Carninja 2011 Bmw E92 M3 Coupe Show Car A/w, 6 Speed Manual on 2040-cars

Auto blog

2016 BMW 7 Series slims down, techs up

BMW is finally pulling the wraps off its sixth-generation 7 Series. The flagship boasts a ton of improvements for 2016, including a smattering of onboard tech and weight reduction of 190 pounds. The 7 Series uses a new internal structure called Carbon Core. Derived from the i sub-brand, Carbon Core uses a mix of carbon-fiber-reinforced plastic and ultra-high-tensile steel for the 7's major structural components. It's largely responsible for the 190-pound weight reduction, along with the aluminum doors and trunk lid. The weight savings has allowed BMW to maintain a fifty-fifty weight distribution. That new structure underpins the largest sedan BMW has ever produced. At 206.6 inches in total, the long-wheelbase-only 7 Series is over an inch longer than its predecessor. Its 124.6-inch wheelbase and 74.9-inch width, though, remain unchanged. Even with such a modest increase in size, BMW is claiming best-in-class rear legroom, at 44.4 inches – a tenth of an inch more than the current 7. Unlike the old car, though, this new 7 Series gets with the times in terms of chauffeur equipment. The front passenger seat can be slid forward and folded, allowing a lucky rear passenger to take advantage of the new pop-out footrest and optional 42.5-degree seat incline, available as part of the Rear Executive Lounge Seating Package. iDrive now adds a number of 3D sensors that respond to pre-programed hand motions. The 7 Series will debut here in the United States with two engines, both of which should be familiar to BMW consumers. There's a 320-horsepower, 3.0-liter, turbocharged six-cylinder in the nose of the 740i, and a 4.4-liter, twin-turbocharged V8 with 445 hp on tap in the 750i xDrive. 60 miles per hour arrives in a relaxed 5.4 seconds for the 740i and 4.3 seconds in the V8 model. Once again, ZF provides the eight-speed automatic transmission used with both engines. Joining the 740i and 750i is the new 740e xDrive. The plug-in-hybrid sedan is motivated by a 2.0-liter, turbocharged four-cylinder and an electric motor, and is capable of 23 miles per charge and speeds of up to 75 miles per hour in pure electric mode. Tthere's no shortage of tech on the latest 7 Series. While we're familiar with some items, like active grille shutters and BMW's Air Breather system, it's items like the gesture-control-equipped iDrive 5.0 that pique our interest. Alongside the new and standard touchscreen, iDrive now adds a number of 3D sensors that respond to pre-programed hand motions.

2013 Dinan S3 BMW 550i

Steve Dinan has been enhancing BMW models since 1979. But don't throw his company into the ring with the dozen or so other tuners who tweak, tinker and piggyback upgrades on the famed German marque. Dinan is a tuner, but it's also an engineering firm that writes its own software, builds its own parts and then backs everything it does with a factory-grade warranty. That sort of fastidiousness comes at a price, but most of its customers - including the powerhouse of BMW Motorsport - rely on Dinan to help them come out on top.
In stock form, BMW's 550i is a formidable four-door with a twin-turbocharged 4.4-liter V8 rated at 400 horsepower and 450 pound-feet of torque. While those figures allow it to run with quick company (0-60 in 5.0 seconds, according to the automaker), Dinan puts the sedan's kettle on full boil with its S3 package. Starting with the engine, the performance engineering firm bolts on larger turbochargers, air-to-water intercoolers, a trick strut tower brace cold air intake, a quad-pipe free flow exhaust and its own engine management software. Pump in some premium fuel, and the result is 542 horsepower and 587 pound-feet of torque. Power is sent through the stock eight-speed automatic to a limited slip rear differential (Dinan will upgrade xDrive all-wheel drive models, too).
The Dinan S3 also features and extensive suspension upgrade that includes new front camber arms and low compliance rear control arms (engineered to reduce understeer and improve turn-in). The stock dampers are retained, but new bump stops are installed along with new springs. Overall, the car rides about a half-inch lower than stock to improve roll rate. To reduce unsprung weight, forged 20-inch HRE Performance wheels are fitted at all four corners (wearing Michelin Pilot Super Sport tires - 275/35ZR20 up front and 295/35ZR20 in the rear). Lastly, the company remaps the factory Electronic Damper Control (EDC) software with its own Dinan Shockware to work in conjunction with the new enhancements.

Germany says nein to EU ban on new fossil-fuel cars from 2035

BERLIN (Reuters) - Germany's government will not agree to European Union plans to effectively ban the sale of new cars with combustion engines from 2035, Finance Minister Christian Lindner said on Tuesday. In its bid to cut planet-warming emissions by 55% by 2030 from 1990 levels, the European Commission has proposed a 100% reduction in CO2 emissions from new cars by 2035. That means it would be impossible to sell combustion engine cars from then. European Parliament lawmakers backed the proposals this month, before negotiations with EU countries on the final law take place. Speaking at an event hosted by Germany's BDI industry association, Lindner said there would continue to be niches for combustion engines so a ban was wrong and said the government would not agree to this European legislation. Lindner, a member of the pro-business Free Democrats, which shares power with the Social Democrats and Greens, said Germany would still be a leading market for electric vehicles. (Reporting by Christian Kraemer; Writing by Madeline Chambers; Editing by Miranda Murray and Edmund Blair) Green Government/Legal Green Audi BMW Mercedes-Benz Volkswagen Opel SEAT Skoda