2012 Chevrolet Malibu 2lt on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls Cadillac ATS and Chevy Impala for separate issues

The National Highway Traffic Safety Administration added two recalls from General Motors in the government organization's daily update of safety campaigns. Both were for failing to meet Federal Motor Vehicle Safety Standards but for completely separate reasons. The larger recall covers 58,698 units of the 2013-2015 Cadillac ATS, but it doesn't really carry huge safety concerns. In vehicles produced between April 25, 2012, and February 9, 2015, the controls for the tilt and slide of the moonroof are not recessed enough, as required by federal law. According to NHTSA, it's possible that someone could inadvertently activate the auto-close for the roof panel, which the agency claims increases "the risk of personal injury." Dealers will install a new trim plate that will add the necessary clearance. The other campaign covers 1,177 examples of the 2014 Chevrolet Impala from between November 15, 2012, and May 27, 2014. However, this is actually a repeat of a previous recall on the Chevy and the Cadillac XTS from 2014. The affected Impalas here "were remedied incorrectly" under the earlier campaign, according to NHTSA. On these sedans, it's possible the electronic parking brake might not fully disengage and still remain in some contact with the rotor, which is in violation of federal rules. The fault can cause excessive heat from the brakes that could potentially lead to a fire, according to NHTSA. To fix the problem, dealers will reprogram the electronic parking brake control module. Show full PR text RECALL Subject : Inadvertent Press of Roof Panel Switch/FMVSS 118 Report Receipt Date: FEB 24, 2015 NHTSA Campaign Number: 15V106000 Component(s): VISIBILITY Potential Number of Units Affected: 58,698 All Products Associated with this Recall Vehicle Make Model Model Year(s) CADILLAC ATS 2013-2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2013-2015 Cadillac ATS vehicles manufactured April 25, 2012, to February 9, 2015. In the affected vehicles, the power-operated roof panels auto-close when the non-recessed "Slide" or "Tilt" switches are pressed. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standards (FMVSS) No.

2021 GMC Canyon trims overhauled, SL and SLT disappear

Until this year, the GMC Canyon has offered six trims in two drivetrains: SL, a base model simply called Canyon, SLE, All Terrain, SLT, and Denali, with all but the SL available in either 2WD or 4WD. GM Authority credits "dealer sources" for news that the 2021 Canyon has had its trim steps overhauled. According to the chart in the report, the SL and SLT are no more, the base Canyon gets replaced by a trim called Elevation Standard, and SLE turns into Elevation. We already know that All Terrain has given way to AT4, while Denali remains in the top spot. Trim content doesn't change with the names, but there's no equivalent for the SLT trim in terms of spec. The GMC site lists the 2020 SLE and SLT on the same page, and a shopper must burrow into the spec comparison page to figure out the differences. The SLT only comes with the 3.6-liter V6 and eight-speed transmission, and makes features like remote start, climate control, heated mirrors, heated seats, hitch guidance, and a spare tire standard equipment. It also chromes the exterior door handles, and offers a Cocoa/Dune leather interior that can't be had on the SLE. It's possible the SLT's $4,700 premium over the SLE led more buyers to start with the SLE and add the engine and options they wanted.   We have a number of questions that we'll need to wait for GMC's official announcement to answer. The 2020 Canyon offers an Elevation Edition package for $650 that adds a black grille with body-colored surround, and 18-inch Satin Graphite wheels in all-terrain rubber. There's also a California Elevation Special Edition for $1,195 with all-weather floor liners, assist steps, and mud flaps. They could be optioned on the SLE but not the SLT. With the addition of two Elevation trims, we'll find out if the packages get renamed or go away. Separately, CarBuzz spotted a 2021 GM Fleet Order Guide that mentions a leveling kit option, LPO Code SQS, for the Canyon and the Chevrolet Colorado. We noted the inclusion of a leveling kit in the coming Canyon AT4 Off-Road Performance Package. According to the order guide, the option can be ordered only for the Canyon AT4 trim, but it's not clear if that's an a la carte choice or if buyers must order the Off-Road Performance Package. On the Chevy, the rake-removal equipment can be had with the Colorado 4x2 Z71 or the 4x4 Work Truck, LT, and Z71. Related Video: