1980 Malibu Classic 305 V8 on 2040-cars

Auto blog

2020 Chevrolet Tahoe, Suburban and GMC Yukon all spied with production lights

One of our spy photographers just caught a smattering of full-size GM SUVs out testing, including the Chevrolet Tahoe, Suburban and GMC Yukon. Previous spy photos of the next-generation of these big GM SUVs have revealed that GM is going with an independent rear suspension design, and these shots confirm the news once again with our best look at the hardware yet. Check them out from the rear, lined up like ducks in a row to see the beefy control arms down there. This will undoubtedly give the big SUVs a more compliant ride, and should bring it back into touch with the refinement from the Ford Expedition and Lincoln Navigator. The new bits we get to see with these shots are production headlights and taillights that are shaping up to look pretty neat. Most distinguishable are the GMC Yukon's LED DRLs. These look a lot like the C-shaped LEDs outlining the headlights on the Sierra, but they have an extra LED strip on top of the C. The parts of the taillights that we can see look significantly different than that found on the Sierra, showing GM is planning on having a great deal of differentiation there. We can sort of see through the mesh covering the grille to what appears to be a classic horizontal bar style front opening. Chevy is predictably dialing the crazy LED strip design back for the Tahoe and Suburban. The parts that are lit up look a whole lot like the headlight fixtures on the 2019 Silverado. That truck uses a stack of lights with the actual headlights separated from the DRLs. We can see the same thing going on here, with the headlight up top and curved LED DRL strip sitting below. It's tough to say if the designs are exactly alike, but we expect to see an extremely Silverado-esque look once all the camouflage comes off. Chevrolet's taillight design differs from its donor truck like the GMC, showing off a curved, vertical series of LEDs out back. Once production lights start popping up like this, we know the vehicle is moving closer to its end game. A reveal sometime later this year could be in the cards for GM's next batch of full-size SUVs. It certainly needs them quick, as Ford rockets ahead with increased Expedition production announced earlier this week.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

GM recalls Colorado, Canyon, and Malibu for airbag problem

The Basics: General Motors will recall and issue a stop sale on 1,740 total examples of the 2016 Chevrolet Colorado, Malibu, and GMC Canyon. This includes 1,579 units in the US and 161 in Canada. The Problem: The second stage of the driver front airbag inflator might not be present. If this happens, the airbag won't fill as quickly as it should in a high-speed crash, which could increase the risk of injury, according to Reuters. This is not related in any way to Takata's inflator problems, and these parts come from a different supplier. Injuries/Deaths: None reported. The Fix: GM will replace the vehicles' airbag assemblies. If You Own One: GM spokesperson Tom Wilkinson told Autoblog he wasn't specifically sure when recall repairs would begin but said it would be "shortly." He expects the fixes to happen "quickly" because of the small number of affected vehicles, and many of them are either in transport or already in dealer stock. More Information: GM recalled the 2015 Canyon and Colorado in 2014 for a completely separate airbag issue. In that case, a manufacturing error improperly wired the connectors. Related Video: GM Statement GM is recalling 1,579 MY 2016 Chevrolet Colorado, GMC Canyon and Chevrolet Malibu vehicles in the United States and 161 in Canada to replace driver-side front airbags. The second stage of the airbag may not deploy properly in certain high-speed crashes. During a routine quality inspection, it was determined that a component required for a second-stage/high-output deployment was not loaded during the inflator build. Dealers will replace the driver-side front airbag assembly. There have been no reports of crashes or injuries related to this issue. This issue is unrelated to the ongoing Takata recalls.