1978 Chevrolet Custom Deluxe Short Bed 4x4, V-8 4-speed Manual Westcoast P/u on 2040-cars

Auto blog

Junkyard Gem: 2005 Chevrolet Aveo LS Sedan

The story of Daewoo in North America took some interesting plot turns over the decades. First we had the 1988-1993 Pontiac LeMans, a rebadged Daewoo LeMans. A bit later, Daewoo began selling cars under its own nameplate here, with the Lanos, Nubira, and Leganza available for the 1999-2002 model years. Then Daewoo fled the continent and left warranty service of those cars in the hands of Manny, Moe, and Jack. With GM taking over Daewoo Motors after Daewoo's bankruptcy, we got some Daewoos with Suzuki badges here— the Verona and the Reno— while Chevrolet began selling the South Korean-built Daewoo Kalos as the Aveo for the 2004 model year. This car may not be a gem in the sense that you would want to own one, but it's a gem of automotive history and thus deserves its place in this series (especially because it's one of the rare 5-speed cars sold here). Many (maybe even most) of these cars ended up in the hands of rental-car companies and other fleet users, but we can tell from the three-pedal setup that this car went to a non-fleet buyer. We've had a couple of these cars compete in the 24 Hours of Lemons, where I work as a dignified and respected race official, and they've been amazingly quick on a road course in the hands of good drivers. Power came from this 103-horsepower Opel-designed four displacing 1.6 liters. The Nubira and Lanos got versions of this engine on these shores, too. The LS was the top trim level for the Aveo in 2004, so this car got air conditioning and a halfway decent audio system (by 2004 standards). The seat fabric is industrial-grade stuff, which would have held up well under the steady drip and/or torrents of bodily fluids coating the interiors of rental cars. The 2004 Aveo LS started at $12,045, which comes to about $16,675 in 2020 dollars, so it was a lot of commuter-appliance for the price. The following generation of this car became the Chevrolet Sonic, beginning with the 2012 model year. You can still buy a new Sonic, and the inflation-adjusted price is nearly identical to that of the original AveoÂ… though you might want to move fast if you really want one, because Daewoo stopped selling the Kalos in South Korea not long ago. If you want the rarest member of the Aveo family available in North America, find yourself a hen's-teeth Pontiac G3, the short-lived Pontiac-badged version. Speaking of the G3, here's the way it broke the hearts of gas pumps around the world.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Car and Driver reveals spy shots of mid-engine 2017 Corvette

Some news in the car world is perennial, and some is perennially wrong. Typically news about some upcoming mid-engined Chevy Corvette has fallen into the latter category, with rumors never yet generating a road car. This time could very well be different. Car and Driver has some exclusive photographs of what would appear to be a Corvette test mule with a mid-mounted engine. The car in question might look like a Holden SSV ute that's undergone some indelicate modification, but C/D editor Don Sherman assures that the bones of a C8 'Vette live within that crude bodywork. Sherman points to the closeness of the cabin to the front axle as clue number one of this car's mid-engine attitude, as well as the powertrain-sized space between the back of the seats and the rear axle. The roof and glasshouse are all clearly plucked from the current C7, and the gas tank filler positioned on the B-pillar is another huge clue. The buff book estimates that the mule points to a timeline for sale, even. Testing on this level could mean a mid-engined C8 ready for sale in as few as 20 months, or for the 2017 model year. Click over to Car and Driver to have a close look at this important set of spy photographs, as well as a rendering of what a finished C8 might ultimately look like