2004 Chevrolet Ssr Yellow Automatic on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Ford Mustang chief engineer, mid-engine Corvette | Autoblog Podcast #488

Note: There were some technical difficulties that prevented some of you from downloading this week's podcast. The player and link below should be working now, and the file has reached iTunes and other feeds as well. Thanks to everyone who wrote in to let us know of the issues! On the podcast this week, we have some questions for Ford Chief Engineer Carl Widman. Plus, Associate Editor Reese Counts joins Mike Austin to talk about the latest news, most notably the spy photos of the upcoming mid-engine Corvette. We also chat about the Jaguar F-Type Coupe, the Nissan Armada, and why 0-60 mph is a stupid performance figure. And, of course, we get into some Spend My Money advice, telling strangers what car to buy. And new this week is a cost-no-object what-cars-would-you-buy game. The rundown is below. And don't forget to send us your questions, money-spend or otherwise, to podcast at autoblog dot com. Autoblog Podcast #488 The video meant to be presented here is no longer available. Sorry for the inconvenience. Topics and stories we mention Mid-engine Chevrolet Corvette spied Chevy Bolt EV comes with 238 miles of range Ford will sell self-driving cars by 2025 Jaguar F-Type Coupe 2017 Nissan Armada (yes, Mike knows it's not a Patrol) Ford Mustang Chief Engineer Carl Widman interview Spend My Money - we give purchase advice Why 0–60 mph is a stupid performance test Rundown Intro - 00:00 The news - 03:30 What we've been driving - 16:20 Carl Widman - 26:44 Spend my money - 37:03 New fun game - 51:48 0–60 mph is overrated - 56:50 Total Duration: 1:04:57 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Feedback Email – Podcast at Autoblog dot com Review the show in iTunes Podcasts Chevrolet Ford Jaguar Nissan Car Buying nissan armada mid-engine corvette jaguar f-type coupe

GM will make Chevy Volt production announcement tomorrow

Thing are apparently happening to get the next-generation Chevy Volt ready for public consumption. The most obvious proof is in a preview of an announcement (possibly coming tomorrow) that the two main places where General Motors gets the Volt ready -the Detroit-Hamtramck Assembly Plant and the Brownstown Township battery assembly facility - will be getting big money upgrades and lots of new positions. The Hamtramck plant builds the Volt and its fancier cousin, the Cadillac ELR, as well as the global versions of the Volt. The Detroit News reports that GM will add 1,400 jobs and spend roughly $450 million at the two locations in order to build the redesigned Volt. What's less clear is exactly what the updates will bring us. We've heard that the new volt will be a 2016 model and come on a new chassis. Speculation in The Detroit News about tomorrow's announcement runs the gamut from a new compact PHEV with less electric range and a lower price (which makes sense) to an updated Volt with more electric range (heard it before) to a new all-electric vehicle (the moon shot). If there's any hints to be gleaned in the international Volts, there are also reports coming in that the Opel brand will get an all-electric vehicle that is cheaper than the Ampera. Read into that what you will. We pestered GM's Kevin Kelly on the new Volt (again) and he said (again) that he couldn't give out any more detail other than what's been reported. He just told AutoblogGreen that there will be an announcement tomorrow and that it will be about the Hamtramck and Brownstown facilities and involve the Volt. So, stay tuned.