2013 Chevy Malibu Ltz , Absolutely Perfect !!!! on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2017 Chevy Bolt charged up for production

Chevy's decision to call its new electric car the Bolt has stirred controversy and confusion, but regardless, it's well on its way to becoming a production reality. The prototype captured in these shots is heavily camouflaged, but the crossover/hatchback styling cues are still evident. The car also has a tall greenhouse, slight creases in the sides, and a sloping roofline in back. There's a rapidly rising body line that makes for less glass for rear passengers, but that's probably part of the camo. The Bolt is expected to arrive for 2017 and will be sold in all 50 states. The Chevy Bolt carries the promise of bringing EV technology to a broader audience. Chevy said the car will cost about $30,000 after possible tax incentives and could have a range of 200 miles. It will be assembled at General Motors' Orion Assembly factory north of Detroit. The Bolt will augment the plug-in hybrid Volt in Chevy's green fleet, and it will compete against vehicles like the BMW i3 and Nissan Leaf. Related Video:

Chevy Silverado gets star-studded treatment at SEMA

Chevrolet has quite a presence ready for the 2015 SEMA Show, including custom takes on the Camaro and Spark. As one of the company's most popular models, the Silverado isn't left out of the fun, either, thanks to a trio of concepts to highlight what's possible for the aftermarket event. Camouflage is supposed to blend in, but the naval-inspired, Razzle Dazzle design on the Silverado Special Ops Concept should make the truck pop under the lights at the Las Vegas Convention Center. Based on a Silverado 1500 Z71, the pickup is conceived as a "rescue vehicle special-operations forces." To get behind enemy lines, it packs extra LED lighting, wheel flares for off-road tires, and a GearOn utility rack in the bed. Plus to help get away, Chevy Performance fits an air intake, exhaust kit, and concept six-piston brakes. The Silverado Realtree Bone Collector Concept (above) also wears camo for SEMA, but it's for enjoying the outdoors rather than getting out of battle. Camouflage company Realtree and The Bone Collector host Michael Waddell help with the design for this custom truck that features 22-inch black wheels, a front push bar, LED light bar, and assist steps all from Chevy Accessories. With leather upholstery, Apple CarPlay, and Android Auto inside, the drive to and from the woods should be comfortable, as well. The Silverado 3500HD Kid Rock Concept rounds out this trio and features patriotic styling from the eponymous rock star. "I wanted the design for the truck to be bold, but with features and elements that wouldn't be out of reach for working-class guys," he said about the design, and Kid Rock even visited the factory in Flint, MI, to meet members from UAW Local 598 for some inspiration. The result features a custom chrome grille with a Born Free logo and chrome exhaust stacks. For added excitement, two Gibbs Sports Quadskis are hooked up on the trailer behind it. Related Video: Chevrolet Introduces Silverado Special Ops Concept Military-inspired truck reinforces capability with go-anywhere style LAS VEGAS – Chevrolet's 2016 Silverado Special Ops concept imagines a unique rescue vehicle for special-operations forces. It is based on the Silverado 1500 Z71, which features a new front-end design and new technologies built into its strong, high-strength steel body structure and fully boxed frame, and draws its design inspiration from naval design aesthetics.