2000 Cadillac Deville Dts Stretch Limosine 130inch Stretch on 2040-cars

Auto blog

GM recalls 55,000 trucks, SUVs for separating axles, fuel pump failures

General Motors issued four separate recalls covering eight of its truck and SUV models for issues related to fuel pump and half-shaft failure. In total, the four campaigns include more than 55,000 vehicles spread out over three brands and six model years, but they've sorted themselves neatly into two categories. Let's dive in.  Axle separation Four models are being recalled for potential axle separation: The 2023 Cadillac XT5, 2023 GMC Acadia, 2023 Chevy Blazer and 2023 Chevy Traverse. The number of units affected is incredibly small (10 units each times two recalls, for a total potential population of just 20 cars). In each case, a small number left the factory with half-shaft assemblies that may have been missing the retention rings that keep them in place, possibly allowing the axles to separate or eject from the transmission. In the case of the XT5 and Acadia, it's the right-side axle assembly; Chevy dealers, however, will have to check the left side.  Fuel pump failure Again, we have multiple vehicles being recalled for similar issues, but in this case they're a bit more distinct. The first of these recalls covers the 2021-2022 Chevy Equinox and 2022 GMC Terrain. GM says a supplier-initiated change may have led to fuel pumps shipping with inadequate clearances to allow for the prescribed flow of fuel, meaning the pump could starve the engine. Customers experiencing the issue may see a check engine light and experience engine hesitation. In some cases, the cars may not start at all. Chevy and GMC will replace the units in question with correctly specified pumps.  The second recall covers a fairly specific cross-section of GM's HD truck lines. 2017-2019 Silverado and Sierra HD trucks sold with the diesel engine and a dual-tank configuration may have shipped with a rear fuel pump that is susceptible to fouling by debris, preventing fuel from properly transferring to the front tank, or, in extreme cases, resulting in a collapse of the rear tank. This issue can lead to inaccurate/erratic fuel tank readings, engine hesitation, a check-engine light or failure to start.  In both cases, GM will inspect and replace faulty units free of charge for customers. Expect notifications to be delivered by March.  Related video: Recalls Cadillac Chevrolet GMC Ownership Safety Truck SUV

2013 Cadillac XTS [w/video]

The Cadillac Of Stopgaps
As confusing as most alphanumeric car names have gotten in recent years, at least one constant has been that the letter "X" is generally indicative of a crossover. Then why did General Motors use this letter on its new 2013 Cadillac XTS luxury sedan? Well, for that, we'll have to look to the world of mathematics where "X" stands for an unknown variable or a placeholder. Now we're talking. The XTS is just an interim product sitting at the top of Cadillac's four-door food chain until the brand gets a true flagship in place. That sounds like a lot of resources to spend on what will likely be a one-and-done model, but the automaker needed to get something - anything - to replace the DTS.
So here you have the 2013 XTS. A big luxury sedan that was created to bridge the gap between Cadillac's recent past and its pending future. Going into our week with this XTS knowing that it was a stopgap measure proved to be both a blessing and a curse. On one hand, we know (or hope) that this car will act as a baseline for future high-end Cadillac models, but at the same time, we couldn't help but be mindful of past stopgap models, albeit in more entry-level segments, like the Cimarron and Catera.

Cadillac CT6 beefs up with 400-hp twin-turbo V6

Cadillac's engine lineup is set to get a makeover led by the potent powerplants under the hood of the CT6. Our man Steven Ewing is onsite at an event in Detroit reporting all the details. Here's what we know so far: The CT6's top engine will be a 3.0-liter twin-turbo V6. It's the first twin-turbo with cylinder deactivation, which essentially makes the V6 able to convert to a V4 unit. Power will be 400 horsepower at 5,500 rpm and 400 pound-feet of torque at just 2,500 rpm. No word on what a potential CT6-V would get. The CT6 will also have a naturally aspirated V6 that Cadillac is claiming to be all-new. It's rated at 335 hp at 6,800 rpm and 284 lb-ft at 5,300 rpm. That's an improvement of 14 hp and nine lb-ft compared with today's 3.6-liter V6, and fuel economy increases nine percent. Cadillac says it's the highest output for a naturally aspirated V6 that's SAE-certified and runs on regular fuel. Both of these V6s will have stop/start technology and will be paired to with eight-speed automatic transmissions. The 3.6-liter V6 will also be used in the 2016 CTS and the 2016 ATS. Meanwhile, Ewing reports that Cadillac says the ATS-V is actually more powerful than initially announced, though there are no numbers to flesh that claim out as yet. The brand also plans to offer four- and six-cylinder diesel engines in various vehicles and new V8 options. The CT6 bows at the New York Auto Show. It will use an aluminum-intensive body that reduces weight by 198 pounds compared with a steel setup and continues Cadillac's creased design language used on the CTS and ATS models. The CT6 goes into production late this year in Detroit. Related Video: Cadillac Next-Gen V-6 Engines Led by 3.0L Twin Turbo Segment-leading power, efficiency in world's most advanced six-cylinder DETROIT – Cadillac today announced a new generation of V-6 engines, led by an exclusive Twin Turbo V-6 that will be one of the industry's most advanced six-cylinder gasoline engines. It leverages the latest technology to balance efficiency, performance and refinement in the upcoming, top-of-the-range CT6 luxury performance sedan. The all-new Cadillac 3.0L Twin Turbo is designed to achieve new thresholds of refinement and specific output for the brand's new prestige luxury sedan, which makes its world premiere March 31, at the New York International Auto Show. Production begins late this year at General Motors' Detroit-Hamtramck Assembly Plant.