1978 Cadillac Eldorado Low Miles Super Clean on 2040-cars

Auto blog

GM faces possible class action lawsuit over 8-speed transmission

General Motors has been hit with a class-action lawsuit from owners who allege the eight-speed automatic transmission found in several rear-wheel-drive Chevrolet, Cadillac and GMC models between the 2015 and 2019 model years has a defect that causes the vehicles to hesitate and jerk when accelerating or slowing down. The lawsuit was posted to ClassAction.org and spotted by GM Authority. Problems with GM's Hydra-Matic 8L90 and 8L45 transmissions have been well-documented on Internet forums and via complaints filed with the National Highway Traffic Safety Administration, with many reporting damage to their vehicles. The lawsuit was first filed in December in U.S. District Court for the Southern District of Florida but appears to have been transferred recently to New York. Autoblog sought comment from Theodore Leopold, the lead attorney for the plaintiffs. "These transmissions have a common defect," the complaint reads. "Drivers attempting to accelerate or decelerate their cars feel a hesitation, followed by a significant shake, shudder, jerk, clunk, or 'hard shift' when the vehicle's automatic transmission changes gears." The problem also occurs when the vehicles accelerate in a single gear, without shifting, the plaintiffs allege. "Drivers have reported that the shift is sometimes so violent, they feel as though they have been hit by another vehicle." The problem is believed to center on the transmission, torque converter or both. The complaint says it causes undue friction, causing hydraulic systems and gears to function improperly and sometimes leaves metal shavings throughout the transmission, leading to costly repairs and replacement of parts or the entire transmission. It says GM has known about the problems since shortly after it introduced the transmissions, and has issued 13 technical service bulletins, none of which have resolved the problem. GM declined to comment on the lawsuit. The plaintiffs say GM should have warned consumers about the issues and covered repairs under each vehicle's three-year/36,000-mile bumper-to-bumper warranty. They're seeking statewide classes in at least six states: California, Florida, Illinois, New York, Oklahoma and Texas.

2020 Cadillac CT5 loses the fake scoop

Well folks, the inevitable has happened. The 2020 Cadillac CT5 luxury sports sedan prototype has shed its hood scoop. Yes, we're as disappointed as you are that instead of being outrageous and brash, Cadillac is still going to try to be classy, understated and luxurious when it comes to its mainline models. And yes, we're being sarcastic here ... but there's a part of us that would kind of like to see the scoop survive. Anyway, the good news is that the scoop is only one of a few bits of fake bodywork and camouflage that the CT5 has shed. As such, we get our best look yet at the new Cadillac sedan, and it looks pretty good. The grille is very wide and not nearly as tall as the prominent prows of current Cadillacs. It actually doesn't even look as tall as the grille of the Escala concept that inspired the CT5's design. The profile of the CT5 isn't too radically different from existing Caddies, with a long hood and a short trunk. It is still a conventional sedan, though, and not a sedan-like hatchback like the Kia Stinger and Audi A5 Sportback and A7. This is evident by the open trunk lid our spy photographer caught. The taillights also continue to be slim and vertical, though we can't quite tell if they will have a horizontal elements at the bottom like on the XTS and XT4. The car also has very bold and thick angular exhaust tips. We expect the CT5 will go into production in 2019 as a 2020 model, and it will likely take the place of both the CTS and ATS, but not be much smaller than the CTS. It will likely use versions of existing Cadillac engines including the 2.0-liter turbo four-cylinder, naturally aspirated 3.6-liter V6, and twin-turbo 3.0-liter V6. We wouldn't rule out the 4.2-liter twin-turbo V8 for a potential CT5-V in the future. Related Video:

Super Cruise’s failsafes

Even though Super Cruise is not a fully autonomous system, it incorporates redundancies like those used in aircraft to ensure failsafe operation. Before taking off on a 700-mile, 11-hour test drive of the system — and putting my life in its hands without my hands on the wheel — I sat down with Daryl Wilson, lead development engineer for Super Cruise, to get a deep dive into the system and its critical safety backups. Autoblog: First, what makes Super Cruise different from similar systems? Wilson: The key differentiator for Super Cruise is hand-free driving. It's an industry first in that respect. Our competitors require the driver at minimum to place their hands on the wheel with some frequency to ensure that the car knows that the driver is there. We don't. Two key technologies allow us to do this. One is our Driver Attention System, which is our methodology for making sure the driver is engaged with the vehicle and engaged with the road. This is a driver assist system, not a fully autonomous system. So it requires driver engagement. We use an infrared camera that constantly monitors the driver's face to determine the direction they're looking. We're looking for the driver to be what we call on-road — not on the center stack, not to left or right or down. That's all done by the tracking of the face. We also track that the eyes are open. It's infrared because at night you need to illuminate the face and you can't be shining a light into the driver's face. Then we have our lidar mapping that provides a foundation for control and redundancy to ensure safe performance. Autoblog: How does the mapping act as a redundant feature? Wilson: This system is only for use on divided, controlled access highways. What I mean by a divided highway is something more than a painted line between you and oncoming traffic. Whether that's a grassy area in between the lanes or a concrete barrier, anything that separates you from oncoming traffic. That's the divided highway part. The controlled access part is entrance ramps and exit ramps. Not with roads that cross at grade, with traffic crossing at the same level. To do that we geofenced these roads to ensure that operation is only allowed in these conditions. We don't just recommend you use it there; we ensure that you only use it there.