1987 Chevrolet Camaro Iroc-z Coupe on 2040-cars

Auto blog

2016 Chevrolet Camaro First Drive [w/video]

The Autoblog gang was downright stoked to learn the 2016 Chevy Camaro was next on our test-car docket. Then we found out it was the V6 model. Buzzkill. We were hoping for the snorting V8, or at least the spunky new turbo four-cylinder. The V6? Meh. We've been driving V6 Camaros for, like, six years. It's what you buy if you can't afford anything better, or so say horsepower snobs as they wrinkle their noses and cut their coffee with 93 octane. But after a week with the six-pot Camaro, we'll admit it: we were wrong. The all-new 3.6-liter V6 is strong, sounds good, and is damn fun to drive. Its 335 horsepower and 284 pound-feet of torque appear modest by modern standards, but they power the Camaro to 60 miles per hour in 5.1 seconds with the automatic, or in the case of our manual-equipped test car, 5.2 seconds. That's almost half a second quicker than the new turbo four-cylinder model. Yes, it has the same displacement as the old V6. No, it's not the same engine. Upon closer inspection, the V6's potency shouldn't come as a surprise. This engine is from General Motors' newest family of dual-overhead cam powerplants that launched in the Cadillac CTS and ATS. Yes, it has the same displacement as the old V6. No, it's not the same engine. Don't be fooled, and don't underestimate it at stoplights. The strapping V6 is unsuspectingly good, but it's just one of many improvements for the sixth-generation Camaro. Chevy's coupe is lighter, faster, and more modern looking inside and out. It starts with a rear-wheel-drive chassis donated from the Cadillac ATS, though about 70 percent of the components are unique to the Camaro. The 2016 model is about two inches shorter in length (thanks to a shorter wheelbase) and about an inch has been removed from height and width compared to the 2015 model. These lighter underpinnings jumpstarted the Camaro's weight-loss plan, and thanks to extensive use of aluminum, the V6 with the new eight-speed automatic transmission weighs 3,435 pounds – 294 less than its predecessor (the manual-transmission V6 Camaro weighs 3,448 pounds). The V8, meanwhile, sheds 223 pounds. One by one, these elements would merely enhance how the Camaro drives, but taken collectively, they invigorate the new model. It feels much more confident and agile in all circumstances. Put simply, it's a sportier car. View 32 Photos Grab second, let the revs build, and the dual-mode exhaust changes its tune from a low buzz to a rumble, then a growl.

Foreign automakers pay from $38 to $65 per hour to non-union workers

As leaders for the United Auto Workers gather in Detroit for their Special Convention on Collective Bargaining to work out the negotiating stance for this year's new labor agreements with the Detroit 3 automakers, what they most want to do is figure out how to eliminate the two-tier wage scale. However, the lower Tier 2 wage has allowed the domestic automakers to reduce their labor costs, hire more workers, and compete better with their import competition. As it stands, per-hour labor rates including benefits are $58 at General Motors, $57 at Ford, and $48 at Fiat-Chrysler – a reflection of FCA's much greater number of Tier 2 workers. The Center for Automotive Research released a study of labor rates (including benefits) that put numbers to what the imports pay: Mercedes-Benz pays the most, at an average of $65 per hour, Volkswagen pays the least, at $38 per hour, and BMW is just a hair above that at $39 per hour. Among the Detroit competitors, Honda workers earn an average of $49 per hour, at Toyota it's $48 per hour, Nissan is $42 per hour, and Hyundai-Kia pays $41 per hour. The lower import wages are aided by their greater use of temporary workers compared to the domestics. Automotive News says the ten-dollar gap between those foreign camakers and the domestics turns out to about an extra $250 per car in labor, which adds up quickly when you're pumping out many millions of cars. That $250-per-car number is one that, come negotiating time, the Detroit 3 will want to reduce, as the UAW is trying to raise both Tier 1 and Tier 2 wages. Another wrinkle is that the domestic carmakers are considering the wide adoption of a third wage level lower than Tier 2. Some workers who do minor tasks like assembling parts trays kits and battery packs already make less than Tier 2, but the UAW will be quite wary about cementing yet another wage scale at the bottom of the system while it's trying to fight a bigger battle at the top. News Source: Automotive News - sub. req., BloombergImage Credit: AP Photo/Erik Schelzig Earnings/Financials UAW/Unions BMW Chevrolet Fiat Ford GM Honda Hyundai Kia Mercedes-Benz Nissan Toyota Volkswagen labor wages collective bargaining labor costs

GM extends production at Detroit factory until early 2020

General Motors Co said on Friday it had extended the production at its Detroit Hamtramck plant until January 2020, against an earlier plan to discontinue production in June this year. The No.1 U.S. automaker is revamping its operations, which include plant closures and thousands of job cuts, as it looks to boost profitability in the wake of declining U.S. auto sales. The Hamtramck plant will continue to produce the Chevrolet Impala and Cadillac CT6 sedans until early next year, the company said. "We are balancing production timing while continuing the availability of Cadillac advanced technology features currently included in the CT6-V — the Blackwing Twin-Turbo V-8 (engine) and Super Cruise (driver assistance system)," GM said. The plant has already discontinued production of the Buick LaCrosse sedan and Chevrolet Volt electric hybrid car. Detroit-based union United Auto Workers' President Gary Jones said GM's decision to continue production at the plant was a relief for the workers as well as their families. "We commend GM for today's decision and we reiterate the importance of a collective bargaining process in times like these," Jones said. Reporting by Ankit Ajmera. Related Video: