2011 Cadillac Cts Premium Coupe 2-door 3.6l on 2040-cars

Auto blog

Cadillac recalls ELR coupe over stability control problems

Cadillac is recalling about 656 2014 ELR models made between September 26, 2013 and February 14, 2014, because of a fault with the electronic stability control system. On cars without adaptive cruise control, it's possible that diagnostics could prevent the system from telling the driver if ESC is on or off.
Cadillac has a software fix ready and repairs begin on April 17. Alan Adler, General Motors' recall and legal spokesperson, tells Autoblog that only about 55 of the affected cars are in the hands of owners. The rest are either on dealer lots or still at the factory. There have been no reported injuries or crashes caused by the fault.
The correction for the stability control system involves a software recalibration of the electronic brake control module that takes around 20 minutes to perform. While they use the same platform, the Chevrolet Volt isn't involved in this recall because it "uses a different a brake control module," said Adler.

Cadillac adds torque-number badging to most new models starting in 2020

Few phrases describe huge swaths of America better than a phrase spotted on the back of a top-fuel dragster at an NHRA event: "You can never have too much horsepower or ammunition." If Cadillac CEO and wily Canuck Steve Carlisle has his way, the revised phrase would substitute "torque measured in Newton-meters" for "horsepower." Starting with the 2020 model year, America's luxury brand will add torque figure badges to CT and XT models, beginning with the XT6. The badge above kinda almost sorta represents the torque produced by the luxury crossover's 3.6-liter V6. That badge did not appear on the XT6 we photographed at the Detroit Auto Show. In U.S. parlance, twist in the XT6 comes to 271 pound-feet. Translated to Newton-meters, that's 367 Nm. Then round that up to the nearest 50, which Cadillac will do, and one arrives at 400. True, the rounding prevents a future of number jumbles like the 2020 XT6 367 vs. the 2021 XT6 419T. Nevertheless, we don't know why Cadillac is rounding to the nearest 50 instead of the nearest 25, since 50 Nm is about 37 lb-ft and could conceal a decent torque increase between model years. A "T" denotes turbocharging, and we imagine there'll be designations for hybrids and electric cars. We think most modern attempts at engine-based nomenclatures soon get as complicated as ciphers or come unmoored from their original scheme. And based on our experience with The Average Car Buyer, they don't care. A bigger number, no matter what that number represents, means more, which is the important thing. Because America, right? Maybe not. Carlisle said, "We're not talking about displacements any more," and the new badging will give consumers "a clear understanding of the power differences across the lineup." The brand believes torque provides a better comparison between ICE, hybrid, and EV powertrains and "the balance between fuel economy and performance." As for the immigrant unit of measurement, Carlisle told CNET, " It's metric, it's universal, it's global, we have to think about all the markets that we're doing business in." Oh, and, "Engineers certainly prefer Newton-meters." The new nomenclature will not be applied to V-series models or the Escalade, because the CEO holds that "special cars get special names." We should probably take a moment to reassure the CT and XT models that Steve Carlisle thinks you're all special, too. Just a different kind of special.

Cadillac president Johan de Nysschen expands on brand's future

Cadillac president Johan de Nysschen chatted with journalists at a recent roundtable, expounding on everything from domestic racing to Chinese manufacturing. The brand's been doing a slow burn on rolling out new products and increasing sales, but admittedly, there was a lot of work to do. After closing out last year 0.8 percent down in the U.S., the domestic luxury brand is more than 5 percent up so far this year, thanks to healthy double-digit bumps for the ATS and Escalade, and increased fleet sales. Globally, the brand's doing 21 percent better. The XT5 still outsells everything, though. Asked about slow sedan sales, de Nysschen cited a few reasons, one of them "energy prices," which are low enough to fuel the crossover craze. You can also read that as another admission that Cadillac doesn't have enough crossovers to please the crowds, a fact the XT4 will soon address. Yet de Nysschen also pegged the sedan malaise on "younger consumers who really are less tuned into dynamics and handling and all of those things that used to excite enthusiasts. It's more about the way cars complement and enable their lifestyle now." He topped that with a take on U.S. roads, saying, "I also have to say it may also be influenced a little bit by the decay of America's infrastructure. When roads no longer support high-performance sport sedans and ultra-low-profile rubber, people are going to respond to it." Those latter takes seem wide of the mark. Yes, BMW is the established leader, but the Munich carmaker sold 8,806 3 Series' so far this year in all variants, compared to 2,543 ATS coupes and sedans. Mercedes-Benz has sold 8,366 C-Class models so far in all variants. As for infrastructure, yes, it's a mess, but AMG sales rocketed up nearly 50 percent in the U.S. last year, nearly 10 percent of overall Mercedes sales, and the Three-Pointed Star expects that to rise again this year. People are buying sedans and performance models. They simply aren't buying enough of them with Cadillac badges. Cadillac has no plans to go racing in Europe since the brand doesn't have the kind of presence there to justify the investment. De Nysschen said they'll stick with the Daytona Prototype International formula in the U.S. domestic scene, and continue with the tech transfer from race to road.