Monte Carlo Ss Coupe Tony Stewart Signature Series Only 1020 Made One Owner on 2040-cars

Auto blog

2016 Chevy Volt will not need premium gas

Buried in the new technical details of the 2016 Chevy Volt released yesterday was a throwaway line about a small but important change that's due to the new 1.5-liter, four-cylinder engine. The first-gen Volt has always required premium gas but the new powerplant will be happy burning plain old regular. The Volt's chief engineer, Andrew Farah, told AutoblogGreen that the change was due to today's Volt owners explaining they were not happy paying for top-shelf petroleum. "The ability to use regular unleaded was based directly on customer feedback," he said. "Since the range extender is an all-new engine, it was optimized to use regular unleaded at the outset. Using regular fuel will not have effect on vehicle acceleration or other performance factors." As Larry Nitz, GM's executive director of vehicle electrification, told AutoblogGreen yesterday, the new engine is more powerful and quieter than the outgoing 1.4-liter engine that's used in the current Volt. Fuel economy and EV range specs for the next-gen Volt are not expected until the full car is revealed at the Detroit Auto Show in January.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Very first Chevy Camaro found and restored

Restoring an important classic car can lead people down rabbit hole upon rabbit hole of discovered history in a process that's essentially automotive genealogy. Take the recent rejuvenation of the very first Chevrolet Camaro as an example. The owners started with a strong hunch that the vehicle might be something special and spent years researching to figure it all out before the mechanical work even began. Fisher Body kicked off work on the first Camaro on May 17, 1966, and it was delivered to General Motors just a few days later for final assembly. While the model has earned a place as an American performance icon since then, the original was built more to develop the production process and boasted just a 230-cubic-inch (3.8-liter) inline six and 3-speed transmission. After spending its first few months appearing in promotions, a Chevy dealer in Oklahoma got the gold car in December of '66. It was touted on the sales floor there for years, and the first private owner didn't come until 1969. This short documentary goes into astonishingly comprehensive detail about every bit of the first Camaro's history. If you just want to hear the story of the latest owners and their work to get the vehicle restored since 2010, skip about 11 minutes into the video. Or, of course, you could just enjoy the whole thing. News Source: PilotCarRegistry via YouTube, Camaro NewsTip: Chris P. Chevrolet Automotive History Auto Repair Maintenance Coupe Classics Videos history