2005(05)malibu Ls We Finance Bad Credit! Buy Here Pay Here Low Down $899 on 2040-cars

Auto blog

The real costs of keeping a Chevy Volt on the road

The release of the new, 2016 Chevy Volt is sure to bring a surge of used electric vehicles to the market as early adopters trade their older models in. Many of these cars are selling for a fraction of their original price, thanks in part to federal and state incentives that lowered the initial cost to the first owner, which opens these cars up to a whole new class of consumers. While the prices are getting attractive, potential buyers are still hesitant to buy a used EV due to uncertainty about service and repair costs, but there may be some good news on the horizon. The Chevy Volt comes with a battery warranty that is good for at least 8 years and 100,000 miles, but many of the Volts popping up on the market have passed that 100,000-mile mark. The threat of needing a new battery can be a deterrent, especially with some dealers quoting prices as high as $34,000 for a full "drive motor battery replacement." That sum is more than the MSRP of a 2016 model. Some of the fear of EV maintenance and repair comes from the mystery of the individual pieces that make up the drivetrain and charging system. If we take a look at the Volt in terms of analogs to a traditional internal-combustion vehicle, the outlook becomes a little more friendly. The Volt battery pack consists of three lithium-ion modules in a T-shaped arrangement, each of which can be serviced individually. Module 1 is made up of 90 cells and corresponds to GM part number 22954462, which retails for $3,258.33; module 2 is made up of 72 cells and corresponds to GM part number 22954463, which retails for $2,930.00; lastly, module 3 is made up of 125 cells and corresponds to GM part number 22954464, and retails for $4,933.33. These part numbers have been added to the dealer order systems but have not shown up in the distribution centers at this time. Although all three of the modules add up to a fairly large $11,121.66 total and are still on hold for dealer ordering, the good news is that in most cases these battery cell modules do not need to be replaced. There are many other individual pieces mounted on the battery pack that are serviceable, such as the Battery Energy Control Modules (BECM) and the Battery Interface Control Modules (BICM). These modules control and monitor the battery packs and charging system and have been known to fail while the lithium-ion battery cells are not at fault. Some have been replaced under warranty, but if you are stuck buying one they run about $255 a piece for the part.

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Camo'd Chevy Camaro ZL1 is one bad boy

Thanks to a fresh gallery of spy shots, we're getting a much better look at the next Chevrolet Camaro ZL1 during its development, and this machine is looking seriously mean. Unlike the last photos, the heavy cladding is gone from the body this time and is replaced by a camouflage wrap. That switch makes checking out the details a whole lot easier. The first thing you'll notice at the front is the massive grille that looks ready to devour anything that gets in the way. To add a little more menace, the lower air dam appears to jut out a bit more, as well. While harder to see in these latest shots, our spies say the hood still boasts an extractor similar to what's found on the Cadillac CTS-V. The big, double spoke wheels look great in black and really dominate the styling in profile. Look past them, and you notice some tweaked side sills, as well. At the very back, you can also spot some styling adjustments to the rear bumper. There's an unmissable wing back there, too. The powerplant for the ZL1 is still a mystery, but it's rumored to use the LT4 6.2-liter supercharged V8. The similar hood design as the CTS-V is one piece of evidence to support that. Even with the same engine, Chevy's engineers could tweak the output higher or lower than the Caddy. The wait to find out isn't too long because the ZL1 is anticipated to launch for the 2017 model year. Related Video: