1988 Chevrolet S10 Blazer Tahoe Sport Utility 2-door 4.3l on 2040-cars

Auto blog

GM Ultium tech can scavenge heat from everywhere, even you

GM likes to give us tidbits about its Ultium platform from time to time, and today it’s telling us about the platformÂ’s ability to capture waste heat from the propulsion system. In addition to capturing from the propulsion system, it can also capture humidity from both inside and outside the vehicle and even from passengersÂ’ body heat. Yes, you, your family and/or your friends are a usable heat source as far as GM EVs are concerned. It then deploys the heat in an advantageous way. If at this point, youÂ’re screaming, "Heat pump!" youÂ’d be right. WeÂ’re talking about an elaborate heat pump system that GM is using for its Ultium-based vehicles. Every Ultium-based GM vehicle gets this system that is covered by 11 patents and four publications. The waste heat it collects is used in a number of ways, but its primary use is to heat the cabin quickly and efficiently. GM claims it can heat the cabin of its Ultium-based vehicles quicker than vehicles with traditional internal combustion engines. Plus, when put to use, GM claims that using the heat pump provides its EVs with up to 10% more range than theyÂ’d have without. Beyond heating the cabin, the heat pump is capable of putting waste heat to use by preheating the battery prior to charging so that you can charge quicker. The system can even cool the propulsion system in preparation for Watts to Freedom (WTF) launch control starts. GM says this was vital in helping the Hummer EV achieve its bonkers 0-60 mph time of about 3 seconds. “Having a ground-up EV architecture gives us the freedom to build in standard features like UltiumÂ’s energy recovery capabilities,” said Doug Parks, GM executive VP of global product development, purchasing and supply chain. “This helps us squeeze more efficiency, performance and overall customer benefit out of our EVs.” GM says itÂ’s been developing heat pump technology since the EV1 and its heat pump. This is the modern evolution of that technology, and GM says itÂ’s going to be implemented in every Ultium-based vehicle as a standard feature. Related video: Green Cadillac Chevrolet GM GMC Technology Electric Future Vehicles

GM isn't liable for punitive damages in ignition switch cases

NEW YORK — A federal appeals court said General Motors is not liable for punitive damages over accidents that occurred after its 2009 bankruptcy and involved vehicles it produced earlier, including vehicles with faulty ignition switches. The 2nd U.S. Circuit Court of Appeals in Manhattan said on Tuesday that the automaker did not agree to contractually assume liability for punitive damages as part of its federally-backed Chapter 11 reorganization. GM filed for bankruptcy in June 2009, and its best assets were transferred to a new Detroit-based company with the same name. The other assets and many liabilities stayed with "Old GM," which is also known as Motors Liquidation Co. Tuesday's 3-0 decision may help GM reduce its ultimate exposure in nationwide litigation over defective ignition switches in several Chevrolet, Pontiac and Saturn models. It is also a defeat for drivers involved in post-bankruptcy accidents, including those who collided with older GM vehicles driven by others, as well as their law firms. The ignition switch defect could cause engine stalls and keep airbags from deploying, and has been linked to 124 deaths. A lawyer for the drivers and their law firms did not immediately respond to requests for comment. GM had no comment. Circuit Judge Dennis Jacobs said GM's agreement to acquire assets "free and clear" of most liabilities excused it from punitive damages claims for Old GM's conduct. He also noted that the judge who oversaw the bankruptcy concluded that the new company could not be liable for claims that the "deeply insolvent" Old GM would never have paid. The decision upheld a May 2018 ruling by U.S. District Judge Jesse Furman in Manhattan, who oversees the ignition switch litigation. Drivers have sought a variety of damages in that litigation, including for declining resale values. GM has recalled more than 2.6 million vehicles since 2014 over ignition switch problems. It has also paid more than $2.6 billion in related penalties and settlements, including $900 million to settle a U.S. Department of Justice criminal case. The case is In re: Motors Liquidation Co, 2nd U.S. Circuit Court of Appeals, No. 18-1940. Government/Legal Chevrolet Pontiac Saturn Safety gm ignition switch

GM Design shows what could have been and what might be

We periodically like to check in with GM Design's Instagram account to see what they're cooking up. Even better is when we catch a glimpse of an alternate history of what legendary designers from The General's past were thinking, though those ideas may not have made it into production. This week, for example, the account posted some illustrations from George Camp, whose career at GM spanned nearly four decades, from 1963 to 2001. One of the renderings is of what appears to be a 1971-72 Pontiac GTO Judge, but with two headlights instead of the production unit's quad beams. The rear departs from the canonical version most dramatically, with a massive integrated wing. Other bits that didn't make the production cut include large side vents, a gill-like side marker and rectangular intakes below the headlights that wouldn't be out of place on a modern design today. Amazingly, from what we can make out of the date, it appears that the drawing was done sometime in 1965, which makes it quite prescient.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) There's also a very aerodynamic interpretation of a Corvette ZR-1. To our eyes it splits the difference between the 1986 Corvette Indy concept and a fourth-generation F-body Pontiac Firebird, so perhaps parts of Camp's work on this sketch did make it into physical form. There's also a radical sports car concept from May 1970 that resembles the Mazda RX-500 concept from the same year, a Syd Mead-looking Cadillac coupe, and an Oldsmobile with a cool take on the company's trademark waterfall grille and elements of the Colonnade Cutlass at the rear. Other recent posts include a FJ Cruiser-like off-road EV, a sleek coupe with the Chevy corporate grille, and a rendering of a Silverado-esque pickup that looks far better than the current production version.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) It's pretty easy to lose hours in the account, but it's always fascinating to see GM's visions of what could have been and what might be. Related Video: