on 2040-cars

Auto blog

Cruze Diesel Road Trip reveals the good and bad, but no ugly

Most of us have strong opinions on diesel-powered cars based on our perceptions of and experience with them. I used to thoroughly dislike oil burners for their noise, smoke and lackluster performance, and the fact that they ran on greasy, smelly stuff that was more expensive than gasoline, could be hard to find and was nasty to get on your hands when refueling. Those negatives, for me, trumped diesel's major positives of big torque for strong acceleration and better fuel economy. Are any of those knocks on diesel still valid today? I'm not talking semis, which continue to annoy me when their operators for some reason almost never shut them down. At any busy truck stop, the air seems always filled with the sound – and sometimes smell – of dozens of big-rig diesels idling endlessly and mindlessly. Or diesel heavy-duty pickups. Those muscular workhorses are far more refined than they once were and burn much less fuel than their gasoline counterparts. But good luck arriving home late at night, or departing early morning, without waking your housemates and neighbors with their clattery racket. No, I'm talking diesel-powered passenger cars, which account for more than half the market in Europe (diesel fuel is cheaper there) yet still barely bump the sales charts in North America. Diesel fuel remains more expensive here, too few stations carry it, and too many Americans remember when diesel cars were noisy, smelly slugs. Also, US emissions requirements make them substantially more expensive to certify, and therefore to buy. But put aside (if you can) higher vehicle purchase and fuel prices, and today's diesel cars can be delightful to drive while delivering much better fuel efficiency than gas-powered versions. So far in the US, all except Chevrolet's compact Cruze Diesel come from German brands, and all are amazingly quiet, visually clean (no smoke) and can be torquey-fun to drive. When a GM Powertrain engineering team set out to modify a tried-and-true GM of Europe turbodiesel four for North American Chevy Cruze compacts, says assistant chief engineer Mike Siegrist, it had a clear target in mind: the Volkswagen Jetta TDI 2.0-liter diesel. And they'll tell you that they beat it in nearly every way. "I believe we have a superior product," he says. "It's powerful, efficient and clean, and it will change perceptions of what a diesel car can be." The 2.0L Cruze turbodiesel pumps out 151 SAE certified horses and 264 pound-feet of torque (at just 2,000 rpm) vs.

2016 Chevrolet Camaro First Drive [w/video]

The Autoblog gang was downright stoked to learn the 2016 Chevy Camaro was next on our test-car docket. Then we found out it was the V6 model. Buzzkill. We were hoping for the snorting V8, or at least the spunky new turbo four-cylinder. The V6? Meh. We've been driving V6 Camaros for, like, six years. It's what you buy if you can't afford anything better, or so say horsepower snobs as they wrinkle their noses and cut their coffee with 93 octane. But after a week with the six-pot Camaro, we'll admit it: we were wrong. The all-new 3.6-liter V6 is strong, sounds good, and is damn fun to drive. Its 335 horsepower and 284 pound-feet of torque appear modest by modern standards, but they power the Camaro to 60 miles per hour in 5.1 seconds with the automatic, or in the case of our manual-equipped test car, 5.2 seconds. That's almost half a second quicker than the new turbo four-cylinder model. Yes, it has the same displacement as the old V6. No, it's not the same engine. Upon closer inspection, the V6's potency shouldn't come as a surprise. This engine is from General Motors' newest family of dual-overhead cam powerplants that launched in the Cadillac CTS and ATS. Yes, it has the same displacement as the old V6. No, it's not the same engine. Don't be fooled, and don't underestimate it at stoplights. The strapping V6 is unsuspectingly good, but it's just one of many improvements for the sixth-generation Camaro. Chevy's coupe is lighter, faster, and more modern looking inside and out. It starts with a rear-wheel-drive chassis donated from the Cadillac ATS, though about 70 percent of the components are unique to the Camaro. The 2016 model is about two inches shorter in length (thanks to a shorter wheelbase) and about an inch has been removed from height and width compared to the 2015 model. These lighter underpinnings jumpstarted the Camaro's weight-loss plan, and thanks to extensive use of aluminum, the V6 with the new eight-speed automatic transmission weighs 3,435 pounds – 294 less than its predecessor (the manual-transmission V6 Camaro weighs 3,448 pounds). The V8, meanwhile, sheds 223 pounds. One by one, these elements would merely enhance how the Camaro drives, but taken collectively, they invigorate the new model. It feels much more confident and agile in all circumstances. Put simply, it's a sportier car. View 32 Photos Grab second, let the revs build, and the dual-mode exhaust changes its tune from a low buzz to a rumble, then a growl.

GM, UAW poaching Nissan workers in Tennessee

General Motors and the United Auto Workers are going on a recruitment drive at the Spring Hill factory in Tennessee, and they're hoping to poach some skilled workers from Nissan's nearby plant in Smyrna, TN. The General and the union even bought a billboard advertising for industrial electricians near the Japanese automaker's facility, according to the Daily News Journal. The reason for the billboard was simple. "GM was short of electricians," said Tim Stannard, the president of the UAW local at Spring Hill, to the Daily News Journal. The factory currently builds the Chevrolet Equinox but has a contract to assemble the next generation of Ecotec engines and the Cadillac XT5, which replaces the SRX. Thanks to the $185-million deal, employment there is expected to double by May 2016, according to Stannard, with roughly 1,800 additional union jobs. Beyond just several billboards, GM has job postings online for the Spring Hill plant looking for workers with specific skills. There has already been some interest in the positions among Nissan employees, Stannard indicated. According to a recent study by the Center for Automotive Research, the average GM worker currently makes $58 an hour, including benefits. Comparatively, Nissan pays an average of $42 an hour with benefits. The General's number could change in the coming weeks because its contract with the UAW is about to expire, and higher wages are among the major negotiating points.