Chevrolet 454 Ss Truck Chevy Truck on 2040-cars

Auto blog

GM profit dips on truck changeover, but beats estimates

DETROIT — General Motors on Thursday reported a higher-than-expected quarterly profit despite a drop in production of high-margin pickup trucks, as it gears up for new models that are expected to boost profits next year. Like rivals Ford and Fiat Chrysler Automobiles, GM is banking on highly-profitable Chevy Silverado and GMC Sierra pickup trucks to lift profits, as consumers shift away from traditional passenger cars in favor of these larger, more comfortable trucks, SUVs and crossovers. During the first quarter, the process of changing over to GM's new pickups resulted in a drop in production of 47,000 units. GM Chief Financial Officer Chuck Stevens said the production drop had resulted in a drop in pre-tax profit of up to $800 million. Earlier this year, GM said its 2018 profits would be flat compared with 2017, but expected its all-new pickup trucks would boost margins starting in 2019. On Thursday, GM reiterated its full-year 2018 forecast for adjusted earnings in a range from $6.30 to $6.60 per share. The automaker said capital expenditures were more than $500 million higher in the quarter because of investments its new pickup trucks and a family of low-cost vehicles under development with Chinese partner SAIC Motor Corp. On Wednesday, rival Ford said it would stop investing in most traditional passenger sedans in North America. CFO Stevens told reporters on Thursday that GM has "already indicated that we will make significantly lower investments on a go-forward basis" in sedans. 2019 GMC Sierra View 21 Photos GM benefited from a lower effective tax rate in the quarter, but adjusted pre-tax margin fell to 7.2 percent from 9.5 percent a year earlier. Stevens said the company's profit margin should hit 10 percent or higher in the second quarter and for the full year. GM said material costs were $700 million higher in the first quarter, and it expects those costs to continue rising. The automaker said it would counter those increases with cost cutting measures. "It is a more difficult environment than it was three or four months ago," Stevens said when asked about rising commodity prices from potential steel and aluminum tariffs announced by the Trump administration. "But we are confident we can continue to offset that." The company reported quarterly net income of $1.05 billion or $1.43 per share, a drop of nearly 60 percent from $2.61 billion or $1.75 per share a year earlier. Analysts had on average expected earnings per share of $1.24.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Diesel details: Comparing Ram 1500 EcoDiesel, Chevy Silverado Duramax, Ford F-150 Powerstroke

With specifications for the 2019 Ford F-150 Power Stroke diesel already out, and the details on the 2020 Ram 1500 EcoDiesel and Chevy Silverado Duramax (and its GMC Sierra twin) trickling out, we felt it was a good time to start comparing the full-size trucks' light-duty diesels. Bear in mind, we've only driven one of these new diesel trucks, so we'll be sticking to numbers for now. Some numbers haven't been announced yet, either, but stay tuned, because we'll be updating this post with additional specifications as they become available. And if you want to compare any other versions of these trucks with other vehicles, be sure to check out our comparison tool. Now let's start comparing, starting with our big chart of numbers below. As we can plainly see, these trucks are quite closely matched. Each one has six cylinders, a displacement of 3.0 liters and a turbocharger to boost it. The output of each is somewhat close, too. The Ram 1500 EcoDiesel is the torque king at 480 pound-feet, 20 more than the GM trucks and 40 more than the Ford. The GM trucks win on power, though, with 277 ponies, 17 more than the Ram, and 27 more than the Ford. GM does report that you get their trucks' peak 460 pound-feet of torque from 1,500 rpm to 3,000 rpm, whereas the others only report peak torque at a particular point in the rev band, but all of these trucks should have wide, flat torque curves as you would expect from modern turbodiesels. 2020 Ram 1500 EcoDiesel View 8 Photos Engine output is only one part of the truck performance equation. We also have towing and payload capacity, as well as fuel economy. With towing, the Ram 1500 is the current leader with a maximum capacity of 12,560 pounds. That tops the Ford F-150's 11,400-pound tow rating by well over 1,000 pounds. The F-150 can carry 2,020 pounds in its bed, but we don't know yet whether that's better or worse than the Ram or the GM trucks. We also don't have numbers for the GM trucks' towing capacities. View 9 Photos As for fuel economy, the Ford F-150 manages a thoroughly impressive 22 mpg in the city and 30 on the highway with two-wheel drive. Choosing four-wheel drive drops those numbers to 20 and 25 respectively. The fuel economy numbers for the Ram, Chevy and GMC haven't been revealed yet, but for some comparison, we can look at the old Ram EcoDiesel. That truck's best fuel economy was 20 in the city and 27 on the highway with two-wheel drive.