2010 Cadillac Escalade Luxury on 2040-cars

Auto blog

GM recalls full-size truck, SUVs and vans over faulty shifter mechanism

Twelve different General Motors vehicles from the 2013 model year, up to 54,686 units in total, are being recalled over two potential issues with their steering columns. The models in question, all full-size trucks, SUVs or vans, are the: Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Express, Silverado, Suburban, Tahoe, and GMC Savana, Sierra, Yukon and Yukon XL.
The affected vehicles were built with a fractured parking lock cable or "a malformed steering column lock actuator gear in the lock module assembly." As a consequence, they could shift out of park without the brake pedal being applied or with the key removed or in the off position.
A bulletin from the National Highway Traffic Safety Administration indicates that the recall should begin on January 17. GM will notify owners, at which time they can take their vehicles to their dealers for repair free of charge. Have a look at the bulletin below for more information.

2015 Cadillac ATS Coupe prepares to fight BMW 4 Series

Cadillac introduced its new ATS Coupe at the 2014 Detroit Auto Show today, bringing customers an alternative to the growing range of sport luxury coupes typified by the BMW 4 Series, Audi A5 and Mercedes-Benz C-Class Coupe.
The ATS Coupe, as a slightly more premium offering, ditches the wheezy 2.5-liter engine found in the basic ATS Sedan, but retains the four-door's 2.0-liter, turbocharged four-cylinder and 3.6-liter V6. That four-pot turbo benefits from a fettling that has increased torque from 260 pound-feet to 295, although its peak is only available from 3,000 rpm to 4,600 rpm, unlike in the sedan, where peak twist arrives at just 1,700 rpm and sticks around until 5,500 rpm.
Power can be channeled to either the rear or all four wheels by the owner's choice of a Tremec six-speed manual or a six-speed automatic transmission. According to Cadillac, the new Coupe can get to 60 in 5.6 seconds when fitted with the 2.0-liter turbo.

Cadillac adds torque-number badging to most new models starting in 2020

Few phrases describe huge swaths of America better than a phrase spotted on the back of a top-fuel dragster at an NHRA event: "You can never have too much horsepower or ammunition." If Cadillac CEO and wily Canuck Steve Carlisle has his way, the revised phrase would substitute "torque measured in Newton-meters" for "horsepower." Starting with the 2020 model year, America's luxury brand will add torque figure badges to CT and XT models, beginning with the XT6. The badge above kinda almost sorta represents the torque produced by the luxury crossover's 3.6-liter V6. That badge did not appear on the XT6 we photographed at the Detroit Auto Show. In U.S. parlance, twist in the XT6 comes to 271 pound-feet. Translated to Newton-meters, that's 367 Nm. Then round that up to the nearest 50, which Cadillac will do, and one arrives at 400. True, the rounding prevents a future of number jumbles like the 2020 XT6 367 vs. the 2021 XT6 419T. Nevertheless, we don't know why Cadillac is rounding to the nearest 50 instead of the nearest 25, since 50 Nm is about 37 lb-ft and could conceal a decent torque increase between model years. A "T" denotes turbocharging, and we imagine there'll be designations for hybrids and electric cars. We think most modern attempts at engine-based nomenclatures soon get as complicated as ciphers or come unmoored from their original scheme. And based on our experience with The Average Car Buyer, they don't care. A bigger number, no matter what that number represents, means more, which is the important thing. Because America, right? Maybe not. Carlisle said, "We're not talking about displacements any more," and the new badging will give consumers "a clear understanding of the power differences across the lineup." The brand believes torque provides a better comparison between ICE, hybrid, and EV powertrains and "the balance between fuel economy and performance." As for the immigrant unit of measurement, Carlisle told CNET, " It's metric, it's universal, it's global, we have to think about all the markets that we're doing business in." Oh, and, "Engineers certainly prefer Newton-meters." The new nomenclature will not be applied to V-series models or the Escalade, because the CEO holds that "special cars get special names." We should probably take a moment to reassure the CT and XT models that Steve Carlisle thinks you're all special, too. Just a different kind of special.