2013 Chevrolet Impala Ltz on 2040-cars

Auto blog

Chevy recalls 73k Cobalts for side airbag non-deployment

Chevrolet is recalling 73,424 examples of the 2010 Cobalt in the US and Canada because the driver's side curtain airbag might not deploy in a crash. These vehicles carry build dates between January 4 and June 23, 2010, and, specifically, 59,474 of them are in the US. "GM is aware of one crash with one injury that may be related to this condition," the company said in a statement. The problem occurs because of improper routing of the side-impact sensor wiring harness in the driver's door, and there can be a short circuit causing the curtain airbag not to deploy. The campaign to fix the issue will begin on August 26. Dealers will inspect the vehicles and will repair the issue on any affected examples. Related Video: GM Statement: General Motors is recalling 59,474 2010 Chevrolet Cobalt sedans in the U.S. because some of them may have been built with improper side impact sensor wire routing in the left front door. Dealers will inspect all suspect vehicles and any found with the condition will be repaired free of charge to the customer. GM is aware of one crash with one injury that may be related to this condition. Including vehicles sold in Canada, the total recall population is 73,424. RECALL Subject : Improperly Routed Side Impact Wire Harness Report Receipt Date: AUG 10, 2015 NHTSA Campaign Number: 15V500000 Component(s): AIR BAGS Potential Number of Units Affected: 59,474 All Products Associated with this Recall Vehicle Make Model Model Year(s) CHEVROLET COBALT 2010 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2010 Chevrolet Cobalt vehicles manufactured January 4, 2010, to June 23, 2010. The affected vehicles may be equipped with an improperly routed Side-Impact Sensor (SIS) wiring harness in the driver side front door. The misrouted wiring harness could cause an electrical short that disables the driver side curtain air bag. CONSEQUENCE: A disabled driver side roof-rail air bag will not deploy in the event of a crash necessitating deployment of that air bag, increasing the risk of injury to the driver. REMEDY: GM will notify owners, and dealers will inspect the sensor's wiring in the driver's door and make repairs as necessary, free of charge. The recall is expected to begin August 26, 2015. Owners may contact Chevrolet customer service at 1-800-222-1020. GM's number for this recall is 15075.

GM patent reveals new two-stage turbocharger

Modern turbochargers may be some of the best ever made, but performance is something that engineers are always trying to improve. According to GM Inside News, General Motors (GM) is hoping to alleviate some of the negative aspects of a two-stage turbocharger setup with a newly-patented design. The patent, that was filed on May 19, 2016, reveals a clever bypass system that allows the engine, a four-cylinder unit, to optimize both the low-pressure and high-pressure inlets for its respective functions. According to the filing, a conventional two-stage turbocharger setup is engineered to allow both turbines to operate simultaneously at low and mid engine speeds. At high engine speeds, only the low-pressure turbine works. The setup can't isolate either the low or high pressure side, which can impair low-end performance. GM's new two-stage turbocharger setup looks to eliminate this by linking the high-pressure turbo to the exhaust manifold through the high-pressure inlet duct. The low-pressure turbo is attached to the high-pressure turbo by a low-pressure inlet duct, which is linked to a connecting channel. A single actuator that is housed in the exhaust manifold creates a bypass that can opens the high-pressure inlet or close the connecting channel. Depending on what the engine load and speed is, the ECU guides the actuator—a single rotating spindle with discs corresponding to flanges on the high and low pressure sides—to isolate one of the two turbos. Isolating the turbos allow the respective inlets to be engineered for the best possible fluid dynamic performance. The setup should increase performance and decrease lag. There's no word on what car this setup will make an appearance on, but it will most likely be used in premium vehicles before trickling down to the rest of GM's vehicles. Related Video: News Source: GM Inside News, AutoGuide via GM Authority Cadillac Chevrolet GM Technology Sedan turbo patent engine turbocharging

GM's Reuss predicts 2016 Chevy Camaro will outperform Ford Mustang in every way

We aren't going to be seeing the next-generation Chevrolet Camaro until next month. But even though we know when we're going to see the new muscle car, it's totally unclear whether Chevy will dole out technical details. That means we can't answer the latest version of the age-old question: Camaro or Ford Mustang? Not surprisingly, General Motors North America President Mark Reuss has already stated his position, saying he was "very confident" that the sixth-generation Camaro will be faster, more agile and more efficient than the Ford. Reuss made his comments after saying he drove the new Camaro back-to-back with the Mustang the week prior. Reuss' statement came in a conversation with Fox News about the 2016 Camaro where he elaborated on the car's weight shedding and how it fit into GM's strategy on other new models. "There are some really cool things in the Camaro, that are quite different than the Malibu, [and] CT6," Reuss told Fox. As we reported previously, the Camaro will shed some 200 pounds by switching to aluminum and other lightweight composites for some of its components. With May 16 just over a month away, here's hoping Reuss decides to loose some other details on the next Camaro ahead of its debut. Related Video: