1984 El Camino Blue Gray on 2040-cars

Auto blog

GM Canada recalls 159,240 GMC and Chevy trucks for faulty defroster circuit

General Motors is recalling more than 159,000 2014-2019 Chevrolet Silverado and GMC Sierra pickup trucks in Canada due to a potential fire risk. GM says the rear defroster circuit could overheat on trucks optioned with the power-sliding rear window. Thus far, there is no word on the recall's relation to U.S. vehicles. The recall, found by Automotive News, was posted to Transport Canada on June 28, 2019 with manufacturer recall No. N192220470. Included in the 159,240 vehicles are the 2014-2018 Silverado 1500, the 2015-2019 Silverado HD, the 2014-2018 Silverado LD, the 2014-2018 Sierra 1500, the 2015-2019 Sierra HD, and the 2014-2018 Sierra LD. The notice says the rear defroster circuit, specifically on trucks with the power-sliding rear window, could overheat. Because of its placement, this excess heat could cause melting, smoking, or possibly fire, in the worst case scenario. As of now, there is no official word when GM will initiate the recall and there is no official fix detailed just yet. GM suggests that owners, who will be notified by mail if their vehicles are affected, take their trucks to a dealer to remove the rear window defroster fuse as a stop-gap.  Automotive News contacted GM to find out if the problem is also found in trucks sold in the United States, but no definitive statement was made, as the investigation is reportedly ongoing. We will update this space if American vehicles are found to be included in the problem.

2015 Chevy Silverado, GMC Sierra recalled for steering issues

DETROIT — General Motors Co is recalling more than 1 million pickup trucks and sport utility vehicles in the United States due to issues with a temporary loss of power steering, the National Highway Traffic Safety Administration said. The recall is for 2015 models. They are: the Chevy Silverado 1500, Suburban and Tahoe, GMC Sierra 1500, Yukon and Yukon XL and Cadillac Escalade. The problem may cause difficulty steering the vehicle, especially at low speeds, increasing the risk of a crash, the auto safety regulator said in a document dated Sept. 12. The document did not highlight any reports of accidents and injuries, because of the power steering issue. GM dealers will update the power steering module software, free of charge for owners of the affected vehicles. In 2014, the No.1 U.S. automaker had recalled nearly 800,000 pickup trucks worldwide because of the same problem. GM did not immediately respond to a request for comment.Related Video:

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck