2005 Chevy Colorado Z71 4 X 4 With Rancho Suspension And 2 Inch Lift Kit. on 2040-cars

Auto blog

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Drivers buy new $300K McLaren 720S, 2019 Chevy Corvette, and wreck 'em

Two high-powered, high-priced sports cars, wrecked in their infancies. No doubt they were fun while they lasted. In Great Falls, Va., a tony suburb of Washington, D.C., that hugs the Potomac River, someone was out enjoying driving the McLaren 720S they had purchased only the day before on a leafy, two-lane road. Then, horror: In an instant, the car hit a tree, mangled and destroyed "because of speed," according to the Fairfax County Police Department. Purchased Friday. Totaled Saturday. This McLaren 720S, costing around $300,000, was destroyed today in Great Falls because of speed. The driver was taken to the hospital with thankfully only non-life threatening injuries. A reminder to slow down, or it could cost you. pic.twitter.com/XhC3LKRY1t — Fairfax County Police (@FairfaxCountyPD) July 14, 2018 Then on salvage auction site Copart, a brand-new orange 2019 Chevrolet Corvette Grand Sport lies in a warehouse in Lincoln, Neb., its front left corner crushed, wheel askew. It had just 15 miles on the odometer. We know nothing of the backstory, except for the obvious front-end damage and secondary damage to the undercarriage. The rear end and 6.2-liter V8 engine, which makes 460 horsepower and 465 pound-feet of torque, look OK. The most current bid as this was published was just north of $9,000. It's tempting in both cases to assign the blame to over-eager drivers who weren't quite yet able to corral all that power. In the case of the McLaren, the supercar makes 710 horsepower and 568 pound-feet of torque from its quad-cam, twin-turbo 4.0-liter V8. It goes from 0-62 miles per hour in 2.9 seconds and boasts a top speed of 212 mph. We're not saying the unidentified driver was a newbie, but this car is definitely not for newbies. Police write that the incident is "A reminder to slow down, or it could cost you." As in, $300,000. Or at least the depreciation for driving it off the lot. Related Video:

Millionth Corvette now being restored after sinkhole damage

Among the original American sports cars that were damaged by the sinkhole at the National Corvette Museum over a year ago was a 1992 convertible that was the millionth Vette made. And now that milestone vehicle is starting its restoration process. The landmark Corvette's rehabilitation is being carried out by the GM Design Center in Warren, MI, by a team of skilled craftsmen and technicians. The crew is more accustomed to building prototypes and concepts, but will face a new challenge in bringing this millionth Corvette back to its original condition. The white-over-red convertible was one of eight Corvettes that were swallowed up by the sinkhole at the museum in Bowling Green early in the morning on February 12, 2014. Five will be preserved in their compromised condition as part of a display demonstrating the effects of the sinkhole, while the remaining three were earmarked for restoration. The Design Center team has already completely the restoration of the 2009 Corvette ZR1 "Blue Devil" prototype, while the remaining 1962 Corvette will be restored by the museum. Related Video: Sinkhole-Swallowed 1 Millionth Corvette Restoration Underway Milestone damaged when earth opened beneath National Corvette Museum 2015-06-10 WARREN, Mich. – Craftspeople and technicians at the General Motors Design Center are painstakingly restoring the historic 1 millionth Chevrolet Corvette damaged nearly 16 months ago when a sinkhole opened beneath the National Corvette Museum in Bowling Green, Ky. The restoration crew is part of GM's Mechanical Assembly group at the Design Center, which typically spends its time building prototype and concept vehicles. The white 1992 Corvette is a challenge because rather than build an all-new vehicle from the ground up, the workers are trying to preserve the original appearance of a production vehicle. It is the second of three sinkhole-damaged Corvettes that Chevrolet has pledged to restore. The first, a 2009 Corvette ZR1 prototype known as the Blue Devil, was only lightly damaged and was returned to its original condition last fall. The National Corvette Museum will oversee the restoration of the third car, a 1962 Corvette. Five other Corvettes swallowed by the sinkhole will remain in their as-recovered state to preserve the historical significance of the cars. They will become part of a future sinkhole-themed display at the museum. Sinkhole summary On Wednesday, Feb.