2007 Cadillac Escalade Base Sport Utility 4-door 6.2l on 2040-cars

Auto blog

GM recalls 55,000 trucks, SUVs for separating axles, fuel pump failures

General Motors issued four separate recalls covering eight of its truck and SUV models for issues related to fuel pump and half-shaft failure. In total, the four campaigns include more than 55,000 vehicles spread out over three brands and six model years, but they've sorted themselves neatly into two categories. Let's dive in.  Axle separation Four models are being recalled for potential axle separation: The 2023 Cadillac XT5, 2023 GMC Acadia, 2023 Chevy Blazer and 2023 Chevy Traverse. The number of units affected is incredibly small (10 units each times two recalls, for a total potential population of just 20 cars). In each case, a small number left the factory with half-shaft assemblies that may have been missing the retention rings that keep them in place, possibly allowing the axles to separate or eject from the transmission. In the case of the XT5 and Acadia, it's the right-side axle assembly; Chevy dealers, however, will have to check the left side.  Fuel pump failure Again, we have multiple vehicles being recalled for similar issues, but in this case they're a bit more distinct. The first of these recalls covers the 2021-2022 Chevy Equinox and 2022 GMC Terrain. GM says a supplier-initiated change may have led to fuel pumps shipping with inadequate clearances to allow for the prescribed flow of fuel, meaning the pump could starve the engine. Customers experiencing the issue may see a check engine light and experience engine hesitation. In some cases, the cars may not start at all. Chevy and GMC will replace the units in question with correctly specified pumps.  The second recall covers a fairly specific cross-section of GM's HD truck lines. 2017-2019 Silverado and Sierra HD trucks sold with the diesel engine and a dual-tank configuration may have shipped with a rear fuel pump that is susceptible to fouling by debris, preventing fuel from properly transferring to the front tank, or, in extreme cases, resulting in a collapse of the rear tank. This issue can lead to inaccurate/erratic fuel tank readings, engine hesitation, a check-engine light or failure to start.  In both cases, GM will inspect and replace faulty units free of charge for customers. Expect notifications to be delivered by March.  Related video: Recalls Cadillac Chevrolet GMC Ownership Safety Truck SUV

Expect the Cadillac XT3 small crossover in late 2018

Cadillac's sedan-heavy lineup can't complete in this crossover-crazy market, it seems. The Detroit News spoke to Cadillac boss Johan de Nysschen and found out some more details about the brand's plan to alter its lineup to cater more to current consumer tastes. It's no surprise that these plans would include a small crossover, because de Nysschen has been talking about a vehicle smaller than the XT5 like this since at least 2015. The report also pins the Fairfax Assembly Plant, where GM builds the Buick LaCrosse and the Chevrolet Malibu, as the site for what could be called the XT3's production. That's not an immediately obvious choice, since the LaCrosse and Malibu are based on the latest evolution of the Epsilon platform, known as E2XX. And the XT5 is based on a crossover version of that same platform (known as C2XX), while XT3 is expected to be smaller than the XT5. So perhaps there's a different assembly line going into Fairfax, or the C2XX platform can be significantly shortened. We assume that the XT3 would be built on a smaller platform, perhaps the Gamma II that underpins the Chevrolet Trax and Buick Encore – which are built in either South Korea or Mexico, depending on which market they are to be exported to. The Encore is selling very well for Buick, with sales figures increasing through late last year. Another possibility is the D2XX platform that underpins the Chinese-built Buick Envision and the GMC Terrain and Chevrolet Equinox, perhaps with assembly happening at the CAMI plant in Ontario. At this early stage, without confirmation of GM as to what platform the XT3 will use or where it will really be built, it's too early to say what the Fairfax rumor means. This isn't the first time we've heard about a small Cadillac crossover. Back in 2015, de Nysschen told us to expect it sometime in 2018. But later that year, speaking to Reuters, he posited that it'd be closer to 2019. The Detroit News says de Nysschen told them it'll launch in the second half of 2018, splitting the difference between what we'd heard previously. Remember, Cadillac's only two vehicles in the segment are the XT5 and Escalade. We know that the brand is almost certainly scrambling to fill the holes in that side of the lineup. We think a three-row crossover will slot between the two, probably called the XT7.

SRX-replacing Cadillac XT5 spied for the very first time

Cadillac has got big plans in place to revitalize its lineup, with new sedans, coupes and crossovers. And it all starts with this, the replacement for the SRX.
Expected to be called XT5 in line with the brand's new naming scheme, the crossover will be based on a scalable new platform called C1XX - or Chi, for short. In its shorter form, Chi is anticipated to underpin the XT5 as well as a new Chevy crossover and the next-gen GMC Acadia. In long-wheelbase form, the platform is slated to give us a larger Cadillac crossover as well as a new Buick Enclave and Chevy Traverse.
Power in the XT5 will be provided by a choice of turbo four or atmospheric six, potentially to be transmitted through GM's new nine-speed automatic.