1971 Chevrolet C20/k20 Cheyenne on 2040-cars

Auto blog

GM is the latest automaker accused of diesel emissions cheating

Volkswagen and Ram need to make room on the diesel-emissions bench for General Motors. America's largest automaker was accused in a lawsuit on Thursday of rigging hundreds of thousands of diesel trucks with at least three so-called defeat devices to ensure that the trucks would meet federal and state emission standards, even if they generated more pollution in real-world driving. According to the complaint, on-road emissions testing conducted for the plaintiffs found that Duramax-equipped trucks produced NOx pollutants, comprised of nitrogen and oxygen atoms, two to five times higher than legally permitted, and "many times" higher than their gasoline counterparts. The proposed class-action lawsuit was filed in federal court in Detroit on behalf of people who own or lease more than 705,000 Chevrolet Silverado and GMC Sierra pickup trucks fitted with "Duramax" engines from 2011 to 2016 model years. The lawsuit seeks remedies including possible refunds or restitution for lost vehicle value, plus punitive damages. It adds to legal problems for Detroit-based GM, which has already paid about $2.5 billion in penalties and settlements over faulty ignition switches linked to 124 deaths. GM joins at least five automakers whose diesel emissions have been scrutinized by regulators or consumers. They include VW, which has admitted to cheating; Mercedes-Benz parent Daimler; Fiat Chrysler Automobiles, Peugeot and Renault. GM spokesman Dan Flores called the claims "baseless," and said the trucks comply with US Environmental Protection Agency emissions standards and California's own tough standards. Shares of GM were down 69 cents, or 2.1 percent, at $32.50 in afternoon trading, after earlier falling to $31.93. The GM lawsuit was filed by several law firms, including Hagens Berman Sobol Shapiro, which helped reach multibillion-dollar settlements with VW on behalf of drivers and dealers. The case is Fenner et al v General Motors LLC et al, US District Court, Eastern District of Michigan, No. 17-11661. The named plaintiffs are Andrei Fenner of Mountain View, California and Joshua Herman of Sulphur, Louisiana. They said they would not have bought their respective 2011 Sierra and 2016 Silverado trucks, or would have paid less for them, had they known about the alleged rigging. Joseph Spak, an RBC Capital Markets analyst, in a research report said "negative publicity" from the lawsuit could drive buyers to trucks from Ford or even Fiat Chrysler's Ram.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

GM's redesigned full-size 2021 SUVs face delay over coronavirus

As General Motors works to conserve cash for the coronavirus pandemic, the automaker reportedly told suppliers that it is postponing development of several future vehicles. The situation may cause GM to delay the launch of the 2021 Cadillac Escalade, GMC Yukon, Chevrolet Tahoe and Chevrolet Suburban SUVs, which had been planned to roll out in April. The original launch plan for the redesigned full-size SUVs, which are some of the most profitable vehicles produced by GM, had called for production of the current models to end at its plant in Arlington, Texas, this week. After a retooling process, the redesigned SUVs were slated to begin production late in the month of April. In an email to suppliers viewed by Reuters and confirmed as authentic by GM, the automaker also said it was suspending development work on six future vehicle programs, including updates of the Chevrolet Equinox, GMC Terrain, Cadillac XT4, Bolt EV, Chevrolet Silverado and GMC Sierra. GM said preproduction work on those programs would be pushed back to calendar year 2021, with most of the updated vehicles scheduled to be launched as 2022 models. According to the Detroit News, work has also been paused on the Chevy Camaro and a future version of the Corvette that has yet to be unveiled and wasn't planned for production during the 2020 calendar year. Last week, the automaker told employees and suppliers it was delaying work on some future vehicles while pushing ahead with near-term models such as its redesigned full-size SUVs and the GMC Hummer EV, Cadillac Lyriq, Chevrolet Bolt EUV and Cruise Origin, as well as its new Ultium battery system. A GM spokesman who spoke with Reuters reiterated on Monday what the automaker had said last week — that the situation with its U.S. plants was "fluid" and that the automaker would "continue to evaluate" whether and when to reopen those plants on a week-by-week basis, with "employee safety" guiding that decision. GM said previously that it was closing most of its U.S. plants indefinitely. In its Monday email, GM asked suppliers to stop work on all pre-production tooling and pre-production parts manufacturing, but also not to dispose of any tooling or materials. GM told Reuters it had solicited volunteers from its workforce to finish the build-out of the current SUVs on a single shift in Arlington.