66 Chevelle on 2040-cars

Auto blog

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

Pony cars, trucks and Italian SUVs | Autoblog Podcast #552

On this week's Autoblog Podcast, Editor-in-Chief Greg Migliore is joined by Senior Editor Alex Kierstein and Associate Editor Reese Counts. We discuss the updated 2019 Chevy Camaro Turbo 1LE variant, the new 2019 GMC Sierra Denali, and the Ferrari-powered Maserati Levante GTS. We also debate whether Volkswagen should build the Atlas-based Tanoak pickup truck and what a delay means for the next-gen Ford Mustang. Finally, we answer a reader question about the state of Lexus.Autoblog Podcast #552 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Rundown 2019 Chevy Camaro Turbo 1LE 2019 GMC Sierra 2019 Maserati Levante GTS Should Volkswagen build the Tanoak? Next-gen Ford Mustang delayed The past, present and future of Lexus Feedback Email – Podcast@Autoblog.com Review the show on iTunes Related Video: Podcasts Chevrolet Ford GM GMC Lexus Maserati RAM Truck Coupe SUV Luxury Performance

GM opens official investigation into C8 Corvette transmission leaks

In March 2020, a month after Chevrolet began customer deliveries of the 2020 C8 Corvette, a GM dealer technician created a Reddit thread about a leaking gearbox in a Corvette with 32 miles. That car hadn't even been sold yet. Since then, as a search of "C8 Corvette transmission leak" shows, it's been tales of woe for some owners. Something in the Tremec TR-9080 transaxle in the back of the mid-engined Corvette doesn't work as it should, the fault able to cause codes that the transmission needs service, or that the driver needs to shift to park. In some cases, the battery would die because of follow-on issues after the initial transmission code, that code preventing the car from powering down. As Autoevolution reports, GM filed paperwork with the National Highway Traffic Safety Administration in August to look into what's going on. Between forum threads and GM's investigation document, there are several issues mentioned. The most common appears to be the dual-clutch transmission leaking fluid due to gasket failures like the one suffered by one owner at 858 miles, and another for an owner currently enduring a second leaking transmission. The Midengined Corvette Forum reported that Chevy engineers redesigned the TR-9080 pan, fitting Corvettes with the new unit at some point in the 2021 model year. The original pan was stamped steel unit affixed to the engine with two studs and 13 bolts, plus "reinforcement plates." The updated pan is said to be a cast aluminum unit affixed with two studs and 17 bolts, omits the reinforcement plates, and gets a new machined new groove around its edge to seat the gasket seal. The GM paperwork now at the NHTSA mentions a P1789 code, and says one reason for it could be "debris on the park position sensor magnet causing an incorrect position reading to the TCM." This might be caused by another issue mentioned in forums, which is clogged transmission filters. GM gives instructions for returning transmission filters to the company, and a poster on one forum said the Corvette tech at the dealer where he bought his Corvette told him the automaker "requires every used transmission filter to be returned to GM."  Whatever's going on, the problems haven't stopped, and they go beyond the P1789 code. Over the weekend, a 2022 Corvette owner posted on Corvette Forums that he got a check engine light on his car after just 850 miles.