93 Z28 Red Camaro on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2016 Chevy Volt auctioned off to help the robots

One of the cool things about the 2016 Chevrolet Volt extended-range plug-in being auctioned off to raise money for kids' science and robotics program is that even the sedan's color sounds very scientific. Indeed, it's fitting that a "Kinetic Blue" Volt will be used to advance the scientific education of the country's students, according to Hybrid Cars. That is, if it fetches enough cash. Chevrolet parent General Motors was kind enough to donate a 2016 Volt to the so-called FIRST K-12 robotics program (FIRST stands for For Inspiration and Recognition of Science and Technology). The program was founded in 1989. Last year, General Motors engineers worked with about 10,000 FIRST students in the US, but it looks like GM is now going the cold-hard-cash route to make its mark on future scientists. Bidding for the vehicle will take place until the morning of November 19, and, hopefully, it will generate enough interest to drive the bidding price up beyond its MSRP. As of Tuesday morning, nine bids had been taken, with the top one at $27,750. That's all fine and good except the car is pretty loaded with bells and whistles, and it's 53-mile electric-only range is a considerable jump from the first-generation Volt, so the car's "estimated value" is $40,245 (not factoring in the $7,500 federal tax incentive). That's a pretty good jump over the 2016 Volt's base price of $33,995, which marked a $175 price cut from the 2015 model. So pony up, folks. It's for the kids. Related Video:

J.D. Power study identifies top seats for your tush

File under News your fanny can use: The seating systems in the Ford Escape and Edge, the Audi A3, Chevrolet Cruze, Kia Cadenza, Porsche Cayenne and Toyota Tundra received top marks in a new J.D. Power study on seating and seat belt quality and satisfaction. The J.D. Power 2017 Seat Quality and Satisfaction Study asked more than 77,000 new owners and lessees of 2017 model-year cars and light trucks to rate their vehicle's seats and seat belts within the first 90 days of taking ownership. The survey is broken up into seven vehicle segments and scored on total seat problems per 100 within each segment, with awards presented to the seating system supplier. Canadian auto supplier Magna won three of seven first-place awards for its seating systems in the A3, Escape and Edge. Ireland-based Adient got top marks for its seats in the Cadenza and Cayenne. Lear Corp. won for the Cruze, and Avanzar Interior Technologies scored highest for seats in the Tundra. J.D. Power says its study is intended for automakers and suppliers with quality and satisfaction information to be used in developing and marketing seating systems. "But the results are just as interesting to a consumer audience," the company says. "After all, some drivers spend a considerable amount of time behind the wheel, and it's helpful to know which vehicles offer the most comfortable seats for those long commutes." Ain't that the truth. Ford was the only automaker whose seat systems, both manufactured by Magna, received top honors in two segments: the Escape for mass-market compact SUV and the Edge for mass-market midsize/large SUV. J.D. Power says it used 22 attributes to measure seat quality, three measures of seat belt quality and 12 to measure satisfaction. Awards were presented to the seating suppliers. Related Video: Image Credit: Audi Auto News Design/Style Audi Chevrolet Ford Kia Porsche Toyota Safety JD Power seats