1978 Chevrolet Half Ton on 2040-cars

Auto blog

2020 Chevy Silverado, GMC Sierra recalled due to faulty brake component

General Motors is recalling 2020 Chevrolet Silverado 1500 and GMC Sierra 1500 pickups to fix a defect in the trucks' brake system. Certain Silverado and Sierra pickups were produced with brake-caliper bolts that were not heat-treated. Without heat-treating, the bolts are weaker than they should be, and there is a risk that they could fail, which would affect the trucks' braking performance, possibly leading to a crash. In total, 20,352 vehicles are affected. Owners of affected trucks will be contacted by GM. Dealers will inspect the bolts and replace those that are defective. Related Video:      

GM recalls 740,000 vehicles over daytime running light issue

General Motors is recalling over 740,000 vehicles due to a daytime running light issue that causes all of the affected cars to run afoul of Federal Motor Vehicle Safety Standards. Vehicles affected by this recall are spread across many of GM’s brands. Models include the 2020-2023 Cadillac CT4 and CT5, 2021-2023 Buick Envision, 2022-2023 Cadillac Escalade and Escalade ESV, 2022-2023 Chevrolet Silverado 1500, Suburban, Tahoe and 2022-2023 GMC Sierra 1500, Yukon, and Yukon XL. GM says that the daytime running lights may remain on in these cars when the headlights are activated. This is a problem, because FMVSS rules require that the daytime running lights deactivate once the headlights turn on. If the DRLs remain on, GM says that could result in additional glare, thereby increasing the risk of an accident. The cause of this failure to deactivate the DRLs comes from body control module software that “under a combination of certain pre-conditions, could fail to deactivate the DRLs,” according to GM. Other GM vehicles were tested, but due to a difference in software or hardware, they remain unaffected. If this is reminding you of another recent GM recall, youÂ’d be right, as GM recalled another 340,000 vehicles for the same issue last month. After that original issue was found within GM, the company began looking into its other cars to determine if the population was larger than originally thought. GM found the additional vehicles included in todayÂ’s recall have the problem. The fix will either be via an over-the-air update or it will require you to bring the vehicle into a dealer for a software update, depending on which vehicle you have. Owner notification letters letting folks know what is necessary are currently scheduled to go out on January 23, 2023. Related video: Cadillac Escalade Infotainment Review

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.