Chevrolet Impala Hardtop Sedan on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

2016 Chevrolet Camaro: Notes from the reveal

The 2016 Chevrolet Camaro debuted Saturday evening in Detroit at an enthusiast-oriented event near the city's IndyCar course. While the big news was the Camaro's 200-pound weight loss, tighter chassis, and a snorting new V8, plenty of other morsels of Camaro info came out. Here's some of the more interesting stuff we heard. • The 2.0-liter inline four-cylinder is the first turbocharged engine in a Camaro. • The LT1 borrowed from the Corvette Stingray marks the third time a Camaro has used an engine with that badge. It was previously used in 1970-72 (Z/28), 1993-97 (Z/28), and 1996-97 (SS). • The Camaro was revealed in a tent before nearly 1,000 enthusiasts, General Motors executives (including CEO Mary Barra) and mere feet from the Grand Prix course where IndyCars will run in two weeks. • Chevy hopes to continue to attract new customers with the Camaro and said 63 percent of the fifth-generation buyers were new to the brand. • GM product boss Mark Reuss neatly summed up the Camaro's handling character. "It's wicked fast and extremely nimble." • Reuss on the design goal: make it "look like a car for tomorrow instead of a car from yesterday." • Reuss' first car was a 1967 Camaro, and he's reiterated his passion for the car. "People want to be seen in a Camaro, and that never goes away." • Chevy North America president Alan Batey said he plans to line up a red Camaro as soon as the order bank opens. We assume he'll have early access to that. • Though the appearance is similar, the sixth generation of the Camaro appears a little sleeker and is more aerodynamic thanks to 350 hours in the wind tunnel. Only two parts, the SS badge and the rear bow-tie emblem, are carryover. • Al Oppenheiser, the Camaro's chief engineer, said most of the options (except Magnetic Ride Control, which is SS exclusive), will be offered on the inline four. The engine will be capable of propelling the Camaro to a sprint to 60 miles per hour in well under six seconds. "We don't want to ... make it feel like an excuse car," he said. • Without revealing specifics, Oppenheiser said every Camaro variant will be faster than the model it replaces. •The interior is vastly improved. We got an up-close look in the cabin of one of the cars revealed with a red and white layout, and the materials are much better. The setting is more colorful, and 24 different ambient lighting shades are available. Related Video:

First 2015 Chevy Corvette Z06s en route to owners [w/video]

Pretty much right on schedule, Chevrolet has begun shipping the very first customer examples of its 650-horsepower, supercharged Corvette Z06. In fact, according to General Motors, the earliest Z06s could be in customer hands by the end of this week. "It has been an incredible opportunity to work on Chevy's most capable model," said Jeff Lamarche, manager of Chevy's Bowling Green Assembly plant. "It truly is an amazing car, and we're thrilled to get them into the hands of our eager customers." Prices for the Z06 start at $78,995 for the hardtop model, while the first-ever Z06 Convertible kicks off at $83,995. Take a look below for the official press release from Chevrolet, and while you're down there, we've slipped in a new video of Corvette Racing's Tommy Milner taking a hot lap of Road Atlanta in a Z06, complete with some Performance Data Recorder footage. First 2015 Corvette Z06s on Their Way to Customers Most capable model in Chevrolet's history now shipping from Bowling Green BOWLING GREEN, Ky. – Chevrolet is now shipping the all-new 2015 Corvette Z06 coupe from Bowling Green Assembly and some early customers could receive the much-anticipated supercar later this week. "It has been an incredible opportunity to work on Chevy's most capable model," said Jeff Lamarche, plant manager of General Motors' Bowling Green Assembly plant, "It truly is an amazing car, and we're thrilled to get them into the hands of our eager customers." The new Corvette Z06 offers the most choice for customers in the model's history. It is the first Z06 to offer an available eight-speed paddle-shift automatic transmission and, thanks to a stronger aluminum frame, a removable roof panel. In addition, it is the first time since 1963 that the Z06 is available as a convertible – which will arrive in early 2015. The new LT4 supercharged 6.2L V-8 engine is SAE-certified at 650 horsepower (485 kW) at 6,400 rpm and 650 lb-ft of torque (881 Nm) at 3,600 rpm – making the 2015 Corvette Z06 the most powerful production car ever from General Motors and one of the most powerful production cars available in the United States. To balance performance and efficiency, the LT4 leverages a trio of advanced technologies – direct injection, Active Fuel Management (cylinder deactivation) and continuously variable valve timing –with a new, more efficient supercharger. The LT4 helps make the Corvette Z06 the most capable car in the brand's history.