Stunning 1967 Chevelle 300 Deluxe Very Rare Options 396 Big Block Factory Disc!! on 2040-cars

Auto blog

Motor Trend puts Chevy Camaro Z28 and Porsche 911 GT3 Head 2 Head

Motor Trend admits, "This is an unfair comparison." But that doesn't make it any less fun to watch when they pit a Camaro Z/28 against the Porsche 911 GT3. The former has a 7.0-liter V8 with 505 horsepower and 481 pound-feet of torque shifted through a six-speed manual. The latter has a 3.8-liter flat-six with 475 hp and 324 lb-ft shifted through a seven-speed dual-clutch transmission. Yet those are only the little disparities – the big disparities are mass and money: the Camaro weighs 3,882 pounds and costs $76,150 as-tested, the Porsche weighs 3,267 pounds and costs $145,785. But they're both about hardcore performance, so MT takes them out on the street, to the drag strip, to the parking lot for figure eights and a skidpad test, and finally to Big Willow for Randy Pobst to give his professional assessment. Remember when a lotta people spent a lotta time debating Pirates vs. Ninjas? This is like that, only it's the "haul-ass good-time car" vs. the "track surgeon." Enjoy the debate in the video.

Chevy recalls 73k Cobalts for side airbag non-deployment

Chevrolet is recalling 73,424 examples of the 2010 Cobalt in the US and Canada because the driver's side curtain airbag might not deploy in a crash. These vehicles carry build dates between January 4 and June 23, 2010, and, specifically, 59,474 of them are in the US. "GM is aware of one crash with one injury that may be related to this condition," the company said in a statement. The problem occurs because of improper routing of the side-impact sensor wiring harness in the driver's door, and there can be a short circuit causing the curtain airbag not to deploy. The campaign to fix the issue will begin on August 26. Dealers will inspect the vehicles and will repair the issue on any affected examples. Related Video: GM Statement: General Motors is recalling 59,474 2010 Chevrolet Cobalt sedans in the U.S. because some of them may have been built with improper side impact sensor wire routing in the left front door. Dealers will inspect all suspect vehicles and any found with the condition will be repaired free of charge to the customer. GM is aware of one crash with one injury that may be related to this condition. Including vehicles sold in Canada, the total recall population is 73,424. RECALL Subject : Improperly Routed Side Impact Wire Harness Report Receipt Date: AUG 10, 2015 NHTSA Campaign Number: 15V500000 Component(s): AIR BAGS Potential Number of Units Affected: 59,474 All Products Associated with this Recall Vehicle Make Model Model Year(s) CHEVROLET COBALT 2010 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2010 Chevrolet Cobalt vehicles manufactured January 4, 2010, to June 23, 2010. The affected vehicles may be equipped with an improperly routed Side-Impact Sensor (SIS) wiring harness in the driver side front door. The misrouted wiring harness could cause an electrical short that disables the driver side curtain air bag. CONSEQUENCE: A disabled driver side roof-rail air bag will not deploy in the event of a crash necessitating deployment of that air bag, increasing the risk of injury to the driver. REMEDY: GM will notify owners, and dealers will inspect the sensor's wiring in the driver's door and make repairs as necessary, free of charge. The recall is expected to begin August 26, 2015. Owners may contact Chevrolet customer service at 1-800-222-1020. GM's number for this recall is 15075.

GM won't really kill off the Chevy Volt and Cadillac CT6, will it?

General Motors is apparently considering killing off six slow-selling models by 2020, according to Reuters. But is that really likely? The news is mentioned in a story where UAW president Dennis Williams notes that slumping US car sales could threaten jobs at low-volume factories. Still, we're skeptical that GM is really serious about killing those cars. Reuters specifically calls out the Buick LaCrosse, Cadillac CT6, Cadillac XTS, Chevrolet Impala, Chevrolet Sonic, and the Chevrolet Volt. Most of these have been redesigned or refreshed within the past few model years. Four - the LaCrosse, Impala, CT6, and Volt - are built in the Hamtramck factory in Detroit. That plant has made only 35,000 cars this year - down 32 percent from 2016. A typical GM plant builds 200,000-300,000 vehicles a year. Of all the cars Williams listed, killing the XTS, Impala, and Sonic make the most sense. They're older and don't sell particularly well. On the other hand, axing the other three seems like an odd move. It would leave Buick and Cadillac without flagship sedans, at least until the rumored Cadillac CT8 arrives. The CT6 was a big investment for GM and backing out after just a few years would be a huge loss. It also uses GM's latest and best materials and technology, making us even more skeptical. The Volt is a hugely important car for Chevrolet, and supplementing it with a crossover makes more sense than replacing it with one. Offering one model with a range of powertrain variants like the Hyundai Ioniq and Toyota Prius might be another route GM could take. All six of these vehicles are sedans, Yes, crossover sales are booming, but there's still a huge market for cars. Backing away from these would be essentially giving up sales to competitors from around the globe. The UAW might simply be publicly pushing GM to move crossover production to Hamtramck to avoid closing the plant and laying off workers. Sales of passenger cars are down across both GM and the industry. Consolidating production in other plants and closing Hamtramck rather than having a single facility focus on sedans might make more sense from a business perspective. GM is also trying to reduce its unsold inventory, meaning current production may be slowed or halted while current cars move into customer hands. There's a lot of politics that goes into building a car. GM wants to do what makes the most sense from a business perspective, while the UAW doesn't workers to lose their jobs when a factory closes.