2002 Chevrolet Avalanche 1500 Z71 Crew Cab Pickup 4-door 5.3l on 2040-cars

Auto blog

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

2021 Chevy Silverado, GMC Sierra fuel economy to go down due to global chip shortage

Production of the 2021 Chevy Silverado and 2021 GMC Sierra is continuing, but the global semiconductor chip shortage is resulting in a mid-year change. Or rather, an omission.  Basically, the availability of cylinder deactivation for the 5.3-liter V8 will be significantly reduced, resulting in a reduction of 1 mpg combined for affected models. This applies whether that engine has the six- or eight-speed automatic, as well as to both the regular Active Fuel Management and the more advanced Dynamic Fuel Management cylinder deactivation systems. DFM does remain with the pairing of 5.3-liter V8 and 10-speed automatic that comes standard on the LT Trail Boss and High Country. "Due to the micro controller shortage, the components that control AFM/DFM in the engine control module (ECM) have been removed," GM spokesperson Michelle Malcho told Autoblog. She also indicated that the engines will still have the AFM/DFM hardware in place, but that GM will not allow activation of the systems in the future with an ECM change.  Malcho also confirmed to Autoblog that the Silverado and Sierra's other engines will continue to have AFM and DFM, including the 2.7-liter turbo inline-four, 4.3-liter V6 and 6.2-liter V8. In an earlier statement to Reuters, she declined to say the volume of vehicles affected. "By taking this measure, we are better able to meet the strong customer and dealer demand for our full-size trucks as the industry continues to rebound and strengthen," Malcho wrote Reuters in an email. The change runs through the 2021 model year, she said. Malcho told Reuters it would not have a major impact on the Detroit automaker's U.S. corporate average fuel economy (CAFE) numbers. "We routinely monitor our fleet for compliance in the U.S. and Canada, and we balance our portfolio in a way that enables us to manage unforeseeable circumstances like this without compromising our overall (greenhouse gas) and fuel economy compliance," she said. GM's fleetwide fuel economy in the 2018 model year was 22.5 miles per gallon and was projected to rise to 22.8 mpg for 2019, according to a report by the Environmental Protection Agency. To meet federal CAFE requirements, automakers like GM often use credits from either earlier years where they faced less stringent rules and performed better than the requirements or buy credits from other automakers. GM said last month the chip shortage could shave up to $2 billion from this year's earnings.

Chevrolet considering midsize crossover to slot between Traverse and Equinox

Crossovers are the new hotness, and automakers are looking to cash in by offering a size and shape for every customer. With Chevrolet's debut of the new 2018 Traverse in Detroit, which grew ever so slightly compared to the first-generation model, there is now a midsize-crossover-sized hole between the three-row Traverse and the compact Equinox. When asked about that obvious space, a Chevrolet spokesperson told us the company is looking into the possibility of expanding its crossover lineup. It should be a relatively simple thing to do, since all it would take is reskinning and rechristening the GMC Acadia with a bow tie, and we all know how much GM loves platform sharing. Although they're now different sizes, the new Acadia and Traverse still use the same platform; the Acadia is now on a short-wheelbase version of the C1XX while the Traverse uses long-wheelbase C1XX parts. A short-wheelbase Chevy built on the C1XX likely would be differentiated visually from both the Acadia and the larger Traverse. It may seem like flooding the lineup with more and more models would cannibalize sales of existing ones, but Chevrolet said it would rather have customers stay within the brand rather than going to another automaker. There have been whispers that some form of the Blazer name (possibly TrailBlazer) may make a return on a midsizer, but if it does don't expect an old-school body-on-frame SUV like the old one. In the end, if Chevy builds it, customers will come. Related Video: