.0-liter Duramax diesel inline-six. Even after Ram let loose its EPA mileage ratings for the 2020 Ram 1500 EcoDiesel, the Chevy oil-burner still took the trophy. The victory was years in the making, GM engineers spending an entire four-year development cycle refining the LM2 Duramax to increase mileage. The tradeoff, as well all know by now, is towing; the Duramax in half-ton duty pulls a maximum 9,300 pounds in the Silverado. Rivals across town can do more, the Ford F-150 PowerStroke rated at 11,500, the Ram 1500 EcoDiesel game to pull 12,560. GM engineer John Barta told Muscle Cars & Trucks that more hauling chops could be on the way, explaining, "We’re actually looking at upgrading some of the materials around (the engine bay) to see if we can maybe raise our tow rating." Engine bay materials are at issue due to thermal complexities underhood. John Barta, GM's assistant chief engineer of diesel engine controls, said the Duramax's inline-six configuration allowed engineers to get emissions hardware like the combined selective catalytic reduction, diesel oxidation catalysts, and diesel particulate filter unit closer to the engine, where it heats up quicker, getting emissions down quicker. But that filter puts another heat source in those confines, enforcing a cap on the tow rating to keep the engine and other systems from overheating. "If you look under the hood," he said, "youÂ’ll see a significant amount of silver ‘moon tapeÂ’ around to make sure things arenÂ’t getting overheatedÂ… if we were to go up in higher towing, which we can, we start impacting the possibility of deteriorating some of the components.” There isn't much space for more grille, so swapping for a better grade of "moon tape" or a different kind of material could reduce engine bay heat, extracting a higher tow rating in the process.  It's important to note a point Barta's been making for months about the Duramax figures, though. "Even though itÂ’s nice to brag about big numbers, in reality, light duty customers are not towing that large with their trucks," and, "We do know that (95 percent) of our light duty customers donÂ’t tow over 9,000 pounds." On our First Drive of the 2020 Silverado diesel we called out the tow rating, but emphasized that the Chevy and GMC have more important challenges to overcome.

GM, UAW poaching Nissan workers in Tennessee

General Motors and the United Auto Workers are going on a recruitment drive at the Spring Hill factory in Tennessee, and they're hoping to poach some skilled workers from Nissan's nearby plant in Smyrna, TN. The General and the union even bought a billboard advertising for industrial electricians near the Japanese automaker's facility, according to the Daily News Journal. The reason for the billboard was simple. "GM was short of electricians," said Tim Stannard, the president of the UAW local at Spring Hill, to the Daily News Journal. The factory currently builds the Chevrolet Equinox but has a contract to assemble the next generation of Ecotec engines and the Cadillac XT5, which replaces the SRX. Thanks to the $185-million deal, employment there is expected to double by May 2016, according to Stannard, with roughly 1,800 additional union jobs. Beyond just several billboards, GM has job postings online for the Spring Hill plant looking for workers with specific skills. There has already been some interest in the positions among Nissan employees, Stannard indicated. According to a recent study by the Center for Automotive Research, the average GM worker currently makes $58 an hour, including benefits. Comparatively, Nissan pays an average of $42 an hour with benefits. The General's number could change in the coming weeks because its contract with the UAW is about to expire, and higher wages are among the major negotiating points.