68 Chevy Truck Hot Rod Rat Rod Classic Truck on 2040-cars
Long Beach, California, United States
Body Type:Pickup Truck
Vehicle Title:Clear
Engine:8
Fuel Type:Gasoline
For Sale By:Private Seller
Number of Cylinders: 8
Make: Chevrolet
Model: C-10
Trim: n/a
Options: CD Player
Drive Type: 2wd
Mileage: 0
Exterior Color: metallic red white pearl top
Number of Doors: 2
Interior Color: n/a
Warranty: Vehicle does NOT have an existing warranty
Im selling my 68' chevy truck long bed it has 350 engine with 400 turbo transmission, oak wood floor bed coated with marine varnish that protects the wood from water and UV rays (its been sitting outside for the last two years and you can see the wood looks like new its shiny and smooth), 20" rims, SONY cd player and 9" speakers, posi traction, new lowed rear spring and shocks and blocks, the gas tank is under bed with billet fuel cap located in the wood floor,
NEED TO SELL FAST MAKE OFFER !!!!!!
BEST OFFER TAKES IT
TRUCK LOCATED IN LONG BEACH CA 90805
engine has:
Ceramic coated headers
high torque mini starter
chrome altanator
Edelbrock camshaft with lifters
1411 Edelbrock carbutator
Edelbrock torker intake
recent head job machine valves and heads have new edelbrock valve springs
edelbrock polish finish water pump
edelbrock fuel pump
edelbrock oval air filter
msd spark plugs wires
MSD 6420 ignition box and MSD distributor and MSD coil
transmission has TCI torque converter
rear end has limited slip/ positve traction
I replace the rocker panels, some parts of the door skin with new metal mostly bottom corners of doors where is usual rust and also the water chanels, paint is 80% nice red metallic and white pearl top still need some more polishing and wet sanding bed was taken a part and it has new red oak wood which was stain and finished with marine varnish and polished, bed strips are stainless steel and also the bolts and nuts. The gas tank was relocated and is under the bed.
The frame has been C notch and dropped the rear 6" and I did that with 2"drop blocks and 4" drop coils and shocks and new pan bar for a total of 6" drop. The front is LOWERED 3in WITH new shocks and coils from CPP. Also the upper and lower control arms have been sand blasted and power coated black, control arms have new ball joints upper and lower.
It needs new interior is not bad but could be better looking. STILL NEEDS MORE WORK BUT IS NICE DRIVABLE PROJECT
any question feel free to email me or give me a call at 562 787-0145
PASSANGER SIDE FENDER HAVE BEEN DAMAGE WILL POST PICTURE LATER OF IT!!!!
Chevrolet C-10 for Sale
1966 chevy c10. clean, original, stock 32,000 original miles everything works!
1970 chevy c10 step side frame off restoration(US $14,500.00)
1977 chevy 454 stepside pick up cumstom(US $9,500.00)
1972 chevy pickup c-10 swb
1970 chevrolet c 10 truck 2 tone (silver & charcoal) with maroon trim(US $9,999.00)
1985 custom chevrolet c-10 swb pick-up
Auto Services in California
Windshield Repair Pro ★★★★★
Willow Springs Co. ★★★★★
Williams Glass ★★★★★
Wild Rose Motors Ltd. ★★★★★
Wheatland Smog & Repair ★★★★★
West Valley Smog ★★★★★
Auto blog
GM, UAW poaching Nissan workers in Tennessee
Tue, Sep 8 2015General Motors and the United Auto Workers are going on a recruitment drive at the Spring Hill factory in Tennessee, and they're hoping to poach some skilled workers from Nissan's nearby plant in Smyrna, TN. The General and the union even bought a billboard advertising for industrial electricians near the Japanese automaker's facility, according to the Daily News Journal. The reason for the billboard was simple. "GM was short of electricians," said Tim Stannard, the president of the UAW local at Spring Hill, to the Daily News Journal. The factory currently builds the Chevrolet Equinox but has a contract to assemble the next generation of Ecotec engines and the Cadillac XT5, which replaces the SRX. Thanks to the $185-million deal, employment there is expected to double by May 2016, according to Stannard, with roughly 1,800 additional union jobs. Beyond just several billboards, GM has job postings online for the Spring Hill plant looking for workers with specific skills. There has already been some interest in the positions among Nissan employees, Stannard indicated. According to a recent study by the Center for Automotive Research, the average GM worker currently makes $58 an hour, including benefits. Comparatively, Nissan pays an average of $42 an hour with benefits. The General's number could change in the coming weeks because its contract with the UAW is about to expire, and higher wages are among the major negotiating points.
Recharge Wrap-up: Chevy Volt class action suit proposed, Tesla stock could outperform in 2015
Sat, Dec 27 2014A class action suit has been proposed against General Motors for a steering problem in the Chevrolet Volt. The plaintiffs claim that a defect can cause the steering to freeze intermittently, and that General Motors either knows or should have known about the problem. The case, filed in New Jersey, also claims that defective parts are replaced with the same or similar parts, which are also defective. The plaintiffs say that claims for the 100-plus-member class exceed $5 million. Read more at Law360 or at BigClassAction. Tesla Motors stock (TSLA) has risen after weeks of losses. It gained 5.4 percent during the week ending December 19, when it closed at $219.29 per share. Since then, it rose slightly more, closing at $222.26 on December 24. Morgan Stanley lowered its target price on Tesla stock from $320 to $290, predicting lower sales on the upcoming Model III than expected before, but still called Tesla a good long-term investment. Analysts at CNBC predicted Tesla to be the best performing stock of 2015. Read more at ETF Daily News. Oslo- and New York-based architecture firm Snohetta has designed a zero-emissions house that also charges an electric car. The ZEB Pilot House, built in Larvik, Norway, uses a solar panel on the roof to power the house, which also provides enough excess energy to charge an EV. To make the most of energy most efficiently, the house uses smart technology to use as much energy as it can once it's harvested. This means one can turn on appliances like the washing machine remotely while the sun is at the optimum angle in the sky - perhaps during mid-day when the residents are at work. The house also uses organic materials and is designed to save as much energy as possible. Read more at Wired.
Chevy Tahoe-to-K5 Blazer conversion shop renders Jimmy option
Sat, Feb 20 2021Back in 2019 we told you about a truck that looked like a K5 Chevy Blazer, but was actually a modern late-model Tahoe underneath. It was the product of Arkansas shop Flat Out Autos, which reskinned modern GM full-size SUVs to look like their predecessors. Now, the same shop is planning to release a GMC version, converting Yukons to Jimmys. We were impressed by Flat Out's workmanship, beautifully blending the lines of the Blazer into those of the Tahoe. The result was a cohesive design, not just a panel swap. It clearly required a lot of work, which helped justify the $69,000 price tag, not including the cost of the donor Tahoe. FlatOut Autos GMC Blazer Tahoe reskin 01 View 11 Photos At least one new owner was so impressed that they recently purchased four identical Blazer conversions at once. The quadruplets were all finished in blue with a white roof and all based on brand-new 2020 Tahoes. Obviously, with such demand it was only natural for Flat Out to explore other options. On Facebook the company said it was working on a 1972 version with an eggcrate grille. Now, they've also released a rendering paying homage to the K5 GMC Jimmy. The Jimmy conversion uses the original's quad-headlight face, crosshair grille and GMC badging. Like the Blazer conversion, it adds chrome bumpers and milled door handles while adapting the original's 2-door design to the new truck's 4-door body. The rendering only shows the front three-quarter view, but presumably a new carbon fiber rear door would have to be created as the Blazer's says "Chevrolet" across the back. Flat Out says that all the modern conveniences found on the donor Tahoe will work on the conversion, including parking, blind spot and lane keeping sensors. If you have the coin, it's a great way to have retro style without giving up modern safety and performance. The new Blazer has been disappointing to many fans that had hoped for a Bronco-like SUV. Instead, GM gave us a crossover. The Flat Out conversions might be a good compromise, and expanding it to the GMC brand only makes sense. Obviously there's no requirement to use a GMC Yukon as the donor vehicle for the Jimmy, as it's functionally identical to a Tahoe, but wouldn't you want to keep it in the family? Related Video:

