Find or Sell Used Cars, Trucks, and SUVs in USA

Chevrolet Camaro Ss on 2040-cars

Year:1967 Mileage:134290 Color: Black /
 Black
Location:

Litchfield, Connecticut, United States

Litchfield, Connecticut, United States
Advertising:
Transmission:Turbo 350
Body Type:Coupe
Engine:350
Vehicle Title:Clear
Fuel Type:Gasoline
VIN: 124377N192736 Year: 1967
Interior Color: Black
Make: Chevrolet
Number of Cylinders: 8
Model: Camaro
Trim: 2 dr coupe SS
Drive Type: RWD
Options: Cassette Player
Mileage: 134,290
Sub Model: SS
Warranty: Vehicle does NOT have an existing warranty
Exterior Color: Black
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

I am selling my 1967 Chevy Camaro SS. The body and interrior are in the same condition as the day I bought the car in 1999. The previous owner did have some restoration work done but exactly what was done I don't know. I can tell that the rear quarter pannels were replaced at some point and the car was repainted.
There are some chips in the paint on the front nose and the passenger door so it could use a new paint job. Also, there is a spot near the antenna where the paint has lifted (probably a little rust below) but the area has never spread since I have owned the car. I have noticed some superficial rust below the trunk floormat but all of the sheet metal is solid. The body and subframe is in good shape considering the age of the car but one or two body mounts may need a little tending to. The fiberglass hood also has a crack in it and the hide-away headlight doors don't work. The interrior is in great shape except the instrument panel has a couple of cracks in it where it screws to the dash board. Note that there are NO aftermarket gauges or tachometers butchered to the dash or held onto the steering column with some plumbing hose clamp. Some of the stitching in the front passenger seat has failed but it could most likely be fixed easily. Also, the speedometer cable broke about a year ago. This car passed inspection when registered in Connecticut with no issue and its condition has not changed or deteriorated since then. I have never driven it in bad weather or in the winter. These are all of the problems with the car that I have noticed. The car otherwise presents itself very well in my opinion. It is a very straight car without dents.
The engine and transmission have been changed and are therefore not original components.

Engine:
350 smallblock with about 11:1 compression ratio, (runs good on 93 octane gas but loves 94 or higher)
Ported and polished heads with triple angle valve job, fairly radical hydraulic lifter cam with 3,500 to about 6,000 rpm powerband (engine idles rough but drives great as a street car)
Intake manifold is a victor jr single plenum, Carburetor is an 830cfm double pumper holley w/anular discharge venturies. Electronic MSD distributor.

Exhaust:
Nothing really special here, your typical dual exhaust system with headers. It does however have a set of gate valves that can be opened under the car to bypass the mufflers but the valves do need new handles.

Transmission:
turbo 350 rebuilt with a shift kit installed. Transmission leaks a small amount of fluid if the car sits (a few drips will appear on the ground from time to time but the leak is so minimal that I never found it to be a priority to fix) A rather expensive Gear Vendor underdrive/overdrive unit is coupled to the transmission tailshaft effectively giving you 6 gears to shift through if desired.

Rearend:
I installed an auburn gear limited slip differential with 3:73 gears in the original rearend housing. When you engage the overdrive unit on the transmission, the car acts as if it has 2:73 gears which is great for the highway.

Brakes:
Aftermarket power front disc brakes with an adjustable proportioning valve for the factory rear drum brakes.

Other:
A 94 amp alternator w/electronic regulator, 3 core radiator, AM FM casette radio

Warantee info:
This automobile is being sold AS IS with no warantee of any kind.

Payment:

If you are the winning bidder I expect you to pay for the vehicle within 7 days of the auction ending or it will be relisted. Payment must be in the form of a certified check. I must receive the check before I will allow you to take possession of the vehicle.

Shipping:

You are responsible to arrange for pick up and shipping of vehicle. The car is at a residential address and is not currently registered. That means your shipper needs to have the ability to pick up the vehicle at a residential address.

 


 

 

 

 

 


  


On Aug-17-13 at 08:37:06 PDT, seller added the following information:

 One thing I forgot to mention, The Camaro won't be available for pickup by the winning bidder until August 29. This is due to a scheduling error on my part. I apologize to the auction winner in advance.

Auto Services in Connecticut

Woodbridge Auto Body Shop Incorporated ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Dent Removal
Address: 36 Lucy St, Derby
Phone: (203) 397-2909

Valenti Autocenter ★★★★★

Auto Repair & Service
Address: 319 Middlesex Tpke, Old-Saybrook
Phone: (203) 481-8299

Talcott Transmissions ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 101 Talcott Rd, West-Hartford
Phone: (860) 233-8259

Sunshine Car Repair ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Inspection Stations & Services
Address: 247 West St, Litchfield
Phone: (860) 567-9490

Shoreline Collision & Rstrtn ★★★★★

Automobile Body Repairing & Painting
Address: 18 Garnet Park Rd, Madison
Phone: (203) 245-9922

Sciaudone`s Garage ★★★★★

Auto Repair & Service, Brake Repair, Automobile Inspection Stations & Services
Address: 28 Leonard St, Norwalk
Phone: (203) 853-0595

Auto blog

NHTSA ends GM steering investigation without seeking a recall

Wed, Jun 8 2022

DETROIT — U.S. safety regulators have closed an investigation into sticky power steering on thousands of older General Motors SUVs and will not seek a recall. The National Highway Traffic Safety Administration says GM in 2014 issued “special coverage” to fix the problem on the Chevrolet Equinox, GMC Terrain and other models. The coverage replaced a steering gear with an improved one. The agency said a recall isn't needed because of the coverage and low complaint and warranty repair rates. The agency opened the probe in June of 2020 into steering problems affecting an estimated 781,000 of the SUVs from the 2010 through 2012 model years. Increased friction could make it feel like the steering wheel is stuck. But GM said the SUVs could still be turned, although with more effort than usual. “In view of the special coverage, low rate of failure and low potential hazard to drivers, this preliminary evaluation is closed,” the agency wrote in documents posted Wednesday on its website. Government/Legal Recalls Chevrolet GMC Safety

2016 Chevy Malibu gets premium looks, hybrid model

Wed, Apr 1 2015

The Chevrolet Malibu was once an automotive icon, but its modern reputation is one for underachievement. A new 2016 model seeks to restore the storied nameplate with improved styling, more interior room and a new hybrid version. It debuts Wednesday at the New York Auto Show. Put simply, "the goal was to put Chevrolet back in the midsize car segment," said John Cafaro, the brand's executive director of car design. In a crowded arena with 2.2 million sales up for grabs annually, Chevy has not been a player. Last year, the brand sold 188,519 Malibus, a six-percent decline from 2013, and fewer than half the number of Toyota Camrys and Honda Accords sold. Despite awards from J.D. Power and Associates and the Insurance Institute for Highway Safety, Chevy knew the Malibu needed a big change. New Skin, Lighter Bones The redesign has been in the works for at least three years. Although the Malibu is still based on GM's Epsilon 2 platform, the underpinnings are more derivative of the Impala than the outgoing model. The body structure makes greater use of high-strength steel, which helps reduce weight by 300 pounds. Size is more Impala-like as well, with 2.3 inches more overall length and a 3.6-inch wheelbase stretch contributing to greater interior space. A new skin covers the Malibu's lighter bones, and design language from the Impala gives its sibling sedan a fresher, more upscale appearance. To execute this premium appearance, Chevy turned to 25-year-old designer Jaymer Starbody, a four-year General Motors veteran and graduate from Detroit's College for Creative Studies. He described the new Malibu as having a "wheel-oriented" design, and the car looks poised to pounce from certain angles. Though the 2016 Malibu is the same width as before, designers stretched the creases and angles in the sheetmetal to create a flatter, sleeker appearance. The hood and cowl are lower, and the Malibu's face sparkles with LED running lamps on the top trim levels. Inside, the roomier cabin has a new center stack, satin chrome accents on the interior panel and a console storage area designed for mobile devices. Chevy MyLink with a seven-inch color touchscreen is standard on lower trims, and the top model upgrades to an eight-inch screen. Perforated leather seats and ambient lighting are also available options. The cabin was designed to look high-tech, but still remain easy to use, according to Chevy interior design director Crystal Windham.

Recharge Wrap-up: GM, LG Chevy Bolt collaboration, Honda Energy Star plants

Wed, Feb 3 2016

Green Car Reports details the relationship between GM and LG in the development and production of the Chevy Bolt. The unique relationship between the two companies began in 2008, and now sees LG producing a multitude of systems for the Bolt, many of which were designed by or with GM. LG's involvement in the Bolt has gone so deep as "defining what will this vehicle be, everything from how we are going to package it, what size it should be, what kind of performance it should have," according to Pam Fletcher, GM's Executive chief engineer for electrified vehicles. Forgoing the traditional automotive relationship for a more collaborative one doesn't just save money, but it also gives GM access to LG's suite of technologies and manufacturing capabilities. Read more at Green Car Congress. The EPA has awarded three Honda factories with Energy Star certification. The automaker's assembly plants in Marysville and East Liberty, Ohio have now earned Energy Star certification ten consecutive years. The Marysville plant added LED lighting, hydrogen-powered tow motors and forklifts, high efficiency HVAC and direct-fired water boilers. The East Liberty facility added new LED lighting and replaced a large water heater with a high-efficiency one. Honda's newest US plant, Honda Manufacturing of Indiana, installed LED lighting and used energy efficient features in its recent expansion. Honda also cites a culture of energy-mindedness – for every associate – for its success. "When everyone involved considers energy efficiency and how they can help the environment, results improve," says Karen Heyob, Honda's sustainability boss in North America. Read more from Honda. The student-led Associated Students of the University of Montana (ASUM) Transportation has ordered two Proterra electric buses. The 40-foot Catalyst Fast Charge buses will serve the campus, and will recharge with a semi-autonomous fast charger. "As part of our ongoing effort to innovate service, align with student advocacy and reduce our carbon footprint, we take great pride in our decision to go electric," says ASUM Office of Transportation Director Jordan Hess. "We hope this encourages – and challenges – other universities to seriously consider the economic and environmental benefits of zero-emission buses." Read more in the press release below. First Student-led Transit Agency in the U.S.