Ss Chevelle on 2040-cars

Auto blog

GM to build outgoing Silverado and Sierra until late 2019

As it has done with previous generations, General Motors is keeping the outgoing versions of its 1500 pickups in production despite the arrival of the all-new 2019 Chevrolet Silverado and 2019 GMC Sierra. The production of the previous, K2 generation models will begin to be wound down gradually, according to Automotive News, starting with crew cabs "early next year," and double and regular cab models following during "the early second half of next year." The old model trucks will continue to be built into "late 2019" based on market demand, GM's spokesperson Kim Carpenter said. The Chevrolet will go by the name Silverado LD, with the GMC Sierra designation still to be announced. Some of the outgoing models are built by sharing the assembly work between two GM plants. Partially finished Silverado and Sierra double cab bodies are shipped from Fort Wayne, Ind., to Oshawa, Ont., where the trucks are completed, including receiving paint. This eases the workload in Fort Wayne, where production of the new T1 generation trucks started in July 2018. In January, the Silao plant in Mexico will take on the duties of building new generation regular cab and crew cab trucks. Carpenter also said that the "Oshawa shuttle," as the shared production is called, has been very successful. As a result, 60,000 more trucks will be built than what the original production forecast initially called for. GM's latest quarterly profits, disclosed last week to be $1 billion, have been far higher than expected and will result in full-year profits far higher than what had been predicted in light of steel tariffs. GM isn't the only truck maker taking a similar multi-generation approach for 2019. Both the outgoing and redesigned Ram 1500 are in production, with the previous generation being dubbed Ram 1500 Classic. Related Video:

2016 Chevy Camaro performance figures released

If you want to make a car faster, there are two sure-fire ways to get the job done – add power and/or reduce weight. Chevy has done both for the 2016 Camaro, putting as much as 455 horsepower into its muscle coupe and shaving a few hundred pounds from every trim. That range-topping power comes courtesy of a 6.2-liter V8 engine, and it's enough grunt to push an automatic-equipped Camaro SS to 60 miles per hour in just 4.0 seconds flat (4.3 seconds with a manual) and down the quarter mile in 12.3 seconds at 116 mph (12.5 at 115 for the stick). Not coincidentally, those acceleration specs, at least on paper, put the V8-powered Camaro SS just above the Mustang GT on the muscle-car pecking order. When the road gets twisty, Chevy claims the Camaro SS can generate as much as .97 g on the skidpad. And, thanks in part to its Goodyear Eagle F1 summer tires, the SS can stop from 60 in as little as 117 feet. We look forward to finding out how nimble the new Camaro feels when compared to its primary competitors. <p>Your browser does not support iframes.</p> Moving down one notch to the 335-hp 3.6-liter V6, properly equipped 2016 Camaro coupes can hit 60 in as few as 5.1 seconds and cover the quarter in 13.5 at 103. Perhaps even more intriguingly, the 2.0-liter turbocharged four-cylinder and its 275 horsepower (the only configuration quicker with a manual transmission, incidentally) can propel the Camaro to 60 in 5.4 seconds and through the 'ol 1320 in 14 seconds flat. That's seriously quick, but buyers comparing the Camaro to the Mustang will find that the EcoBoost 2.3-liter is a bit more powerful (310 hp and 320 lb-ft) and quicker (5.1 seconds to 60). Chevy is making lots of noise about the efforts its engineers went through to shed weight from the 2016 Camaro, going so far as to shave down suspension bolts so that no thread went unthreaded. The weight-saving obsession pays off – base Camaro models are down 390 pounds while the SS model drops 223 pounds over the 2015. The 2016 Camaro SS boasts a power-to-weight ratio of 8.1 lbs per pony, a 14-percent improvement over the last-gen. Even though weight is down, chassis stiffness is said to be up by 28 percent over the fifth-gen Camaro coupe. Also of note: The Camaro is now lighter than the Mustang across the board when comparing like-to-like configuration levels. The 2016 Chevy Camaro starts at $26,695 (including $995 for destination).

1956 Corvette SR-2 factory racer profiled

The Chevrolet Corvette has earned its place as America's sports car, capable of taking on the best the world can throw at it. Much of that winning reputation was earned with victories on the track. Now, there was a chance to own an early piece of the nameplate's motorsport history in the form of a 1956 Corvette SR-2 racer, but some deep pockets were necessary to get it, with an estimate of $6.885 million. The story behind the SR-2 is fascinating. In 1956, famous General Motors designer Harley Earl's son was racing in a Ferrari. Obviously, that wasn't going to work given his father's position within the automaker, and Harley and Corvette engineer Zora Arkus-Duntov got to work on a faster racecar. Three were made. This one was reportedly the first, and for 1957 it also received a fuel-injected V8 making a claimed 331 horsepower and four-speed manual gearbox, according to "Corvette Mike," the owner and seller. The SR-2 went on display in Scottsdale, AZ appropriately timed to coincide with the big Barrett-Jackson auction there that wrapped up this weekend. The car wasn't part of that event; instead marque specialist Mike Vietro sold the racer as a private treaty sale. Company spokesperson Troy Worrell told Autoblog both the bids and identities of the bidders will remain undisclosed. The video above goes into even deeper detail about this rare, finned Vette or check out the car's full description for even more info.