1999 98 97 Cadillac Deville Concours Dts Dhs Seville Sts Sls Deville Caddy on 2040-cars

Auto blog

Cadillac toned down ATS Coupe design due to customer feedback [w/poll]

Automakers always face a difficult decision when it comes to styling their cars. Design them too blandly and nobody will get excited about them. But style them too aggressively and they'll often end up turning off potential buyers.
Cadillac, for its part, is no stranger to aggressive design, but when it came to the new ATS Coupe, it elected to tone things down a bit. Speaking with The Detroit News in a wide-ranging interview, Cadillac design director Bob Boniface revealed that the original design for its compact coupe was edgier - closer to that of the CTS Coupe - with a wedgier profile, a more steeply raked beltline and a more severe grille. But potential customers surveyed in clinics apparently didn't like it. They found it looked heavy, inefficient and not fun to drive. So Boniface and his team literally went back to the drawing board and "took as much visual mass out of the car as [they] could." The resulting coupe, while handsome, looks far more similar to its four-door companion than did Cadillac's CTS.
What do you think, does the new ATS Coupe look just right, or is it too conservative? Voice your opinion in our quick online poll.

Cadillac SRX production moving to TN, next-gen Equinox going to Mexico

It's a good week for the town of Spring Hill, TN, as General Motors has announced that its factory in the city of 31,000 will receive a $185 million contract to produce engines. On top of that, the next-generation Cadillac SRX crossover will be built at the factory (NA models are presently built in Ramos, Arizpe Mexico), which was once famous for being the home of GM's now-defunct Saturn brand.
The factory is one of GM's six facilities around the globe that will screw together the company's new line of three- and four-cylinder Ecotec engines. Spring Hill currently builds the 2.0-liter, turbocharged Ecotec, as well as the naturally aspirated 2.4 and 2.5-liter variants.
Spring Hill's vehicle assembly lines were idled in 2009, but were reactivated in 2011. The SRX is just one of the products meant to benefit from last year's $350-million investment, and should have a positive impact, creating or retaining around 1,800 positions at the factory.

GM recalls 2022 Cadillac XT5, XT6 and GMC Acadia for suspension issue

General Motors is recalling a relatively small number of 2022 Cadillac and GMC crossovers to address the potential for missing or loose rear suspension hardware that is being blamed on a lapse in quality control at the company's Spring Hill facility. The campaign covers 223 examples of the Cadillac XT5, 159 examples of the Cadillac XT6 and 354 examples of the GMC Acadia. "General Motors has decided that a defect, which relates to motor vehicle safety, exists in certain 2022 model year Cadillac XT5, XT6, and GMC Acadia vehicles," GM said in its defect report. "A fastener in the left-rear suspension toe link in some of these vehicles may not have been fully tightened during suspension assembly. After an assembly process was moved to a new area, error proofing equipment was not initially set up properly, which allowed a window where the operator might miss tightening certain fasteners without the failure being flagged." The issue was discovered by a quality engineer at the Spring Hill facility in March of this year, at which point GM conducted an audit to determine which and how many vehicles may have left the factory with improperly torqued or missing fasteners, narrowing down the recall population to the above 736 vehicles. No incidents associated with the defect have been reported in customer vehicles.  Related video: Recalls Buick Cadillac GM Ownership Safety