2008 Cadillac Cts 3.6l V6 24v Automatic Awd Sedan Onstar Bose Navigation on 2040-cars

Auto blog

2017 Cadillac XT5 cuts weight, adds room over SRX [UPDATE]

UPDATE: This post has been updated with a full set of official photos. Impressions on the interior and exterior have also been added. The attention of Cadillac fans may be focused on the new CT6 sedan, but the most important new vehicle in the New York-based company's quiver might be the all-new XT5. Cadillac officially unveiled the SRX replacement today ahead of its full debut in Los Angeles next week. Short for Crossover Touring 5, the new XT5 drops 278 pounds over the old SRX, while offering an extra 3.2 inches of interior space. The XT5's face balances the best parts of the Escalade and CT6's fascias, with a strong egg-crate grille and prominent LED accent lights. It looks good scaled to a vehicle of this size. The taillights curve up and over the rear haunches, which feed into a strong shoulder line that runs towards the front of the car. It's a solid look, and one we're looking forward to seeing in person. The interior looks very, very nice, with warm leather and wood trimmings. The steering wheel, with its large, central wood accent, looks remarkably good. In fact, it might be one of our favor parts, if only because it's such a bold piece of design. We aren't crazy about the sheer abundance of buttons on the wheel, though. All four spokes are covered, and it just looks kind of cluttered. As is the trend nowadays, the center console features a floating bridge design with plenty of storage space underneath. Our early impression of the leather-wrapped dash is positive, although as is so often the case, we need to get a hands on before rendering a final judgment. There are no major surprises under the hood. Like the current SRX, the XT5 utilizes the same 3.6-liter V6 as the CTS and ATS sedans. Start/stop has been fitted, which should provide a boost in fuel economy although no mileage figures have been published yet. Cadillac will also offer a standard 2.0-liter turbocharged four-cylinder XT5, although for reasons that aren't clear, it's only for the Chinese market. This seems like a misstep in our eyes, considering the XT5 will challenge the likes of the BMW X3, Audi Q5, and Mercedes-Benz GLC – all of which offer four-cylinder turbos. With the V6, the XT5 delivers 310 horsepower and 270 pound-feet of torque. While there's more total horsepower than the Lexus, Audi, or BMW, the 3.6 still faces a torque deficiency versus the turbocharged X3 xDrive35i or supercharged Audi V6. The XT5 has a standard eight-speed automatic transmission.

[UPDATE] Cadillac Blackwing gets ticket to Italy, to go to work in a supercar

UPDATE: It seems MAT's belief it had secured a supply of Cadillac's 4.2-liter Blackwing V8 was premature, and based on a handshake deal before GM sold its Turin engine center to Italy's Punch Group. Shortly after Hagerty ran the story, GM sent a statement to the outlet reading, in part, "We do not have an agreement in place with Manifattura Automobili Torino (MAT) to provide or sell the Blackwing engine. ... Our team is following up with MAT president Paolo Garella to discuss the misunderstanding." MAT also submitted a statement to Hagerty, saying, in part, "We thank GM for the clarification. Although a signed agreement was not finalized between the parties, we were under the impression that our counterpart was committing to making this engine available to MAT at conditions yet to be defined. ... We hope that this misunderstanding will not compromise our relations with GM and possible future collaborations." The original article follows: Some necessary cost-cutting at Cadillac led to switching the new CT4, CT5, and Escalade to older platforms. The revised architecture plan meant Cadillac's newest top-tier products couldn't fit Cadillac's newest top-tier engine, the 4.2-liter twin-turbo DOHC V8 known as Blackwing. That engine would serve limited duty at full power in the now-dead CT6-V, and at reduced output in the CT6 Platinum V8 trim before ending its bright, brief domestic life. But the story isn't over, the rebirth of Blackwing coming from a most surprising locale: Turin, Italy. Before the canceled Geneva Motor Show, Hagerty spoke to Paolo Garella, CEO of Manifattura Automobili Torino; that's the company better known as MAT, makers of the New Stratos and contract engineering house for boutique screamers like the Aspark Owl electric hypercar, Apollo Intensa Emozione, and SCG003C. Garella told the outlet, "We have an agreement with General Motors" for a supply of Blackwings, which would be developed and built at the General Motors Propulsion Engineering Center (PEC) in Turin. Since 2005, the PEC has been used to develop GM's global diesel engines and electronics. MAT's plan is to put the V8 into a new limited-run car MAT is creating from its own design. Then another surprising turn: Belgium-based global auto supplier Punch Group bought the PEC, with plans to work with GM on projects in progress until at least the end of 2021. Nothing changes as far as MAT is concerned, except perhaps a chance for an even closer collaboration with Punch Turin.

Cadillac issues stop-sale on recalled CTS, SRX

General Motors has issued a stop-sale order on the Cadillac CTS and SRX, both of which were recalled late last month. Why the stop-sale after all this time? Well, um, GM apparently doesn't know how to fix them.
The stop-sale covers all used Cadillac CTS sedans, coupes and wagons from model years 2003 to 2013, as well as new 2014 coupes and wagons. The SRX crossover stop-sale, meanwhile, only covers used vehicles from model years 2004 to 2006.
Automotive News reached out to GM spokesperson Alan Adler, who told the news pub that the company's engineers were "looking at one common solution" for the affected vehicles, although "they don't have it yet."