2003 Corvette Convertible Triple Black 6 Speed Z51 1sb Ls1 Ram Air Predator Tune on 2040-cars

Auto blog

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

1956 Corvette SR-2 factory racer profiled

The Chevrolet Corvette has earned its place as America's sports car, capable of taking on the best the world can throw at it. Much of that winning reputation was earned with victories on the track. Now, there was a chance to own an early piece of the nameplate's motorsport history in the form of a 1956 Corvette SR-2 racer, but some deep pockets were necessary to get it, with an estimate of $6.885 million. The story behind the SR-2 is fascinating. In 1956, famous General Motors designer Harley Earl's son was racing in a Ferrari. Obviously, that wasn't going to work given his father's position within the automaker, and Harley and Corvette engineer Zora Arkus-Duntov got to work on a faster racecar. Three were made. This one was reportedly the first, and for 1957 it also received a fuel-injected V8 making a claimed 331 horsepower and four-speed manual gearbox, according to "Corvette Mike," the owner and seller. The SR-2 went on display in Scottsdale, AZ appropriately timed to coincide with the big Barrett-Jackson auction there that wrapped up this weekend. The car wasn't part of that event; instead marque specialist Mike Vietro sold the racer as a private treaty sale. Company spokesperson Troy Worrell told Autoblog both the bids and identities of the bidders will remain undisclosed. The video above goes into even deeper detail about this rare, finned Vette or check out the car's full description for even more info.

The 2021 F-150 elevates Ford's bed game

The new 2021 Ford F-150 is ushering in a new era of pickup capability, but there's more to it than the introduction of the PowerBoost hybrid. While that new powertrain is certainly the truck's headlining element, the supporting electrical architecture enables a level of utility that hasn't been offered in past consumer half-tons. The true party trick is Ford's new "Pro Power Onboard" feature, which is essentially a built-in generator that provides juice for the 2021 F-150's rather robust in-bed power station. This system is available even on gasoline-engine models, but its utility is maximized with the electrified powertrain. ICE models equipped with the option max out at 2.0 kilowatts, while the PowerBoost hybrid can be had with either a 2.4- or a whopping 7.2-kilowatt inverter.  The idea here is that the F-150 can essentially stand in for a high-output portable generator. In a worksite example provided by Ford, a PowerBoost model with the 7.2-kW upgrade and a single tank of fuel could provide 32 hours of power for an 1,800-watt compound miter saw, a 1,000W circular saw, a 1,200W battery charger, a 1,200W hammer drill, and a 1,000W air compressor with hundreds of watts to spare for lighting and other accessories. But even without the Pro Power Onboard option, Ford's new bed setup enables more versatility than in previous models. The new Tailgate Work Surface option adds a flat work area with integrated rulers, recesses for pencils or small tools, and even a stand for a personal device.  Ford is neither the first to offer an auxiliary power outlet in a half-ton pickup bed, nor was Ford the first to introduce a more feature-rich tailgate. GMC's MultiPro tailgate was a major innovation on that front, and while it is geared mostly toward improving the cargo utility of the bed, it can also be customized with 12-volt power and even an accessory speaker system. The Ram 1500 is also offered with both a multi-function tailgate and AC power in the bed, though the latter option is limited to models with the RamBox cargo package.  As half-ton pickups approach levels of towing and hauling capability that begin to blur lines with heavy-duty offerings, it's clear that automakers are looking for ways to differentiate themselves without stepping on their own bigger trucks' toes. These new bed and tailgate innovations may yet be the tip of the iceberg when it comes to full-size pickup versatility. Related Video: