2010 Chevrolet Traverse on 2040-cars

Auto blog

CNG-powered Chevy Sonic, Cruze headed your way

The value proposition for a Crazy Diamond Performance CNG ride was a little bit better before gas prices took a dive in the past month. Still, the Michigan-based company, which converts some of Chevrolet's compact vehicles to run on compressed natural gas, received approval late last month from the US Environmental Protection Agency (EPA) for two of its conversion models. And CNG is still pretty cheap. Crazy Diamond will start selling CNG versions of both the Chevrolet Cruze and Chevrolet Sonic. The startup will target fleet operators looking to cut both refueling costs and their carbon footprint. CNG can be found in much of the country in the low $2 range, while the average CO2 emissions are about 25 percent less than those of similar gas-powered vehicles. Average gas prices have tumbled by more than 30 cents a gallon in the last month, according to AAA, but they're still at close to $3. The two models will be able to go almost 300 miles on a full tank of CNG. Crazy Diamond said this summer that it would start selling converted a CNG-powered Cruze that delivers 130 horsepower for as low as $26,000. The turbocharged version goes for about $28,000. Take a look at Crazy Diamond Performance's celebratory press release below. Crazy Diamond Performance recieves EPA approval on its CNG Cruze and Sonic CDP receives EPA approval for its Mono-Fuel CNG Cruze and Sonic. Shelby Township, Michigan, October 30, 2014– Crazy Diamond Performance (CDP) receives EPA approval on its Mono-Fuel Compressed Natural Gas (CNG) Chevrolet Cruze and Chevrolet Sonic. Crazy Diamond Performance has received EPA approval on two new mono-fuel small passenger vehicles, the CNG Chevrolet Cruze and CNG Chevrolet Sonic. These new mono-fuel CNG platforms are the first of a series of small and fuel efficient vehicles coming from CDP, where cost, low emissions and reduced fuel consumption is important for not only fleet owners, but to the general public as well. "Soon to be available, are the 1.8L and 1.4L Cruze and Sonic CNG retrofit systems. These two vehicles represent a change in the status quo, with an OEM level integration of the fuel system and its components" states Michelle Fern, Executive Vice President CDP Inc. These vehicles provide flexibility for fleets looking to purchase a domestic small mono-fuel passenger sedan, but have not had an option until now. There are significant emissions benefits over its gasoline counterpart, with an average reduction in Carbon Dioxide (CO2) of 25%.

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

Petrolicious profiles one man and his duo of '64 Impalas

Restoring any vintage car is a labor of love. In the end, the investment of time and money is often more than the vehicle is realistically worth on the open market. Deciding to take all of that work on yourself doesn't make things any easier, but it can only increase your connection to the project. Don Rogers, the subject of the latest video from Petrolicious, shows this passion perfectly with his duo of 1964 Chevrolet Impalas – a hardtop and convertible. Both of these Chevys had been sitting for years before Rogers got his talented hands on them, and he did all of the work himself. Now, driving the pair is therapy for him, and he's not worried about anything breaking because he knows he can put it back together. Rogers says he enjoys wrenching on his vehicles even more than going to shows. Doing your own work comes with advantages, like tailoring a project's look to your preferences. It's not original, but Rogers used the crimson interior color from a '59 Impala on his convertible to make the interior pop with the top down. Rogers is undoubtedly a talented builder, and his work is worth checking out in the latest from Petrolicious. Related Video: